11,387 research outputs found
System overview on electromagnetic compensation for reflector antenna surface distortion
The system requirements and hardware implementation for electromagnetic compensation of antenna performance degradations due to thermal effects was investigated. Future commercial space communication antenna systems will utilize the 20/30 GHz frequency spectrum and support very narrow multiple beams (0.3 deg) over wide angle field of view (15-20 beamwidth). On the ground, portable and inexpensive very small aperture terminals (VSAT) for transmitting and receiving video, facsimile and data will be employed. These types of communication system puts a very stringent requirement on spacecraft antenna beam pointing stability (less than .01 deg), high gain (greater than 50 dB) and very lowside lobes (less than -25 dB). Thermal analysis performed on the advanced communication technology satellite (ACTS) has shown that the reflector surfaces, the mechanical supporting structures and metallic surfaces on the spacecraft body will distort due thermal effects from a varying solar flux. The antenna performance characteristics (e.g., pointing stability, gain, side lobe, etc.) will degrade due to thermal distortion in the reflector surface and supporting structures. Specifically, antenna RF radiation analysis has shown that pointing error is the most sensitive antenna performance parameter to thermal distortions. Other antenna parameters like peak gain, cross polarization level (beam isolation), and side lobe level will also degrade with thermal distortions. In order to restore pointing stability and in general antenna performance several compensation methods were proposed. In general these compensation methods can be classified as being either of mechanical or electromagnetic type. This paper will address only the later one. In this approach an adaptive phased array antenna feed is used to compensate for the antenna performance degradation. Extensive work has been devoted to demonstrate the feasibility of adaptive feed compensation on space communication antenna systems. This paper addresses the system requirements for such a system and identify candidate technologies (analog and digital) for possible hardware implementation
Theta Graph Designs
We solve the design spectrum problem for all theta graphs with 10, 11, 12, 13, 14 and 15 edges
Copolyimide with a combination of flexibilizing groups
Copolyimides are prepared by reacting one or more aromatic dianhydrides with a meta-substituted phenylene diamine and an aromatic bridged diamine. The incorporation of meta-substituted phenylene diamine derived units and bridged aromatice diamine derived units into the linear aromatic polymer backbone results in a copolyimide of improved flexibility, processability, and melt-flow characteristics. The copolyimides are especially useful as thermoplastic hot-melt adhesives
A simple nearest-neighbor two-body Hamiltonian system for which the ground state is a universal resource for quantum computation
We present a simple quantum many-body system - a two-dimensional lattice of
qubits with a Hamiltonian composed of nearest-neighbor two-body interactions -
such that the ground state is a universal resource for quantum computation
using single-qubit measurements. This ground state approximates a cluster state
that is encoded into a larger number of physical qubits. The Hamiltonian we use
is motivated by the projected entangled pair states, which provide a
transparent mechanism to produce such approximate encoded cluster states on
square or other lattice structures (as well as a variety of other quantum
states) as the ground state. We show that the error in this approximation takes
the form of independent errors on bonds occurring with a fixed probability. The
energy gap of such a system, which in part determines its usefulness for
quantum computation, is shown to be independent of the size of the lattice. In
addition, we show that the scaling of this energy gap in terms of the coupling
constants of the Hamiltonian is directly determined by the lattice geometry. As
a result, the approximate encoded cluster state obtained on a hexagonal lattice
(a resource that is also universal for quantum computation) can be shown to
have a larger energy gap than one on a square lattice with an equivalent
Hamiltonian.Comment: 5 pages, 1 figure; v2 has a simplified lattice, an extended analysis
of errors, and some additional references; v3 published versio
An experimental study of pressures on 60 deg Delta wings with leading edge vortex flaps
An experimental study was conducted in the Virginia Tech Stability Wind Tunnel to determine surface pressures over a 60 deg sweep delta wing with three vortex flap designs. Extensive pressure data was collected to provide a base data set for comparison with computational design codes and to allow a better understanding of the flow over vortex flaps. The results indicated that vortex flaps can be designed which will contain the leading edge vortex with no spillage onto the wing upper surface. However, the tests also showed that flaps designed without accounting for flap thickness will not be optimum and the result can be oversized flaps, early flap vortex reattachment and a second separation and vortex at the wing/flap hinge line
Pressure investigation of NASA leading edge vortex flaps on a 60 deg Delta wing
Pressure distributions on a 60 deg Delta Wing with NASA designed leading edge vortex flaps (LEVF) were found in order to provide more pressure data for LEVF and to help verify NASA computer codes used in designing these flaps. These flaps were intended to be optimized designs based on these computer codes. However, the pressure distributions show that the flaps wre not optimum for the size and deflection specified. A second drag-producing vortex forming over the wing indicated that the flap was too large for the specified deflection. Also, it became apparent that flap thickness has a possible effect on the reattachment location of the vortex. Research is continuing to determine proper flap size and deflection relationships that provide well-behaved flowfields and acceptable hinge-moment characteristics
Closed-drift thruster investigations
Recent data obtained from a second generation closed-drift thruster design, employing Hall current acceleration is outlined. This type device is emphasized for electric propulsion for geocentric mission applications. Because geocentric mission profiles are best achieved with a specific impulse range of 1000 to 2000 s, closed-drift thrusters are well suited for this application, permitting time payload compromises intermediate of those possible with either electrothermal or electrostatic devices. A discussion is presented of the potential advantages of using a 1000 to 2000 s device for one way orbit raising of nonpower payloads. Because closed-drift thruster operation is not space charge limited, and requires only one power circuit for steady state operation, their application is technically advantageous. Beam, plasma and thrust characteristics are detailed for a range of operating conditions
Marine crude-oil biodegradation: a central role for interspecies interactions
The marine environment is highly susceptible to pollution by petroleum, and so it is important to understand how microorganisms degrade hydrocarbons, and thereby mitigate ecosystem damage. Our understanding about the ecology, physiology, biochemistry and genetics of oil-degrading bacteria and fungi has increased greatly in recent decades; however, individual populations of microbes do not function alone in nature. The diverse array of hydrocarbons present in crude oil requires resource partitioning by microbial populations, and microbial modification of oil components and the surrounding environment will lead to temporal succession. But even when just one type of hydrocarbon is present, a network of direct and indirect interactions within and between species is observed. In this review we consider competition for resources, but focus on some of the key cooperative interactions: consumption of metabolites, biosurfactant production, provision of oxygen and fixed nitrogen. The emphasis is largely on aerobic processes, and especially interactions between bacteria, fungi and microalgae. The self-construction of a functioning community is central to microbial success, and learning how such " microbial modules" interact will be pivotal to enhancing biotechnological processes, including the bioremediation of hydrocarbons. © 2012 McGenity et al.; licensee BioMed Central Ltd
- …