12,314 research outputs found

    Homological Product Codes

    Full text link
    Quantum codes with low-weight stabilizers known as LDPC codes have been actively studied recently due to their simple syndrome readout circuits and potential applications in fault-tolerant quantum computing. However, all families of quantum LDPC codes known to this date suffer from a poor distance scaling limited by the square-root of the code length. This is in a sharp contrast with the classical case where good families of LDPC codes are known that combine constant encoding rate and linear distance. Here we propose the first family of good quantum codes with low-weight stabilizers. The new codes have a constant encoding rate, linear distance, and stabilizers acting on at most n\sqrt{n} qubits, where nn is the code length. For comparison, all previously known families of good quantum codes have stabilizers of linear weight. Our proof combines two techniques: randomized constructions of good quantum codes and the homological product operation from algebraic topology. We conjecture that similar methods can produce good stabilizer codes with stabilizer weight nan^a for any a>0a>0. Finally, we apply the homological product to construct new small codes with low-weight stabilizers.Comment: 49 page

    Parametric evaluation of ball milling of SiC in water

    Get PDF
    A statistically designed experiment was conducted to determine optimum conditions for ball milling alpha-SiC in water. The influence of pH adjustment, volume percent solids loading, and mill rotational speed on grinding effectiveness was examined. An equation defining the effect of those milling variables on specific surface area was obtained. The volume percent solids loading of the slurry had the greatest influence on the grinding effectiveness in terms of increase in specific surface area. As grinding effectiveness improved, mill and media wear also increased. Contamination was minimized by use of sintered alpha-SiC milling hardware

    Particle size reduction of Si3N4 with Si3N4 milling hardware

    Get PDF
    The grinding of Si3N4 powder using reaction bonded Si3N4 attrition, vibratory, and ball mills with Si3N4 media was examined. The rate of particle size reduction and the change in the chemical composition of the powder were determined in order to compare the grinding efficiency and the increase in impurity content resulting from mill and media wear for each technique. Attrition and vibratory milling exhibited rates of specific surface area increase that were approximately eight times that observed in ball milling. Vibratory milling introduced the greatest impurity pickup

    Lie Algebras and Suppression of Decoherence in Open Quantum Systems

    Full text link
    Since there are many examples in which no decoherence-free subsystems exist (among them all cases where the error generators act irreducibly on the system Hilbert space), it is of interest to search for novel mechanisms which suppress decoherence in these more general cases. Drawing on recent work (quant-ph/0502153) we present three results which indicate decoherence suppression without the need for noiseless subsystems. There is a certain trade-off; our results do not necessarily apply to an arbitrary initial density matrix, or for completely generic noise parameters. On the other hand, our computational methods are novel and the result--suppression of decoherence in the error-algebra approach without noiseless subsystems--is an interesting new direction.Comment: 7 page

    Reliability analysis of a structural ceramic combustion chamber

    Get PDF
    The Weibull modulus, fracture toughness and thermal properties of a silicon nitride material used to make a gas turbine combustor were experimentally measured. The location and nature of failure origins resulting from bend tests were determined with fractographic analysis. The measured Weibull parameters were used along with thermal and stress analysis to determine failure probabilities of the combustor with the CARES design code. The effect of data censoring, FEM mesh refinement, and fracture criterion were considered in the analysis

    SU(m) non-Abelian anyons in the Jain hierarchy of quantum Hall states

    Full text link
    We show that different classes of topological order can be distinguished by the dynamical symmetry algebra of edge excitations. Fundamental topological order is realized when this algebra is the largest possible, the algebra of quantum area-preserving diffeomorphisms, called W1+∞W_{1+\infty}. We argue that this order is realized in the Jain hierarchy of fractional quantum Hall states and show that it is more robust than the standard Abelian Chern-Simons order since it has a lower entanglement entropy due to the non-Abelian character of the quasi-particle anyon excitations. These behave as SU(mm) quarks, where mm is the number of components in the hierarchy. We propose the topological entanglement entropy as the experimental measure to detect the existence of these quantum Hall quarks. Non-Abelian anyons in the ν=2/5\nu = 2/5 fractional quantum Hall states could be the primary candidates to realize qbits for topological quantum computation.Comment: 5 pages, no figures, a few typos corrected, a reference adde

    Note on graviton MHV amplitudes

    Full text link
    Two new formulas which express n-graviton MHV tree amplitudes in terms of sums of squares of n-gluon amplitudes are discussed. The first formula is derived from recursion relations. The second formula, simpler because it involves fewer permutations, is obtained from the variant of the Berends, Giele, Kuijf formula given in Arxiv:0707.1035.Comment: 10 page

    Response styles revisited: Racial/ethnic and gender differences in extreme responding

    Full text link
    https://deepblue.lib.umich.edu/bitstream/2027.42/137850/1/occ72.pd

    The Three Loop Equation of State of QED at High Temperature

    Get PDF
    We present the three loop contribution (order e4e^4) to the pressure of massless quantum electrodynamics at nonzero temperature. The calculation is performed within the imaginary time formalism. Dimensional regularization is used to handle the usual, intermediate stage, ultraviolet and infrared singularities, and also to prevent overcounting of diagrams during resummation.Comment: ANL-HEP-PR-94-02, SPhT/94-054 (revised final version

    Topologically-Protected Qubits from a Possible Non-Abelian Fractional Quantum Hall State

    Full text link
    The Pfaffian state is an attractive candidate for the observed quantized Hall plateau at Landau level filling fraction ν=5/2\nu=5/2. This is particularly intriguing because this state has unusual topological properties, including quasiparticle excitations with non-Abelian braiding statistics. In order to determine the nature of the ν=5/2\nu=5/2 state, one must measure the quasiparticle braiding statistics. Here, we propose an experiment which can simultaneously determine the braiding statistics of quasiparticle excitations and, if they prove to be non-Abelian, produce a topologically-protected qubit on which a logical NOT operation is performed by quasiparticle braiding. Using the measured excitation gap at ν=5/2\nu=5/2, we estimate the error rate to be 10−3010^{-30} or lower
    • …
    corecore