110,610 research outputs found

    Sharp bounds on enstrophy growth in the viscous Burgers equation

    Full text link
    We use the Cole--Hopf transformation and the Laplace method for the heat equation to justify the numerical results on enstrophy growth in the viscous Burgers equation on the unit circle. We show that the maximum enstrophy achieved in the time evolution is scaled as E3/2\mathcal{E}^{3/2}, where E\mathcal{E} is the large initial enstrophy, whereas the time needed for reaching the maximal enstrophy is scaled as E1/2\mathcal{E}^{-1/2}. These bounds are sharp for sufficiently smooth initial conditions.Comment: 12 page

    Transonic aerodynamic and aeroelastic characteristics of a variable sweep wing

    Get PDF
    The flow over the B-1 wing is studied computationally, including the aeroelastic response of the wing. Computed results are compared with results from wind tunnel and flight tests for both low-sweep and high-sweep cases, at 25.0 deg. and 67.5 deg., respectively, for selected transonic Mach numbers. The aerodynamic and aeroelastic computations are made by using the transonic unsteady code ATRAN3S. Steady aerodynamic computations compare well with wind tunnel results for the 25.0 deg. sweep case and also for small angles of attack at the 67.5 deg. sweep case. The aeroelastic response results show that the wing is stable at the low sweep angle for the calculation at the Mach number at which there is a shock wave. In the higher sweep case, for the higher angle of attack at which oscillations were observed in the flight and wind tunnel tests, the calculations do not show any shock waves. Their absence lends support to the hypothesis that the observed oscillations are due to the presence of leading edge separation vortices and are not due to shock wave motion as was previously proposed

    Route planning in a four-dimensional environment

    Get PDF
    Robots must be able to function in the real world. The real world involves processes and agents that move independently of the actions of the robot, sometimes in an unpredictable manner. A real-time integrated route planning and spatial representation system for planning routes through dynamic domains is presented. The system will find the safest most efficient route through space-time as described by a set of user defined evaluation functions. Because the route planning algorthims is highly parallel and can run on an SIMD machine in O(p) time (p is the length of a path), the system will find real-time paths through unpredictable domains when used in an incremental mode. Spatial representation, an SIMD algorithm for route planning in a dynamic domain, and results from an implementation on a traditional computer architecture are discussed

    Infrared Lighting Does Not Suppress Catch of Codling Moth (Lepidoptera: Tortricidae) in Pheromone-Baited Monitoring Traps

    Get PDF
    Video cameras are increasingly being used to record insect behaviors in the field over prolonged intervals. A nagging question about crepuscular and nocturnal recordings is whether or not infrared light emitted by such cameras to illuminate the scene influences the behaviors of the subjects or study outcomes. Here we quantified catches of male codling moths, Cydia pomonella (L.), responding to sex pheromone-baited monitoring traps illuminated with infrared, red, white, or no light. No statistically significant differences were found between any of these treatments

    Moving-base visual simulation study of decoupled controls during approach and landing of a STOL transport aircraft

    Get PDF
    The simulation employed all six rigid-body degrees of freedom and incorporated aerodynamic characteristics based on wind-tunnel data. The flight instrumentation included a localizer and a flight director which was used to capture and to maintain a two-segment glide slope. A closed-circuit television display of a STOLport provided visual cues during simulations of the approach and landing. The decoupled longitudinal controls used constant prefilter and feedback gains to provide steady-state decoupling of flight-path angle, pitch angle, and forward velocity. The pilots were enthusiastic about the decoupled longitudinal controls and believed that the simulator motion was an aid in evaluating the decoupled controls, although a minimum turbulence level with root-mean-square gust intensity of 0.3 m/sec (1 ft/sec) was required to mask undesirable characteristics of the moving-base simulator

    Pressure distributions and shock shapes for 12.84 deg/7 deg on-axis and bent-nose biconics in air at Mach 6

    Get PDF
    Pressure distributions and shock shapes on a spherically blunted, 12.84 deg /7 deg on axis biconic and a spherically blunted, 12.84 deg/7 deg bent nose biconic at Mach 6 in air were measured. The angle of attack, referenced to the axis of aft cone, was varied from 0 deg to 25 deg in nominal 5 deg increments. Two values of free stream Reynolds number based on model length were tested. Predictions from simple, theories and from a supersonic, three dimensional, external invsicid code (STEIN) are compared with measured values. Predicted STEIN shock shapes and windward pressures are in agreement with measured values for both biconics over the present range of angle of attack

    Effective Operators for Double-Beta Decay

    Get PDF
    We use a solvable model to examine double-beta decay, focusing on the neutrinoless mode. After examining the ways in which the neutrino propagator affects the corresponding matrix element, we address the problem of finite model-space size in shell-model calculations by projecting our exact wave functions onto a smaller subspace. We then test both traditional and more recent prescriptions for constructing effective operators in small model spaces, concluding that the usual treatment of double-beta-decay operators in realistic calculations is unable to fully account for the neglected parts of the model space. We also test the quality of the Quasiparticle Random Phase Approximation and examine a recent proposal within that framework to use two-neutrino decay to fix parameters in the Hamiltonian. The procedure eliminates the dependence of neutrinoless decay on some unfixed parameters and reduces the dependence on model-space size, though it doesn't eliminate the latter completely.Comment: 10 pages, 8 figure

    Charge storage mechanism in nanoporous carbons and its consequence for electrical double layer capacitors

    Get PDF
    Electrochemical capacitors, also known as supercapacitors, are energy storage devices that fill the gap between batteries and dielectric capacitors. Thanks to their unique features, they have a key role to play in energy storage and harvesting, acting as a complement to or even a replacement of batteries which has already been achieved in various applications. One of the challenges in the supercapacitor area is to increase their energy density. Some recent discoveries regarding ion adsorption in microporous carbon exhibiting pores in the nanometre range can help in designing the next generation of high-energy-density supercapacitors

    Families of classical subgroup separable superintegrable systems

    Full text link
    We describe a method for determining a complete set of integrals for a classical Hamiltonian that separates in orthogonal subgroup coordinates. As examples, we use it to determine complete sets of integrals, polynomial in the momenta, for some families of generalized oscillator and Kepler-Coulomb systems, hence demonstrating their superintegrability. The latter generalizes recent results of Verrier and Evans, and Rodriguez, Tempesta and Winternitz. Another example is given of a superintegrable system on a non-conformally flat space.Comment: 9 page

    Second order superintegrable systems in conformally flat spaces. IV. The classical 3D Stäckel transform and 3D classification theory

    Get PDF
    This article is one of a series that lays the groundwork for a structure and classification theory of second order superintegrable systems, both classical and quantum, in conformally flat spaces. In the first part of the article we study the Stäckel transform (or coupling constant metamorphosis) as an invertible mapping between classical superintegrable systems on different three-dimensional spaces. We show first that all superintegrable systems with nondegenerate potentials are multiseparable and then that each such system on any conformally flat space is Stäckel equivalent to a system on a constant curvature space. In the second part of the article we classify all the superintegrable systems that admit separation in generic coordinates. We find that there are eight families of these systems
    corecore