Dielectronic Resonance Method for Measuring Isotope Shifts

Longstanding problems in the comparison of very accurate hyperfine-shift measurements to theory were partly overcome by precise measurements on few-electron highly-charged ions. Still the agreement between theory and experiment is unsatisfactory. In this paper, we present a radically new way of precisely measuring hyperfine shifts, and demonstrate its effectiveness in the case of the hyperfine shift of $4s\_{1/2}$ and $4p\_{1/2}$ in $^{207}\mathrm{Pb}^{53+}$. It is based on the precise detection of dielectronic resonances that occur in electron-ion recombination at very low energy. This allows us to determine the hyperfine constant to around 0.6 meV accuracy which is on the order of 10%

Magnetostriction of ternary Fe–Ga–X (X = C,V,Cr,Mn,Co,Rh) alloys

Binary iron-gallium (Galfenol) alloys have large magnetostrictions over a wide temperature range. Single crystal measurements show that additions of 2 at. % or greater of 3d and 4d transition elements with fewer (V, Cr, Mo, Mn) and more (Co, Ni, Rh) valence electrons than Fe, all reduce the saturation magnetostriction. Kawamiya and Adachi [J. Magn. Magn. Mater. 31–34, 145 (1983)] reported that the D03 structure is stabilized by 3dtransition elements with electron∕atom ratios both less than iron and greater than iron. IfD03 ordering decreases the magnetostriction, the maximum magnetostriction should be largest for the (more disordered) binary Fe–Ga alloys as observed. Notably, addition of small amounts of C (0.07, 0.08, and 0.14 at. %) increases the magnetostriction of the slow cooled binary alloy to values comparable to the rapidly quenched alloy. We assume that small atom (C, B, N) additions enter interstitially and inhibit ordering, thus maximizing the magnetostriction without quenching

Water Quality Impacts of Natural Riparian Grasses Part 1: Empirical Studies

Studies were conducted on the effectiveness of natural riparian grass buffer strips in removing sediment and ag chemicals from surface runoff. No till and conventional tillage erosion plots served as the sediment and chemical source area. Runoff from the plots was directed onto 15, 30, and 45 foot filter strips where the inflow and outflow concentrations and sediment size distributions. Trapping percentages for sediment and ag chemicals typically ranged near or above 90%. An evaluation was made of the distribution of trapped chemicals among infiltrated mass and mass stored in the surface layer and on plant surfaces. The analysis showed that most of the chemicals were trapped by infiltration onto the soil matrix

Impact of Riparian Grass Filter Strips on Surface-Water Quality

The effectiveness of natural riparian grass filter strips in removing sediment and agricultural chemicals from surface runoff was studied using no-tillage and conventional-tillage erosion plots. Runoff from the tillage plots was directed onto 4.57, 9.14, and 13.72 m (15, 30, and 45 ft.) length filter strips, where the inflow and outflow concentrations and sediment size distributions were measured. Trapping efficiencies for sediment and agricultural chemicals typically ranged near or above 90 percent, mainly because of high infiltration rates. The filters also significantly reduced peak discharge concentrations, which reduced the impact of sediment and agricultural chemicals on receiving surface waters

Rhombohedral magnetostriction in dilute iron (Co) alloys

Iron is a well-utilized material in structural and magnetic applications. This does not mean, however, that it is well understood, especially in the field of magnetostriction. In particular, the rhombohedral magnetostriction of iron, λ111 , is anomalous in two respects: it is negative in sign, in disagreement with the prediction of first principles theory, and its magnitude decreases with increasing temperature much too rapidly to be explained by a power law dependence on magnetization. These behaviors could arise from the location of the Fermi level, which leaves a small region of the majority 3d t2g states unfilled, possibly favoring small internal displacements that split these states. If this view is correct, adding small amounts of Co to Fe fills some of these states, and the value of λ111 should increase toward a positive value, as predicted for perfect bcc Fe. We have measured the magnetostriction coefficients (λ111 and λ100) of pure Fe, Fe97Co3, and Fe94Co6 single crystals from 77 K to 450 K. Resonant ultrasound spectroscopy has been used to check for anomalies in the associated elastic constants, c 44 and c′. The additional electrons provided by the cobalt atoms indeed produced positive contributions to bothmagnetostriction constants, λ111 and λ100, exhibiting an increase of 2.8 × 10−6 per at. % Co for λ111 and 3.8 × 10−6 per at. % Co for λ100

Tetragonal magnetostriction and magnetoelastic coupling in Fe-Al, Fe-Ga, Fe-Ge, Fe-Si, Fe-Ga-Al, and Fe-Ga-Ge alloys

This paper presents a comparative study on the tetragonal magnetostriction constant,λγ,2, [ = (3/2)λ100] and magnetoelastic coupling, b1, of binary Fe100-xZx (0 \u3c x \u3c 35, Z = Al, Ga, Ge, and Si) and ternary Fe-Ga-Al and Fe-Ga-Ge alloys. The quantities are corrected for magnetostrains due to sample geometry (the magnetostrictive form effect). Recently published elastic constant data along with magnetization measurements at both room temperature and 77 K make these corrections possible. The form effect correction lowers the magnetostriction by ∼10 ppm for high-modulus alloys and by as much as 30 ppm for low-modulus alloys. The elastic constants are also used to determine the values of the magnetoelastic coupling constant, b1. With the new magnetostriction data on the Fe-Al-Ga alloy, it is possible to show how the double peak magnetostriction feature of the binary Fe-Ga alloy flows into the single peak binary Fe-Al alloy. The corrected magnetostriction and magnetoelastic coupling data for the various alloys are also compared using the electron-per-atom ratio, e/a, as the common variable. The Hume-Rothery rules link thee/a ratio to the regions of phase stability, which appear to be intimately related to the magnetostriction versus the solute concentration curve in these alloys. Using e/a as the abscissa tends to align the peaks in the magnetostriction and magnetoelastic coupling for the Fe-Ga, Fe-Ge, Fe-Al, Fe-Ga-Al, and Fe-Ga-Ge alloys, but not for the Fe-Si alloys for which the larger atomic size difference may play a greater role in phase stabilization. Corrections for the form effect are also presented for the rhombohedral magnetostriction,λɛ,2, and the magnetoelastic coupling, b2, of Fe100-xGax (0 \u3c x \u3c 35) alloys

Electron-ion recombination of Si IV forming Si III: Storage-ring measurement and multiconfiguration Dirac-Fock calculations

The electron-ion recombination rate coefficient for Si IV forming Si III was measured at the heavy-ion storage-ring TSR. The experimental electron-ion collision energy range of 0-186 eV encompassed the 2p(6) nl n'l' dielectronic recombination (DR) resonances associated with 3s to nl core excitations, 2s 2p(6) 3s nl n'l' resonances associated with 2s to nl (n=3,4) core excitations, and 2p(5) 3s nl n'l' resonances associated with 2p to nl (n=3,...,infinity) core excitations. The experimental DR results are compared with theoretical calculations using the multiconfiguration Dirac-Fock (MCDF) method for DR via the 3s to 3p n'l' and 3s to 3d n'l' (both n'=3,...,6) and 2p(5) 3s 3l n'l' (n'=3,4) capture channels. Finally, the experimental and theoretical plasma DR rate coefficients for Si IV forming Si III are derived and compared with previously available results.Comment: 13 pages, 9 figures, 3 tables. Accepted for publication in Physical Review