11 research outputs found
Epoxy composite dusts with and without carbon nanotubes cause similar pulmonary responses, but differences in liver histology in mice following pulmonary deposition
Inorganic chemical composition given as elemental weight% measured by standardless WDXRF. The three epoxy materials were measured as solid disks (4 cm in diameter, 1 cm high). For comparison, the results for CNT powder, previously published in [25], were added to the figure. Displayed axis 99.7 – 100 %. (PPTX 71 kb
Societal and Politic Aspects of the Introduction of Nanotechnology in Healthcare Applications.
Abstract not availableJRC.H-Institute for environment and sustainability (Ispra
Simulation of Cellular-Dendritic Solidification Structures of Binary Alloys in Three Dimensional Growth Using a Multiparticle Diffusion Limited Aggregation Model.
Abstract not availableJRC.H-Institute for environment and sustainability (Ispra
Simulation of Solidification Structures of Binary Alloys: a Multi-Particle Diffusion Limited Aggregation Model with Surface Rearrangement.
The thermodynamics and kinetics of isothermal solidification in binary alloy melts were simulated in a two-dimensional model incorporating the effects of nearest and next nearest neighbours at the solid-liquid interfaces, taking into account the simultaneous diffusion in the melt of all diffusing paritcles (atoms) and allowing solid-liquid interface rearrangement on a local scale. The next nearest neighbour interaction and the surface rearrangement were shown to have large effects on the resulting morphologies. Further the influences of the operating diffusion coefficient and the sticking rule for the solidifying particle were analysed. A wide range of growth modes, dendritic, massive, equiaxed, eutetic, and transitions there of during solidification, also involving change of time dependency of the growth velocity, as observed in practice, could be given a rationalistic basis.JRC.I-Institute for Health and Consumer Protection (Ispra
Highly Textured Nanostructure of Pulsed Laser Deposited IrO2 Thin Films as Investigated by Transmission Electron Microscopy.
Abstract not availableJRC.I-Institute for Health and Consumer Protection (Ispra
High-Resolution Transmission Electron Microscopy Investigation of the Nanostructure of Undoped and Pt-Doped Nanocrystalline Pulsed Laser Deposited SnO2 Thin Films.
Abstract not availableJRC.I-Institute for Health and Consumer Protection (Ispra
Interstitial Position of Tin Ions in alpha-(Fe-rich Sn)2O3 Solid Solutions Prepared by Mechanical Alloying.
The microstructures of four 94, 85, and 71 mal % alfa-Fe03-Sao2 samples prepared by mechanical allying have been studied by x-ray diffraction with Rietveld structure refinements. The alfa-(FerichSn)2O3 solid solutions with higher Sao2 contents in the immiscible ceramic system have been synthesized by mechanical alloying, On the basis of the structure refinements to the whole x-ray diffraction patterns for the four as-milled samples, it is found that tin ions do not substitute iron ions in the solid solutions, although this model is generally assumed in literature.JRC.I-Institute for Health and Consumer Protection (Ispra
Hardfacing of Stainless Steel with Laser Melted Colmonoy.
Abstract not availableJRC.I-Institute for Health and Consumer Protection (Ispra
Laser Cladding of Stainless Steel with Hastelloy.
Abstract not availableJRC.I-Institute for Health and Consumer Protection (Ispra
Pulsed Laser Deposition of Nanostructured Tin Oxide Films for Gas Sensing Applications.
Abstract not availableJRC.I-Institute for Health and Consumer Protection (Ispra