Data Management Study, Volume 5. Appendix H - Contractor Data Package Logistics and Support /LS/ Final Report

Contractor data package for Voyager logistics and support in transportation, communications, supply, and maintenanc

Data management study, volume 5. Appendix F - Contractor data package test /TE/ and mission operations /MP/ Final report

Test and mission operations contractor data package for Voyager spacecraf

Preparation of silicon carbide-silicon nitride fibers by the pyrolysis of polycarbosilazane precursors

The development of silicon carbide-silicon nitride fibers (SiC-Si3N4) by the pyrolysis of polycarbosilazane precursors is reviewed. Precursor resin, which was prepared by heating tris(N-methylamino)methylsilane or tris(N-methylamino)phenylsilane to about 520 C, was drawn into fibers from the melt and then made unmeltable by humidity conditioning at 100 C and 95 percent relative humidity. The humidity treated precursor fibers were pyrolyzed to ceramic fibers with good mechanical properties and electrical resistivity. For example, SiC-Si3N4 fibers derived from tris(N-methylamino)methylsilane had a tensile rupture modulus of 29 million psi and electrical resistivity of 6.9 x ten to the 8th power omega-cm, which is ten to the twelfth power times greater than that obtained for graphite fibers

Dynamic model for failures in biological systems

A dynamic model for failures in biological organisms is proposed and studied both analytically and numerically. Each cell in the organism becomes dead under sufficiently strong stress, and is then allowed to be healed with some probability. It is found that unlike the case of no healing, the organism in general does not completely break down even in the presence of noise. Revealed is the characteristic time evolution that the system tends to resist the stress longer than the system without healing, followed by sudden breakdown with some fraction of cells surviving. When the noise is weak, the critical stress beyond which the system breaks down increases rapidly as the healing parameter is raised from zero, indicative of the importance of healing in biological systems.Comment: To appear in Europhys. Let

How to Collect your Water Sample and Interpret the Results for the Poultry Analytical Package

Rapidly growing birds may consume up to twice as much water as feed (Scantling and Watkins 2013), which means a plentiful supply of clean water is crucial for poultry health and productivity. To determine the quality of your poultry’s water resources, periodic sampling and analysis is needed. Analyzing water supplies can also be a crucial tool in identifying existing or potential challenges. The Arkansas Water Resources Center (AWRC) in cooperation with the UA Cooperative Extension Service offers several analytical packages to assess the quality of your water resources. This document is intended to provide guidance to poultry producers on collecting water samples for analysis and understanding the “Poultry Water Report Form” provided by the AWRC’s Water Quality Laboratory (Lab). The information contained within this fact sheet should be used as general guidance, and the reader is encouraged to seek advice from Extension specialists regarding the interpretation of individual reports and water testing results that may be of concern

Stoichiometry control of sputtered CuCl thin films: Influence on ultraviolet emission properties

We demonstrate that the chemical composition of the sputtered CuCl thin films could be finely controlled by adjusting the bias to the substrate. The films deposited without any intentional bias were Cl rich (CuCl1+x), a bias of −22 V yielded stoichiometric CuCl, and a further increase in the negative bias resulted in Cl deficient films (CuCl1−x). The crystalline and optical properties were found to be associated with the chemical composition. Cl rich films showed a deep level green emission at around 515 nm in addition to ultraviolet (UV) excitonic emission. The stoichiometric films have higher optical quality, exhibiting a sharp UV emission at around 385 nm at room temperature, compared to nonstoichiometric samples. Visible luminescence related to deep level defects was not observed in the stoichiometric films. Changes in energy of the flux from the target and the subsequent ion bombardment on the substrate surface are correlated with the variations in chemical composition and their impact on the film microstructure and UV emission

System and market failures: the unavailability of magnesium sulphate for the treatment of eclampsia and pre-eclampsia in Mozambique and Zimbabwe.

Low cost and effective drugs, such as magnesium sulphate, need to be included in initiatives to improve access to essential medicines in Afric

Effects of seawater and deionized water at 0 to 80 deg C on the flexural properties of a glass/epoxy composite

The effect on the flexural properties of a glass/epoxy composite of immersion in deionized water or seawater at 0, 25, and 80 C for 451 hr was examined. The percent weight gain at 0 and 25 C was low (0.06 to 0.17 percent) and there was no significant change in the flexural properties for these environmental conditions. At 80 C there was a decrease in the flexural strength of 17 and 20 percent in seawater and deionized water, respectively. This is a comparison to control samples exposed to 80 C heat alone. These decreases were found to be nearly reversible once the samples were dried. Optical microscopy did not reveal cracking of the matrix. The flexural modulus was essentially unaffected by exposure to deionized water and seawater at 80 C

Dynamic model of fiber bundles

A realistic continuous-time dynamics for fiber bundles is introduced and studied both analytically and numerically. The equation of motion reproduces known stationary-state results in the deterministic limit while the system under non-vanishing stress always breaks down in the presence of noise. Revealed in particular is the characteristic time evolution that the system tends to resist the stress for considerable time, followed by sudden complete rupture. The critical stress beyond which the complete rupture emerges is also obtained