76 research outputs found
Enhanced coupling to microsphere resonances with optical fibers
Cataloged from PDF version of article.Morphology-dependent resonances (MDR's) of polystyrene microspheres were excited by an optical fiber coupler. For optical elimination of the air-cladding interface at the optical fiber coupler surface, the microsphere was immersed in an index-matching oil. MDR's were observed, even though the relative refractive index between the microsphere and the oil was only 1.09. The observed MDR spectra are in good agreement with the generalized Lorenz-Mie theory and the localization principle. The scattering efficiency into each MDR is estimated as a function of the impact parameter by means of generalized Lorenz-Mie theory. (C) 1997 Optical Society of America
Morphology Dependent Resonances of a microsphere/optical fiber system
Cataloged from PDF version of article.Morphology-dependent resonances of microspheres sitting upon an index-matched single-mode fiber half-coupler are excited by a tunable 753-nm distributed-feedback laser. Resonance peaks in the scattering spectra and associated dips in the transmission spectra for the TE and TM modes are observed. We present a new model that describes this interaction in terms of the fiber-sphere coupling coefficient and the microsphere's intrinsic quality factor Q0. This model enables us to obtain expressions for the finesse and the Q factor of the composite particle-fiber system, the resonance width, and the depth of the dips measured in the transmission spectra. Our model shows that index matching improves the coupling efficiency by more than a factor of 2 compared with that of a non-index-matched system. © 1996 Optical Society of America
A note on multiple flow equilibria
A set of ordinary differential equations describing a mechanical system subject to forcing and dissipation is considered. A topological argument is employed to show that if all time-dependent solutions of the governing equations are bounded, the equations admit N steady solutions, where N is a positive odd integer and where at least ( N −1)/2 of the steady solutions are unstable. The results are discussed in the context of atmospheric flows, and it is shown that truncated forms of the quasigeostrophic equations of dynamic meteorology and of Budyko-Sellers climate models satisfy the hypotheses of the theorem.Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/43139/1/24_2004_Article_BF00881609.pd
Recommended from our members
Characterization of Greater-Than-Class C Sealed Sources Volume 2: Sealed Source Characterization and Future Production - September 1994
Sealed sources are small, relatively high-activity radioactive sources typically encapsulated in a metallic container. The activities can range from less than 1 mCi to over 1,000 Ci. They are used in a variety of industries and are commonly available. Many of the sources will be classified as Greater-Than-Class C low-level radioactive waste (GTCC LLW) for the purpose of waste disposal. The U.S. Department of Energy is responsible for disposing of this class of low-level radioactive waste. The characterization of a sealed source is essentially a function of the type of radiation it emits, the principal use for which it is applied, and the activity it contains. The types of radiation of most interest to the GTCC LLW Program are gamma rays and neutrons, since these are emitted by the highest activity sources. The principal uses of most importance are gamma irradiators, medical teletherapy, well logging probes, and other general neutron applications. Current annual production rates of potential Greater-Than-Class C (PGTCC) sources sold to specific licensees were estimated based on data collected from device manufacturers. These estimates were then adjusted for current trends in the industry to estimate future annual production rates. It is expected that there will be approximately 8,000 PGTCC sealed sources produced annually for specific licensees
Distributed feedback guided surface acoustic wave microresonator
Surface acoustic wave resonators have been used in a number of applications: high‐Q frequency filtering, very accurate frequency sources, etc. A major disadvantage of conventional resonators is their large dimensions, which makes them inadequate for integrated acoustics applications. In order to overcome these size limitations a new type of microresonator was designed, developed, and tested. In this paper, theoretical calculations and measurements on two kinds of such devices (a corrugated waveguide filter and a microresonator structure) are presented and their possible applications are discussed
- …