48,945 research outputs found
A heterotic sigma model with novel target geometry
We construct a (1,2) heterotic sigma model whose target space geometry
consists of a transitive Lie algebroid with complex structure on a Kaehler
manifold. We show that, under certain geometrical and topological conditions,
there are two distinguished topological half--twists of the heterotic sigma
model leading to A and B type half--topological models. Each of these models is
characterized by the usual topological BRST operator, stemming from the
heterotic (0,2) supersymmetry, and a second BRST operator anticommuting with
the former, originating from the (1,0) supersymmetry. These BRST operators
combined in a certain way provide each half--topological model with two
inequivalent BRST structures and, correspondingly, two distinct perturbative
chiral algebras and chiral rings. The latter are studied in detail and
characterized geometrically in terms of Lie algebroid cohomology in the
quasiclassical limit.Comment: 83 pages, no figures, 2 references adde
Seismological support for the metastable superplume model, sharp features, and phase changes within the lower mantle
Recently, a metastable thermal-chemical convection model was proposed to explain the African Superplume. Its bulk tabular shape remains relatively stable while its interior undergoes significant stirring with low-velocity conduits along its edges and down-welling near the middle. Here, we perform a mapping of chemistry and temperature into P and S velocity variations and replace a seismically derived structure with this hybrid model. Synthetic seismogram sections generated for this 2D model are then compared directly with corresponding seismic observations of P (P, PCP, and PKP) and S (S, SCS, and SKS) phases. These results explain the anticorrelation between the bulk velocity and shear velocity and the sharpness and level of SKS travel time delays. In addition, we present evidence for the existence of a D" triplication (a putative phase change) beneath the down-welling structure
Detection of zeptojoule microwave pulses using electrothermal feedback in proximity-induced Josephson junctions
We experimentally investigate and utilize electrothermal feedback in a
microwave nanobolometer based on a normal-metal
(\mbox{Au}_{x}\mbox{Pd}_{1-x}) nanowire with proximity-induced
superconductivity. The feedback couples the temperature and the electrical
degrees of freedom in the nanowire, which both absorbs the incoming microwave
radiation, and transduces the temperature change into a radio-frequency
electrical signal. We tune the feedback in situ and access both positive and
negative feedback regimes with rich nonlinear dynamics. In particular, strong
positive feedback leads to the emergence of two metastable electron temperature
states in the millikelvin range. We use these states for efficient threshold
detection of coherent 8.4 GHz microwave pulses containing approximately 200
photons on average, corresponding to 1.1 \mbox{ zJ} \approx 7.0 \mbox{ meV}
of energy
Retrodictive states and two-photon quantum imaging
We use retrodictive quantum theory to analyse two-photon quantum imaging
systems. The formalism is particularly suitable for calculating conditional
probability distributions.Comment: 5 pages, 3 figure
ACREAGE PLANTING DECISION ANALYSIS OF SOUTH CAROLINA TOMATOES: NERLOVIAN VERSUS JUST RISK MODEL
Factors which explain supply response behavior of South Carolina tomato growers were determined. Two well known supply response models were used for comparison: the Nerlovian structural model and the Just risk model. The Just risk model reflected the significance of the risk effect in both stable and unstable periods. An evaluation of forecasting power between the two models was indeterminate. Growers are apparently willing to invest in more information with increased market instability because growers were influenced by the Florida winter price of tomatoes in planting decisions during the period of instability.Crop Production/Industries,
Effects of axisymmetric contractions on turbulence of various scales
Digitally acquired and processed results from an experimental investigation of grid generated turbulence of various scales through and downstream of nine matched cubic contour contractions ranging in area ratio from 2 to 36, and in length to inlet diameter ratio from 0.25 to 1.50 are reported. An additional contraction with a fifth order contour was also utilized for studying the shape effect. Thirteen homogeneous and nearly isotropic test flow conditions with a range of turbulence intensities, length scales and Reynolds numbers were generated and used to examine the sensitivity of the contractions to upstream turbulence. The extent to which the turbulence is altered by the contraction depends on the incoming turbulence scales, the total strain experienced by the fluid, as well as the contraction ratio and the strain rate. Varying the turbulence integral scale influences the transverse turbulence components more than the streamwise component. In general, the larger the turbulence scale, the lesser the reduction in the turbulence intensity of the transverse components. Best agreement with rapid distortion theory was obtained for large scale turbulence, where viscous decay over the contraction length was negligible, or when a first order correction for viscous decay was applied to the results
(k,q)-Compressed Sensing for dMRI with Joint Spatial-Angular Sparsity Prior
Advanced diffusion magnetic resonance imaging (dMRI) techniques, like
diffusion spectrum imaging (DSI) and high angular resolution diffusion imaging
(HARDI), remain underutilized compared to diffusion tensor imaging because the
scan times needed to produce accurate estimations of fiber orientation are
significantly longer. To accelerate DSI and HARDI, recent methods from
compressed sensing (CS) exploit a sparse underlying representation of the data
in the spatial and angular domains to undersample in the respective k- and
q-spaces. State-of-the-art frameworks, however, impose sparsity in the spatial
and angular domains separately and involve the sum of the corresponding sparse
regularizers. In contrast, we propose a unified (k,q)-CS formulation which
imposes sparsity jointly in the spatial-angular domain to further increase
sparsity of dMRI signals and reduce the required subsampling rate. To
efficiently solve this large-scale global reconstruction problem, we introduce
a novel adaptation of the FISTA algorithm that exploits dictionary
separability. We show on phantom and real HARDI data that our approach achieves
significantly more accurate signal reconstructions than the state of the art
while sampling only 2-4% of the (k,q)-space, allowing for the potential of new
levels of dMRI acceleration.Comment: To be published in the 2017 Computational Diffusion MRI Workshop of
MICCA
Penning traps with unitary architecture for storage of highly charged ions
Penning traps are made extremely compact by embedding rare-earth permanent
magnets in the electrode structure. Axially-oriented NdFeB magnets are used in
unitary architectures that couple the electric and magnetic components into an
integrated structure. We have constructed a two- magnet Penning trap with
radial access to enable the use of laser or atomic beams, as well as the
collection of light. An experimental apparatus equipped with ion optics is
installed at the NIST electron beam ion trap (EBIT) facility, constrained to
fit within 1 meter at the end of a horizontal beamline for transporting highly
charged ions. Highly charged ions of neon and argon, extracted with initial
energies up to 4000 eV per unit charge, are captured and stored to study the
confinement properties of a one-magnet trap and a two-magnet trap. Design
considerations and some test results are discussed
Scalable squeezed light source for continuous variable quantum sampling
We propose a novel squeezed light source capable of meeting the stringent
requirements of continuous variable quantum sampling. Using the effective
interaction induced by a strong driving beam in the presence of the
response in an integrated microresonator, our device is compatible
with established nanophotonic fabrication platforms. With typical realistic
parameters, squeezed states with a mean photon number of 10 or higher can be
generated in a single consistent temporal mode at repetition rates in excess of
100MHz. Over 15dB of squeezing is achievable in existing ultra-low loss
platforms
- …