Experimental study of the normal zone propagation velocity in double-layer 2G-HTS wires by thermal and electrical methods

The Normal Zone Propagation Velocity (NZPV) of a double-layer second generation (2G) high temperature superconducting (HTS) wire manufactured by American Superconductor has been measured by electrical and thermal methods, and the results have been compared and discussed. The NZPV values determined by the voltage traces are ranging from 3.8 mm/s at 0.4 Ic to 19.2 mm/s at 0.9 Ic; while from 5.9 mm/s to 18.3 mm/s by the temperature traces. NZPV determined by these two approaches agrees well with each other. Also, NZPV of double-layer YBCO tape is close to that of conventional single-layer superconducting tape.This work was supported in part by the EPSRC under Grant NMZF/064.This is the accepted manuscript. The final version is available from IEEE at http://ieeexplore.ieee.org/xpl/articleDetails.jsp?arnumber=6963291&sortType%3Dasc_p_Sequence%26filter%3DAND%28p_IS_Number%3A6353170%29%26rowsPerPage%3D50

Defining the gap between research and practice in public relations programme evaluation - towards a new research agenda

The current situation in public relations programme evaluation is neatly summarized by McCoy who commented that 'probably the most common buzzwords in public relations in the last ten years have been evaluation and accountability' (McCoy 2005, 3). This paper examines the academic and practitioner-based literature and research on programme evaluation and it detects different priorities and approaches that may partly explain why the debate on acceptable and agreed evaluation methods continues. It analyses those differences and proposes a research agenda to bridge the gap and move the debate forward

Interactive effects between carbon allotrope fillers on the mechanical reinforcement of polyisoprene based nanocomposites

Interactive effects of carbon allotropes on the mechanical reinforcement of polymer nanocomposites were investigated. Carbon nanotubes (CNT) and nano-graphite with high shape anisotropy (nanoG) were melt blended with poly(1,4- cis-isoprene), as the only fillers or in combination with carbon black (CB), measuring the shear modulus at low strain amplitudes for peroxide crosslinked composites. The nanofiller was found to increase the low amplitude storage modulus of the matrix, with or without CB, by a factor depending on nanofiller type and content. This factor, fingerprint of the nanofiller, was higher for CNT than for nanoG. The filler-polymer interfacial area was able to correlate modulus data of composites with CNT, CB and with the hybrid filler system, leading to the construction of a common master curve. © BME-PT

An Overview of Flux Pumps for HTS Coils

High-Tc superconducting (HTS) flux pumps are capable of injecting flux into closed HTS magnets without electrical contact. It is becoming a promising alternative of current source in powering HTS coils. This paper reviews the recent progress in flux pumps for HTS coil magnets. Different types of HTS flux pumps are introduced. The physics of these flux pumps are explained and comparisons are made.J. Geng would like to acknowledge Cambridge Trust for offering Cambridge International Scholarship to support his study in Cambridge

Sceptical Employees as CSR Ambassadors in Times of Financial Uncertainty

This chapter offers new insights into the understanding of internal (employee) perceptions of organizational corporate social responsibility (CSR) policies and strategies. This study explores the significance of employees’ involvement and scepticism upon CSR initiatives and focuses on the effects it may have upon word of mouth (WOM) and the development of employee–organisation relationships. Desk research introduces the research questions. Data for the research questions were gathered through a self-completion questionnaire distributed in a hardcopy form to the sample. An individual’s level of scepticism and involvement appears to affect the development of a positive effect on employees’ WOM. Involvement with the domain of the investment may be a central factor affecting relationship building within the organization, and upon generation of positive WOM. The chapter offers a conceptual framework to public relations (PR) and corporate communications practitioners, which may enrich their views and understanding of the use and value of CSR for communication strategies and practices. For-profit organisations are major institutions in today’s society. CSR is proffered as presenting advantages for (at macro level) society and (micro level) the organization and its employees. Concepts, such as involvement and scepticism, which have not been rigorously examined in PR and corporate communication literature, are addressed. By examining employee perceptions, managers and academic researchers gain insights into the acceptance, appreciation and effectiveness of CSR policies and activities upon the employee stakeholder group. This will affect current and future CSR communication strategies. The knowledge acquired from this chapter may be transferable outside the for-profit sector

Flexible growing rods: a pilot study to determine if polymer rod constructs may provide stability to skeletally immature spines

Abstract Background Surgical treatments for early onset scoliosis (EOS), including growing rod constructs, involve many complications. Some are due to biomechanical factors. A construct that is more flexible than current instrumentation systems may reduce complications. The purpose of this preliminary study was to determine spine range of motion (ROM) after implantation of simulated growing rod constructs with a range of clinically relevant structural properties. The hypothesis was that ROM of spines instrumented with polyetheretherketone (PEEK) rods would be greater than metal rods and lower than noninstrumented controls. Further, adjacent segment motion was expected to be lower with polymer rods compared to conventional systems. Methods Biomechanical tests were conducted on 6 skeletally immature porcine thoracic spines (domestic swine, 35-40 kg). Spines were harvested after death from swine that had been utilized for other studies (IACUC approved) which had not involved the spine. Paired pedicle screws were used as anchors at proximal and distal levels. Specimens were tested under the following conditions: control, then dual rods of PEEK (6.25 mm), titanium (4 mm), and CoCr (5 mm) alloy. Lateral bending (LB) and flexion-extension (FE) moments of ±5 Nm were applied. Vertebral rotations were measured using video. Differences were determined by two-tailed t-tests and Bonferroni correction with four primary comparisons: PEEK vs control and PEEK vs CoCr, in LB and FE (α=0.05/4). Results In LB, ROM of specimens with PEEK rods was lower than control at each instrumented level. ROM was greater for PEEK rods than both Ti and CoCr at every instrumented level. Mean ROM at proximal and distal noninstrumented levels was lower for PEEK than for Ti and CoCr. In FE, mean ROM at proximal and distal noninstrumented levels was lower for PEEK than for metal. Combining treated levels, in LB, ROM for PEEK rods was 35% of control (p<0.0001) and 270% of CoCr rods (p<0.01). In FE, ROM with PEEK was 27% of control (p<0.001) and 180% of CoCr (p<0.01). Conclusions PEEK rods decreased flexibility versus noninstumented controls, and increased flexibility versus metal rods. Smaller increases in ROM at proximal and distal adjacent motion segments occurred with PEEK compared to metal rods, which may help decrease junctional kyphosis. Flexible growing rods may eventually help improve treatment options for young patients with severe deformity.http://deepblue.lib.umich.edu/bitstream/2027.42/134537/1/13013_2015_Article_967.pd

Bulk high-Tc superconductors with drilled holes: how to arrange the holes to maximize the trapped magnetic flux ?

Drilling holes in a bulk high-Tc superconductor enhances the oxygen annealing and the heat exchange with the cooling liquid. However, drilling holes also reduces the amount of magnetic flux that can be trapped in the sample. In this paper, we use the Bean model to study the magnetization and the current line distribution in drilled samples, as a function of the hole positions. A single hole perturbs the critical current flow over an extended region that is bounded by a discontinuity line, where the direction of the current density changes abruptly. We demonstrate that the trapped magnetic flux is maximized if the center of each hole is positioned on one of the discontinuity lines produced by the neighbouring holes. For a cylindrical sample, we construct a polar triangular hole pattern that exploits this principle; in such a lattice, the trapped field is ~20% higher than in a squared lattice, for which the holes do not lie on discontinuity lines. This result indicates that one can simultaneously enhance the oxygen annealing, the heat transfer, and maximize the trapped field

Scanning Tunneling Spectroscopy in MgB2

We present scanning tunneling microscopy measurements of the surface of superconducting MgB2 with a critical temperature of 39K. In zero magnetic field the conductance spectra can be analyzed in terms of the standard BCS theory with a smearing parameter Gamma. The value of the superconducting gap is 5.2 meV at 4.2 K, with no experimentally significant variation across the surface of the sample. The temperature dependence of the gap follows the BCS form, fully consistent with phonon-mediated superconductivity in this novel superconductor. The application of a magnetic field induces strong pair-breaking as seen in the conductance spectra in fields up to 6 T.Comment: 4 pages, 4 figure

Large well-relaxed models of vitreous silica, coordination numbers and entropy

A Monte Carlo method is presented for the simulation of vitreous silica. Well-relaxed networks of vitreous silica are generated containing up to 300,000 atoms. The resulting networks, quenched under the BKS potential, display smaller bond-angle variations and lower defect concentrations, as compared to networks generated with molecular dynamics. The total correlation functions T(r) of our networks are in excellent agreement with neutron scattering data, provided that thermal effects and the maximum inverse wavelength used in the experiment are included in the comparison. A procedure commonly used in experiments to obtain coordination numbers from scattering data is to fit peaks in rT(r) with a gaussian. We show that this procedure can easily produce incorrect results. Finally, we estimate the configurational entropy of vitreous silica.Comment: 7 pages, 4 figures (two column version to save paper