65 research outputs found
Разработка интерактивной моделирующей системы технологии низкотемпературной сепарации газа
We present a study of J ψ meson production in collisions of 26.7 GeV electrons with 820 GeV protons, performed with the H1-detector at the HERA collider at DESY. The J ψ mesons are detected via their leptonic decays both to electrons and muons. Requiring exactly two particles in the detector, a cross section of σ(ep → J ψ X) = (8.8±2.0±2.2) nb is determined for 30 GeV ≤ W γp ≤ 180 GeV and Q 2 ≲ 4 GeV 2 . Using the flux of quasi-real photons with Q 2 ≲ 4 GeV 2 , a total production cross section of σ ( γp → J / ψX ) = (56±13±14) nb is derived at an average W γp =90 GeV. The distribution of the squared momentum transfer t from the proton to the J ψ can be fitted using an exponential exp(− b ∥ t ∥) below a ∥ t ∥ of 0.75 GeV 2 yielding a slope parameter of b = (4.7±1.9) GeV −2
A Measurement of the Proton Structure Function
A measurement of the proton structure function is reported
for momentum transfer squared between 4.5 and 1600 and
for Bjorken between and 0.13 using data collected by the
HERA experiment H1 in 1993. It is observed that increases
significantly with decreasing , confirming our previous measurement made
with one tenth of the data available in this analysis. The dependence is
approximately logarithmic over the full kinematic range covered. The subsample
of deep inelastic events with a large pseudo-rapidity gap in the hadronic
energy flow close to the proton remnant is used to measure the "diffractive"
contribution to .Comment: 32 pages, ps, appended as compressed, uuencoded fil
Исследование точности отверстий и их усадки в обрабатываемых дорнованием втулках
В работе рассмотрены область применения ,виды дорнов, схема процесса дорнования отверстия, схема параметры дорнования отверстия, плюсы и минусы дорнования, и оборудование для дорнования.
Потом использование конечно-элементного программного обеспечения ANSYS для моделирования процесса обработки.
Затем проведено исследование зависимости усадки отверстия от натяга, степени толстостенности, механических свойств материала, а также исследована кривизна обработанных отверстий.
В заключении изложены выводы о проделанной работе и представлено уравнение описывающее исследованные зависимости.In the work, the scope of application, types of mandrels, a diagram of the mandrel process of a hole, a diagram of the parameters of a mandrel of a hole, the pros and cons of mandrel, and equipment for mandrel are considered.
Then the use of ANSYS finite element software to simulate the processing process.
Then the study of the dependence of the hole shrinkage on the tightness, the degree of thickness, the mechanical properties of the material was carried out, and the curvature of the machined holes was also investigated.
In the conclusion, the conclusions about the work done are presented and the equation describing the investigated dependences is presented
- …