756 research outputs found
Single-Pole Double-Throw MMIC Switches for a Microwave Radiometer
In order to reduce the effect of gain and noise instabilities in the RF chain of a microwave radiometer, a Dicke radiometer topology is often used, as in the case of the proposed surface water and ocean topography (SWOT) radiometer instrument. For this topology, a single-pole double-throw (SPDT) microwave switch is needed, which must have low insertion loss at the radiometer channel frequencies to minimize the overall receiver noise figure. Total power radiometers are limited in accuracy due to the continuous variation in gain of the receiver. High-frequency SPDT switches were developed in the form of monolithic microwave integrated circuits (MMICs) using 75 micron indium phosphide (InP) PIN-diode technology. These switches can be easily integrated into Dicke switched radiometers that utilize microstrip technology
Characterization and Bioremediation of Birch Condensate
Birch (Betula papyrifera Marsh) condensate collected from a veneer plant in Michigan was analyzed for its major chemical constituents. This condensate contained carbohydrates and lipids. In the lipid fractions, triglycerides were the most abundant component (35-40%), followed by phenolic compounds (30%) and waxes (25-30%). Gas Chromatography-Mass Spectrometry (GC-MS) and Fast Atom Bombardment (FAB) MS were used to identify 14 lipid compounds. A white rot fungus, Phanerochaete chrysosporium [Burdsall-lombard, 5176, HHB-6251], was tested as a means for the bio-remediation of the condensate. P. chrysosporium reduced the total organic content (TOC) of the condensate from 350 ppm to 22 ppm and the color intensity from 0.614 to 0.355 absorbance units, after 2 weeks incubation in a liquid medium containing yeast and peptonc at pH 5
On-Wafer S-Parameter Measurements in the 325-508-GHz Band
New circuits have been designed and fabricated with operating frequencies over 325 GHz. In order to measure S-parameters of these circuits, an extensive process of wafer dicing and packaging, and waveguide transition design, fabrication, and packaging would be required. This is a costly and time-consuming process before the circuit can be tested in waveguide. The new probes and calibration procedures will simplify the testing process. New on-wafer probes, and a procedure for their calibration, have been developed that allow fast and inexpensive S-parameter characterization of circuits in the 325 -508 -GHz frequency band. The on-wafer probes transition from rectangular waveguide to coplanar waveguide probe tips with 40- m nominal signal-to-ground pin pitch so as to allow for probing circuits on a wafer. The probes with bias tees have been optimized for minimal insertion loss and maximum return loss when placed on 50-ohm structures to allow for calibration. The calibration process has been developed using the Thru-Reflect-Line Agilent algorithm with JPL determined calibration structures and calibration coefficients for the algorithm. This new test capability is presently unique to JPL. With it, researchers will be able to better develop circuits such as low-noise amplifiers, power amplifiers, multipliers, and mixers for heterodyne receivers in the 325-508-GHz frequency band for remote sensing/spectroscopy
Cryogenic 160-GHz MMIC Heterodyne Receiver Module
A cryogenic 160-GHz MMIC heterodyne receiver module has demonstrated a system noise temperature of 100 K or less at 166 GHz. This module builds upon work previously described in Development of a 150-GHz MMIC Module Prototype for Large-Scale CMB Radiation (NPO-47664), NASA Tech Briefs, Vol. 35, No. 8 (August 2011), p. 27. In the original module, the local oscillator signal was saturating the MMIC low-noise amplifiers (LNAs) with power. In order to suppress the local oscillator signal from reaching the MMIC LNAs, the W-band (75 110 GHz) signal had to be filtered out before reaching 140 170 GHz. A bandpass filter was developed to cover 120 170 GHz, using microstrip parallel-coupled lines to achieve the desired filter bandwidth, and ensure that the unwanted W-band local oscillator signal would be sufficiently suppressed. With the new bandpass filter, the entire receiver can work over the 140 180-GHz band, with a minimum system noise temperature of 460 K at 166 GHz. The module was tested cryogenically at 20 K ambient temperature, and it was found that the receiver had a noise temperature of 100 K over an 8-GHz bandwidth. The receiver module now includes a microstrip bandpass filter, which was designed to have a 3-dB bandwidth of approximately 120-170 GHz. The filter was fabricated on a 3-mil-thick alumina substrate. The filter design was based on a W-band filter design made at JPL and used in the QUIET (Q/U Imaging ExperimenT) radiometer modules. The W-band filter was scaled for a new center frequency of 150 GHz, and the microstrip segments were changed accordingly. Also, to decrease the bandwidth of the resulting scaled design, the center gaps between the microstrip lines were increased (by four micrometers in length) compared to the gaps near the edges. The use of the 150-GHz bandpass filter has enabled the receiver module to function well at room temperature. The system noise temperature was measured to be less than 600 K (at room temperature) from 154 to 168 GHz. Additionally, the use of a W-band isolator between the receiver module and the local oscillator source also improved the noise temperature substantially. This may be because the mixer was presented with a better impedance match with the use of the isolator. Cryogenic testing indicates a system noise temperature of 100 K or less at 166 GHz. Prior tests of the MMIC amplifiers alone have resulted in a system noise temperature of 65.70 K in the same frequency range (.160 GHz) when cooled to an ambient temperature of 20 K. While other detector systems may be slightly more sensitive (such as SIS mixers), they require more cooling (to 4 K ambient) and are not as easily scalable to build a large array, due to the need for large magnets and other equipment. When cooled to 20 K, this receiver module achieves approximately 100 K system noise temperature, which is slightly higher than single-amplifier module results obtained at JPL (65.70 K when an amplifier is corrected for back-end noise contributions). If this performance can be realized in practice, and a scalable array can be produced, the impact on cosmic microwave background experiments, astronomical and Earth spectroscopy, interferometry, and radio astronomy in general will be dramatic
Exploring the self-assembly and energy transfer of dynamic supramolecular iridium-porphyrin systems
EZ-C acknowledges the University of St Andrews for financial support. IDWS acknowledges support from EPSRC (EP/J009016) and the European Research Council (grant 321305). IDWS also acknowledges support from a Royal Society Wolfson research merit award. DJ acknowledges the European Research Council (grant: 278845) and the RFI Lumomat for financial support.We present the first examples of dynamic supramolecular systems composed of cyclometalated Ir(III) complexes of the form of [Ir(C^N)2(N^N)]PF6 (where C^N is mesppy = 2-phenyl-4-mesitylpyridinato and dFmesppy = 2-(4,6-difluorophenyl)-4-mesitylpyridinato and N^N is 4,4':2',2'':4'',4'''-quaterpyridine, qpy) and zinc tetraphenylporphyrin (ZnTPP), assembled through non-covalent interactions between the distal pyridine moieties of the qpy ligand located on the iridium complex and the zinc of the ZnTPP. The assemblies have been comprehensively characterized by a series of analytical techniques (1H NMR titration experiments, 2D COSY and HETCOR NMR spectra and low temperature 1H NMR spectroscopy) and the crystal structures have been elucidated by X-ray diffraction. The optoelectronic properties of the assemblies and the electronic interaction between the iridium and porphyrin chromophoric units have been explored with detailed photophysical measurements, supported by time-dependent density functional theory (TD-DFT) calculations.PostprintPeer reviewe
A simple combinatorial treatment of constructions and threshold gaps of ramp schemes
We give easy proofs of some recent results concerning threshold gaps in ramp schemes. We then generalise a construction method for ramp schemes employing error-correcting codes so that it can be applied using nonlinear (as well as linear) codes. Finally, as an immediate consequence of these results, we provide a new explicit bound on the minimum length of a code having a specified distance and dual distance
in NonCommutative Standard Model
We study the top quark decay to b quark and W boson in the NonCommutative
Standard Model (NCSM). The lowest contribution to the decay comes from the
terms quadratic in the matrix describing the noncommutative (NC) effects while
the linear term is seen to identically vanish because of symmetry. The NC
effects are found to be significant only for low values of the NC
characteristic scale.Comment: 11 page Latex file containing 2 eps figures (redrawn). More
discussion included. To appear in PR
System size resonance in coupled noisy systems and in the Ising model
We consider an ensemble of coupled nonlinear noisy oscillators demonstrating
in the thermodynamic limit an Ising-type transition. In the ordered phase and
for finite ensembles stochastic flips of the mean field are observed with the
rate depending on the ensemble size. When a small periodic force acts on the
ensemble, the linear response of the system has a maximum at a certain system
size, similar to the stochastic resonance phenomenon. We demonstrate this
effect of system size resonance for different types of noisy oscillators and
for different ensembles -- lattices with nearest neighbors coupling and
globally coupled populations. The Ising model is also shown to demonstrate the
system size resonance.Comment: 4 page
RC J0311+0507: A Candidate for Superpowerful Radio Galaxies in the Early Universe at Redshift z=4.514
A strong emission line at 6703A has been detected in the optical spectrum for
the host galaxy (R=23.1) of the radio source RC J0311+0507 (4C+04.11). This
radio galaxy, with a spectral index of 1.31 in the frequency range 365-4850
MHz, is one of the ultrasteep spectrum objects from the deep survey of a sky
strip conducted with RATAN-600 in 1980-1981. We present arguments in favor of
the identification of this line with Ly\alpha at redshift z=4.514. In this
case, the object belongs to the group of extremely distant radio galaxies of
ultrahigh radio luminosity (P_{1400}=1.3 x 10^{29}W Hz^{-1}). Such power can be
provided only by a fairly massive black hole (~10^9M_\sun}) that formed in a
time less than the age of the Universe at the observed z(1.3 Gyr) or had a
primordial origin.Comment: 8 pages, 3 figure
BAK Alters Neuronal Excitability and Can Switch from Anti- to Pro-Death Function during Postnatal Development
AbstractBAK is a pro-apoptotic BCL-2 family protein that localizes to mitochondria. Here we evaluate the function of BAK in several mouse models of neuronal injury including neuronotropic Sindbis virus infection, Parkinson's disease, ischemia/stroke, and seizure. BAK promotes or inhibits neuronal death depending on the specific death stimulus, neuron subtype, and stage of postnatal development. BAK protects neurons from excitotoxicity and virus infection in the hippocampus. As mice mature, BAK is converted from anti- to pro-death function in virus-infected spinal cord neurons. In addition to regulating cell death, BAK also protects mice from kainate-induced seizures, suggesting a possible role in regulating synaptic activity. BAK can alter neurotransmitter release in a direction consistent with its protective effects on neurons and mice. These findings suggest that BAK inhibits cell death by modifying neuronal excitability
- …