11 research outputs found
Effective stress analysis and set-up for shaft capacity of piles in clay
ABSTRACT A case history of repeated dynamic and static loading tests in Alberta on two pipe piles during dissipation of driving-induced pore pressures is presented together with three reanalyzed published case histories involving similar records. The four case histories demonstrate that, for each case, the same effective-stress proportionality coefficients, beta-coefficients, fit the capacities at different degrees of dissipation of excess pore pressures. For two of the test sites, the beta-coefficients back-calculated from the tests differed considerable from the values determined from the soil plasticity relation, while for two, the agreement is good. For one case, the backcalculated shaft resistance agreed well with the values of vane shear strength, while a less good agreement was found for the other tests. Neither case showed good agreement was found for methods combining undrained shear strength and effective overburden stress. Capacity calculations for two cases employing methods based on CPT soundings gave excellent agreement with one test and a poor agreement with the other. The increase of capacity due to aging after dissipation of excess pore pressures did not agree with cited recommendation for calculations of aging effect
Recommended from our members
Metallic Fuel Casting Development and Parameter Optimization Simulations
One of the advantages of metallic fuel is the abilility to cast the fuel slugs to near net shape with little additional processing. However, the high aspect ratio of the fuel is not ideal for casting. EBR-II fuel was cast using counter gravity injection casting (CGIC) but, concerns have been raised concerning the feasibility of this process for americium bearing alloys. The Fuel Cycle Research and Development program has begun developing gravity casting techniques suitable for fuel production. Compared to CGIC gravity casting does not require a large heel that then is recycled, does not require application of a vacuum during melting, and is conducive to re-usable molds. Development has included fabrication of two separate benchscale, approximately 300 grams, systems. To shorten development time computer simulations have been used to ensure mold and crucible designs are feasible and to identify which fluid properties most affect casting behavior and therefore require more characterization
Internal state variable plasticity-damage modeling of the copper tee-shaped tube hydroforming process
This paper presents a parametric finite element analysis using a history-dependent internal state variable model for a hydroforming process. Experiments were performed for the internal state variable model correlation and for validating a 2-in. copper tee hydroforming process simulation. The material model constants were determined from uniaxial stress-strain responses obtained from tensile tests on the tube\u27s material. In the finite element simulations, the mesh and boundary conditions were integrated with the geometry and process parameters currently used in industry. The study provides insights for the variation of different process parameters (velocity and pressure profiles, and bucking system characteristics) related to the finished product. © 2010 Elsevier B.V