Filling the Ranks: Manpower in the Canadian Expeditionary Force, 1914-1918 (Book Review) by Richard Holt

Review of Filling the Ranks: Manpower in the Canadian Expeditionary Force, 1914-1918 by Richard Holt

Determination of optimum sunlight concentration level in space for 3-5 cascade solar cells

The optimum range of concentration levels in space for III-V cascade cells was calculated using a realistic solar cell diode equation. Temperature was varied with concentration using several models and ranged from 55 C at 1 sun to between 80 and 200 C at 100 suns. A variety of series resistance and internal resistances were used. Coefficients of the diffusion and recombination terms are strongly temperature dependent. The study indicates that the maximum efficiency of 30 percent occurs in the 50 to 100 sun concentration range provided series resistance is below 0.015 ohm-sq cm and cell temperature is about 80 C at 100 suns

Effect of atmospheric parameters on silicon cell performance

The effects of changing atmospheric parameters on the performance of a typical silicon solar cell were calculated. The precipitable water vapor content, airmass and turbidity were varied over wide ranges and the normal terrestrial distribution of spectral irradiance was studied. The cell short-circuit current was then computed for each spectral irradiance distribution using the cell spectral response. Data are presented in the form of calibration number (cell current/incident irradiance) vs. water vapor content or turbidity

Results of module electrical measurement of the DOE 46-kilowatt procurement

Current-voltage measurements have been made on terrestrial solar cell modules of the DOE/JPL Low Cost Silicon Solar Array procurement. Data on short circuit current, open circuit voltage, and maximum power for the four types of modules are presented in normalized form, showing distribution of the measured values. Standard deviations from the mean values are also given. Tests of the statistical significance of the data are discussed

Galactic cosmic ray heavy primary secondary doses

Results of a calculation which estimates the heavy primary secondary doses from cosmic ray interaction data are reported. The incident galactic cosmic ray heavy primary spectrum is represented as the sum of helium, nitrogen, magnesium, and iron components. The incident iron nuclei are allowed to fragment into lesser Z secondaries, which are assumed to travel in the same direction and start with the same energy per nucleon as the interacting primary. The total emergent particle energy spectra and dose are then presented for the galactic heavy primary spectrum incident on aluminum and tissue slabs. The importance of the fragmentation parameters assumed is also evaluated. The total dose from the heavy primaries and their secondaries is found to be reduced by only a factor of two in 20 g/sq cm of shielding

A study of radiation environment in space and its biological effects

Biological effects on man in space resulting from galactic and solar cosmic radiation are discussed. Importance of secondary ions which contribute to galactic cosmic radiation hazards is analyzed. Mathematical model to show rate of production of secondary ions of given atomic number at various points in absorber is presented

Operational performance of a low cost, air mass 2 solar simulator

Modifications and improvements on a low cost air mass 2 solar simulator are discussed. The performance characteristics of total irradiance, uniformity of irradiance, spectral distribution, and beam subtense angle are presented. The simulator consists of an array of tungsten halogen lamps hexagonally spaced in a plane. A corresponding array of plastic Fresnel lenses shapes the output beam such that the simulator irradiates a 1.2 m by 1.2 m area with uniform collimated irradiance. Details are given concerning individual lamp output measurements and placement of the lamps. Originally, only the direct component of solar irradiance was simulated. Since the diffuse component may affect the performance of some collectors, the capability to simulate it is being added. An approach to this diffuse addition is discussed