1,294 research outputs found
Evaluation of feasibility of measuring EHD film thickness associated with cryogenic fluids
The feasibility of measuring elastohydrodynamic (EHD) films as formed with a cryogenic (LN2) fluid is evaluated. Modifications were made to an existing twin disk EHD apparatus to allow for disk lubrication with liquid nitrogen. This disk apparatus is equipped with an X-ray system for measuring the thickness of any lubricant film that is formed between the disks. Several film thickness experiments were conducted with the apparatus which indicate that good lubrication films are filmed with LN2. In addition to the film thickness studies, failure analyses of three bearings were conducted. The HPOTP turbine end bearings had experienced axial loads of 36,000 to 44,000 N (8,000 to 10,000 lb). High continuous radial loads were also experienced, which were most likely caused by thermal growth of the inner race. The resulting high internal loads caused race spalling and ball wear to occur
Incidence, morbidity and mortality of admissions related to alcohol consumption on critical care: a single-centre experience
Measurements of elastohydrodynamic film thickness, wear and tempering behavior of high pressure oxygen turbopump bearings
The reusable design of the Space Shuttle requires a target life of 7.5 hours for the turbopumps of the Space Shuttle main engine (SSME). This large increase from the few hundred seconds required in single-use rockets has caused various problems with the bearings of the turbopumps. The berings of the high pressure oxygen turbopump (HPOTP) were of particular concern because of wear, spalling, and cage failures at service time well below the required 7.5 hours. Lubrication and wear data were developed for the bearings. Since the HPOTP bearings operate in liquid oxygen, conventional liquid lubricants cannot be applied. Therefore, solid lubricant coatings and lubricant transfer from the polytetrafluorethylene (FTFE) cage were the primary lubrication approaches for the bearings. Measurements were made using liquid nitrogen in a rolling disk machine to determine whether usable elastohydrodynamic films could be generated to assist in the bearing lubrication
Design and operation of an autosampler controlled flow-injection preconcentration system for lead determination by flame atomic absorption spectrometry
Flow-injection manifolds are described which allow the preconcentration
of lead for flame atomic absorption determinations, using
columns contained within the sample loop of an injection valve. An
interface was designed which allowed the valves and pump in the
system to be controlled by an autosampler which enabled precise
timing of preconcentration and elution steps. The effects of sample
flow rate, buffer pH and buffer type for preconcentration and
eluent concentration and flow rate were investigated in order to
obtain optimum performance of the system. A 50-times improvement
in detection limits over conventional sample introduction was
obtained for a sample volume of approximately 12 ml, preconcentrated for
150 s. The injection of eluent, as opposed to the use of a
continuously flowing eluent stream, enabled this reagent to be
conserved
The design of a microprocessor system for automatic signal averaging and percentage purity calculations coupled to a nuclear magnetic resonance spectrometer
Predictors of Marital Satisfaction in Couples That Include a Physician Partner
It is estimated that the divorce rate for marriages in which at least one party is a physician is 10-20% higher than the general population. Predicting the variables that contribute to marital satisfaction, identifying the skills associated with those behaviors and developing a residency curriculum to teach the skills to resident physicians is the focus of this study. Intimacy, conflict resolution and emotional expressiveness have all been identified as important aspects of marital satisfaction. We will determine how each of these variables contributes to marital satisfaction using multilevel logistic regression. The results will be used to develop a skills based training curriculum for residency to improve the lives and well-being of physicians and their families
Identification and quantification of gaseous organic compounds emitted from biomass burning using two-dimensional gas chromatography/time-of-flight mass spectrometry
The current understanding of secondary organic aerosol (SOA) formation within biomass burning (BB) plumes is limited by the incomplete identification and quantification of the non-methane organic compounds (NMOCs) emitted from such fires. Gaseous organic compounds were collected on sorbent cartridges during laboratory burns as part of the fourth Fire Lab at Missoula Experiment (FLAME-4), with analysis by two-dimensional gas chromatography/time-of-flight mass spectrometry (GC×GC/TOFMS). The sensitivity and resolving power of GC×GC/TOFMS allowed the acquisition of the most extensive data set of BB NMOCs to date, with measure ments for 722 positively or tentatively identified compounds. Estimated emission factors (EFs) are presented for these compounds for burns of six different vegetative fuels, including conifer branches, grasses, agricultural residue, and peat. The number of compounds detected from individual burns ranged from 129 to 474, and included extensive isomer groups. For example, 38 monoterpene isomers were observed in the emissions from coniferous fuels; the isomeric ratios were found to be consistent with those reported in relevant essential oils, suggesting that the composition of such oils may be very useful when predicting fuel-dependent terpene emissions. Further, eleven sesquiterpenes were detected and tentatively identified, providing the first reported speciation of sesquiterpenes in gas-phase BB emissions. The calculated EFs for all measured compounds are compared and discussed in the context of potential SOA formation
Evaluation of outer race tilt and lubrication on ball wear and SSME bearing life reductions
Several aspects of the SSME bearing operation were evaluated. The possibility of elastohydrodynamics (EHD) lubrication with a cryogenic fluid was analyzed. Films as thick as .61 microns were predicted with one theory which may be thick enough to provide hydrodynamic support. The film formation, however, is heavily dependent on good surface finish and a low bulk bearing temperature. Bearing dynamics to determine if the radial stiffness of a bearing which are dependent on bearing misalignment were analyzed. Four ball tests were conducted at several environmental conditions from an LN2 bath to 426 C in air. Surface coatings and ball materials are evaluated. Severe wear and high friction are measured for all ball materials except when the balls have surface lubricant coatings
Identification and quantification of gaseous organic compounds emitted from biomass burning using two-dimensional gas chromatography–time-of-flight mass spectrometry
The current understanding of secondary organic aerosol (SOA) formation within biomass burning (BB) plumes is limited by the incomplete identification and quantification of the non-methane organic compounds (NMOCs) emitted from such fires. Gaseous organic compounds were collected on sorbent cartridges during laboratory burns as part of the fourth Fire Lab at Missoula Experiment (FLAME-4) and analyzed by two-dimensional gas chromatography-time-of-flight mass spectrometry (GC x GC-ToFMS). The sensitivity and resolving power of GC x GC-ToFMS allowed the acquisition of the most extensive data set of BB NMOCs to date, with measurements from 708 positively or tentatively identified compounds. Estimated emission factors (EFs) are presented for these compounds for burns of six different vegetative fuels, including conifer branches, grasses, agricultural residue, and peat. The number of compounds meeting the peak selection criteria ranged from 129 to 474 among individual burns, and included extensive isomer groups. For example, 38 monoterpene isomers were observed in the emissions from coniferous fuels; the isomeric ratios were found to be consistent with those reported in relevant essential oils, suggested that the composition of such oils may be very useful when predicting fuel-dependent terpene emissions. Further, 11 sesquiterpenes were deteched and tentatively identified, providing the first reported speciation of sesquiterpenes in gas-phase BB emissions. The calculated EFs for all measured compounds are compared and discussed in the context of potential SOA formation
- …