4,163 research outputs found
Nacelle design
The external cowlings of engine nacelles on large turbofan powered aircraft are good candidates for application of natural laminar flow. These nacelles usually have shorter characteristic lengths than other candidate surfaces such as wings and fuselages and therefore have lower characteristic Reynolds numbers. A conceptive figure of the natural flow nacelle (NLF) is shown. On the typical nacelle the flow accelerates to a curvature induced velocity peak near the lip and then decelerates over the remainder of the nacelle length. Transition occurs near the start of the deceleration, so turbulent flow with high friction coefficient exists over most of the nacelle length. On the other hand, the NLF nacelle is contoured to have an accelerating flow over most of its length, so transition is delayed, and a relatively lower friction drag exists over most of the nacelle. The motivation for development of the LFN is a potential 40 to 50 percent reduction in nacelle friction drag
LANDSAT data for state planning
The results of an effort to generate and apply automated classification of LANDSAT digital data to state of Georgia problems are presented. This phase centers on an analysis of the usefulness of LANDSAT digital data to provide land-use data for transportation planning. Hall County, Georgia was chosen as a test site because it is part of a seventeen county area for which the Georgia Department of Transportation is currently designing a Transportation Planning Land-Use Simulation Model. The land-cover information derived from this study was compared to several other existing sources of land-use data for Hall County and input into this simulation. The results indicate that there is difficulty comparing LANDSAT derived land-cover information with previous land-use information since the LANDSAT data are acquired on an acre by acre grid basis while all previous land-use surveys for Hall County used land-use data on a parcel basis
LANDSAT information for state planning
The transfer of remote sensing technology for the digital processing of LANDSAT data to state and local agencies in Georgia and other southeastern states is discussed. The project consists of a series of workshops, seminars, and demonstration efforts, and transfer of NASA-developed hardware concepts and computer software to state agencies. Throughout the multi-year effort, digital processing techniques have been emphasized classification algorithms. Software for LANDSAT data rectification and processing have been developed and/or transferred. A hardware system is available at EES (engineering experiment station) to allow user interactive processing of LANDSAT data. Seminars and workshops emphasize the digital approach to LANDSAT data utilization and the system improvements scheduled for LANDSATs C and D. Results of the project indicate a substantially increased awareness of the utility of digital LANDSAT processing techniques among the agencies contracted throughout the southeast. In Georgia, several agencies have jointly funded a program to map the entire state using digitally processed LANDSAT data
Study of USGS/NASA land use classification system
It is known from several previous investigations that many categories of land-use can be mapped via computer processing of Earth Resources Technology Satellite data. The results are presented of one such experiment using the USGS/NASA land-use classification system. Douglas County, Georgia, was chosen as the test site for this project. It was chosen primarily because of its recent rapid growth and future growth potential. Results of the investigation indicate an overall land-use mapping accuracy of 67% with higher accuracies in rural areas and lower accuracies in urban areas. It is estimated, however, that 95% of the State of Georgia could be mapped by these techniques with an accuracy of 80% to 90%
Geothermal reservoir simulation
The prediction of long-term geothermal reservoir performance and the environmental impact of exploiting this resource are two important problems associated with the utilization of geothermal energy for power production. Our research effort addresses these problems through numerical simulation. Computer codes based on the solution of partial-differential equations using finite-element techniques are being prepared to simulate multiphase energy transport, energy transport in fractured porous reservoirs, well bore phenomena, and subsidence
Design of a low cost earth resources system
The author has identified the following significant results. Survey results indicated that users of remote sensing data in the Southeastern U.S. were increasingly turning to digital processing techniques. All the states surveyed have had some involvement in projects using digitally processed data. Even those states which do not yet have in-house capabilities for digital processing were extremely interested in and were planning to develop such capabilities
Computer processing of peach tree decline data
There are no author-identified significant results in this report
Development of large-internal-surface-area nickel-metal plaques third quarterly progress report, dec. 19, 1964 - mar. 18, 1965
Electrodes impregnated with cadmium for porosity and electrochemical evaluatio
- …