7 research outputs found
Recommended from our members
Submicrometer spectromicroscopy of UO2aged under high humidity conditions
The oxidation of uranium dioxide is a complicated process, depending on factors including humidity, temperature, and microstructure. To further determine the characteristics of this process, UO2 particles were allowed to age and agglomerate under 98% relative humidity at room temperature for 378 days. A focused ion beam (FIB) section of this agglomeration was then measured at the O K-edge, U N5-edge, and C K-edge using the scanning transmission x-ray microscope (STXM) at the Advanced Light Source. O K-edge and U N5-edge x-ray absorption measurements allowed for the elemental and chemical species mapping of the agglomerates and indicated the formation of schoepite at the submicrometer scale in specific locations. Non-negative matrix factorization was employed to elucidate the main components at the O K-edge, which were uranyl (schoepite) formed primarily at the interface of the sample with controlled atmosphere, a UO2-like bulk component present in the majority of the sample, and an oxygen species present at the surface of the FIB section, which is likely adsorbed water. STXM spectromicroscopy measurements at the U N5-edge measurements also confirmed the location of oxidized uranium. This analysis is a valuable insight into the formation of schoepite on UO2 and shows the sensitivity to and utility of STXM spectromicroscopy for uranium speciation
Recommended from our members
Ferromagnetic quantum critical point in CePd2 P2 with Pd → Ni substitution
An investigation of the structural, thermodynamic, and electronic transport properties of the isoelectronic chemical substitution series Ce(Pd1-xNix)2P2 is reported, where a possible ferromagnetic quantum critical point is uncovered in the temperature-concentration (T-x) phase diagram. This behavior results from the simultaneous contraction of the unit cell volume, which tunes the relative strengths of the Kondo and Ruderman-Kittel-Kasuya-Yosida (RKKY) interactions, and the introduction of disorder through alloying. Near the critical region at xcr≈ 0.7, the rate of contraction of the unit cell volume strengthens, indicating that the cerium f valence crosses over from trivalent to a noninteger value. Consistent with this picture, x-ray absorption spectroscopy measurements reveal that while CePd2P2 has a purely trivalent cerium f state, CeNi2P2 has a small (<10 %) tetravalent contribution. In a broad region around xcr, there is a breakdown of Fermi-liquid temperature dependences, signaling the influence of quantum critical fluctuations and disorder effects. Measurements of clean CePd2P2 furthermore show that applied pressure has an initial effect similar to alloying on the ferromagnetic order. From these results, CePd2P2 emerges as a keystone system to test theories such as the Belitz-Kirkpatrick-Vojta model for ferromagnetic quantum criticality, where distinct behaviors are expected in the dirty and clean limits
Dynamics of laser-driven heavy-ion acceleration clarified by ion charge states
Motivated by the development of next-generation heavy-ion sources, we have investigated the ionization and acceleration dynamics of an ultraintense laser-driven high- Z silver target, experimentally, numerically, and analytically. Using a novel ion measurement technique allowing us to uniquely identify silver ions, we experimentally demonstrate generation of highly charged silver ions ( Z ∗ = 45 + 2 − 2 ) with energies of > 20 MeV/nucleon ( > 2.2 GeV) from submicron silver targets driven by a laser with intensity 5 × 10 21 W / cm 2 , with increasing ion energy and charge state for decreasing target thickness. We show that although target pre-expansion by the unavoidable rising edge of state-of-the-art high-power lasers can limit proton energies, it is advantageous for heavy-ion acceleration. Two-dimensional particle-in-cell simulations show that the Joule heating in the target bulk results in a high temperature ( ∼ 10 keV ) solid density plasma, leading to the generation of high flux highly charged ions ( Z ∗ = 40 + 2 − 2 , ≳ 10 MeV / nucleon ) via electron collisional ionization, which are extracted and accelerated with a small divergence by an extreme sheath field at the target rear. However, with reduced target thickness this favorable acceleration is degraded due to the target deformation via laser hole boring, which accompanies higher energy ions with higher charge states but in an uncontrollable manner. Our elucidation of the fundamental processes of high-intensity laser-driven ionization and ion acceleration provides a path for improving the control and parameters of laser-driven heavy-ion sources, a key component for next-generation heavy-ion accelerators