Shifting of the magnetic resonance peak to lower energy in the superconducting state of underdoped YBa_2Cu_3O_{6.8}

Inelastic neutron scattering has been used to determine the dynamic spin fluctuations in an underdoped high temperature superconductor YBCO_{6.8} single crystal. The magnetic resonance, that occurs around 40 meV in overdoped samples, is shifted to a lower energy, E_r= 34 meV. A constant ratio, $E_r/ k_B T_C= 4.9 \pm 0.2$, almost independent of the doping level, is found. According to numerous theoretical approaches, this finding supports the idea that the resonance energy is proportional (approximately twice) to the superconducting gap.Comment: 8 pages, 3 figures, accepted in Europhysics Lette

CHARACTERIZATION OF THE 105 K SUPERCONDUCTOR Tl2Ba2CaCu208 ("2212")

International audienceHomogeneous Tl1.8Ba2CaCu208 ceramics were synthesized by a novel route, starting from Tl2Ba205 precursors and using high gas pressures. This method allows tight control of thallium losses, resulting in dense, large-grained samples with sharp superconducting transitions above 105 K. Results of a characterization by X-ray diffraction, optical micrographs and micro-probe analysis are presented, together with selected physical properties

Preparation of pure Tl2Ba2CuO6+x: the contribution of phase equilibrium studies

International audienceThe formation of the pure thallium-based cuprate Tl2Ba2CuO6+x (2201) using a convenient process in the ternary TIO1.5-BaO-CuO phase diagram is described. This process is based on the congruent formation of the oxide Tl2Ba2O5 to which CuO is mixed, constituting a quasi-binary system. In the resulting 2201 compound no trace of the main poisoning magnetic impurity BaCuO2 could be detected by AC susceptibility measurements. The orthorhombic to tetragonal transformation is asserted to be due to thallium deficiency which occurs during the heat treatments at a temperature depending on the oxygen partial pressure

Estimation of urban sensible heat flux using a dense wireless network of observations

The determination of the sensible heat flux over urban terrain is challenging due to irregular surface geometry and surface types. To address this, in 2006-07, a major field campaign (LUCE) took place at the École Polytechnique Fédérale de Lausanne campus, a moderately occupied urban site. A distributed network of 92 wireless weather stations was combined with routine atmospheric profiling, offering high temporal and spatial resolution meteorological measurements. The objective of this study is to estimate the sensible heat flux over the built environment under convective conditions. Calculations were based on Monin-Obukhov similarity for temperature in the surface layer. The results illustrate a good agreement between the sensible heat flux inferred from the thermal roughness length approach and independent calibrated measurements from a scintillometer located inside the urban canopy. It also shows that using only one well-selected station can provide a good estimate of the sensible heat flux over the campus for convective conditions. Overall, this study illustrates how an extensive network of meteorological measurements can be a useful tool to estimate the sensible heat flux in complex urban environment

An AC susceptometer for the characterization of large, bulk superconducting samples

The main purpose of this work was to design, develop and construct a simple, low-cost AC susceptometer to measure large, bulk superconducting samples (up to 32 mm in diameter) in the temperature range 78-120 K. The design incorporates a double heating system that enables a high heating rate (25 K/hour) while maintaining a small temperature gradient (< 0.2 K) across the sample. The apparatus can be calibrated precisely using a copper coil connected in series with the primary coil. The system has been used successfully to measure the temperature dependence of the AC magnetic properties of entire RE-Ba-Cu-O [(RE)BCO] bulk superconducting domains. A typical AC susceptibility measurement run from 78 K to 95 K takes about 2 hours, with excellent temperature resolution (temperature step ~ 4 mK) around the critical temperature, in particular.Comment: 25 pages, 7 figures. Accepted for publication in Measurement Science and Technolog

Reversible magnetization below Tc in high-quality superconducting ceramics

International audienceWe have investigated the reversible magnetization below Tc in high-quality YBa2Cu307_d (Y-123), YBa2Cu4Os (Y-124), Y2Ba4Cu7O15+x (Y-247) and Bi2Sr2CaCu2O8+x (Bi-2212), Tl2Ba2Cu106+d (Tl-2201) and Tl2Ba2CalCu2O8+d (T1-2212) ceramics. Except for the stoichiometric Y-124 phase, the oxygen concentration was optimized in order to obtain the highest value of the critical temperature for which the normal-state susceptibility becomes temperature independent. Using the simple London model, we are able to fit the reversible magnetization M(T, H) outside the region near Tc with good accuracy for the nearly three-dimensional YBaCuO phases. For the very anisotropic BiSrCaCuO and TlBaCaCuO phases, we have to include an additional term to take into account the fluctuations of vortices. An important result is that Y-123 exhibits a critical field clearly higher than those of the BiSrCaCuO or TlBaCaCuO phases. We obtain for the Y-123 phase a slope at Tc μodHC2,C/dT = -4.3 T/K and an extrapolated μoHC2,C (0) = 280 T

Estimation of urban sensible heat flux using a dense wireless network of observations

The determination of the sensible heat flux over urban terrain is challenging due to irregular surface geometry and surface types. To address this, in 2006–07, a major field campaign (LUCE) took place at the École Polytechnique Fédérale de Lausanne campus, a moderately occupied urban site. A distributed network of 92 wireless weather stations was combined with routine atmospheric profiling, offering high temporal and spatial resolution meteorological measurements. The objective of this study is to estimate the sensible heat flux over the built environment under convective conditions. Calculations were based on Monin–Obukhov similarity for temperature in the surface layer. The results illustrate a good agreement between the sensible heat flux inferred from the thermal roughness length approach and independent calibrated measurements from a scintillometer located inside the urban canopy. It also shows that using only one well-selected station can provide a good estimate of the sensible heat flux over the campus for convective conditions. Overall, this study illustrates how an extensive network of meteorological measurements can be a useful tool to estimate the sensible heat flux in complex urban environments

ULTRASONIC ATTENUATION AND OCCURENCE OF THE MARTENSITIC TRANSFORMATION IN THE HIGH Tc A15 COMPOUND V3Si

The [100] shear modulus C44 is known to be nearly temperature independent in the case of V3Si, an extensively studied compound for wich many authors tried to associate the lattice instability and the high superconducting transition temperature. We report new sound velocity and attenuation measurements of this [100] shear mode. The temperature change of the sound velocity displays a 6 % relative decrease while a large increase in the attenuation of this mode occurs for T decreasing from 80 K to Tc = 17 K. This new observation gives a strong support for a very recently proposed approach to the occurence of the structural transformation in V3Si

Back to the A15 instability problems

Recent experimental results obtained on A15 compounds allow a better understanding of the correlation between superconductivity and lattice instability in this system. The effect of the lattice distortion is shown to reduce the superconducting transition T c. An enhancement of Tc in the case of V3Si is obtained when the temperature of the martensitic transition is lowered (by pressure or defects). Theoretically, these effects are well explained and predictable within the frame work of the band Jahn-Teller « models »; then also give more arguments in favour of these models.De récents résultats expérimentaux sur les composés A15 permettent une meilleure compréhension de la relation entre la supraconductivité et l'instabilité de réseau dans ce système. L'effet de la déformation structurale est de réduire la température de transition supraconductrice Tc. Une augmentation de Tc, dans le cas de V 3 Si, est obtenue lorsque la température de la transition structurale est abaissée (par effet de pression ou de défauts). 11 est possible, d'un point de vue théorique, de comprendre et de prévoir ces effets dans le cadre des modèles Jahn-Teller de bandes, ce qui donne des arguments supplémentaires en faveur de ce mécanisme