45 research outputs found
Validation of finite-element models of persistent-current effects in Nb3Sn accelerator magnets
Persistent magnetization currents are induced in superconducting filaments during the current ramping in magnets. The resulting perturbation to the design magnetic field leads to field quality degradation, particularly at low field, where the effect is stronger relative to the main field. The effects observed in NbTi accelerator magnets were reproduced well with the critical-state model. However, this approach becomes less accurate for the calculation of the persistent-current effects observed in Nb Sn accelerator magnets. Here, a finite-element method based on the measured strand magnetization is validated using three state-of-the-art Nb Sn accelerator magnets featuring different subelement diameters, conductor critical currents, magnet designs, and test temperatures. The temperature dependence of the persistent-current effects is reproduced. Based on the validated model, the impact of conductor design on the persistent-current effects is discussed. The strengths, limitations, and possible improvements of the approach are also discussed. 3
The effect of residence time on the tensile properties of superelastic and thermal activated Ni-Ti orthodontic wires
Interstrand Coupling Properties of LARP High Gradient Quadrupole Cables in Response to Variations in Cable Design and Heat Treatment Condition
Microstructure, texture and mechanical properties of metastable beta titanium alloy Ti–5Al–3.5Mo–7.2V–3Cr
AC Loss and Contact Resistance in Nb3Sn Rutherford Cables With and Without a Stainless Steel Core
Modeling of transport AC losses in superconducting arrays carrying anti-parallel currents
Recommended from our members
Flux Creep in a Bi-2212 Rutherford Cable for Particle Accelerator Applications
Bi-2212 superconducting cables are being considered for use in the high field magnets needed for the next generation of particle accelerators. Magnetization in these cables and the decay of that magnetization lead to field error and field-error drift, respectively, which need to be compensated. To study this, a segment of the winding pack was extracted from a racetrack coil made from Bi-2212 Rutherford cable. Using a Hall probe measurement technique, we measured the response of the cable's magnetization and its magnetization decay to changes in the applied magnetic field. The effect of adjustments to the cycling of the magnetic field was studied, intended to simulate the preinjection cycles of an accelerator magnet. Three M vs. H loops were constructed by sweeping the magnetic field applied to the sample from 0 to 2.5 T, then to a preinjection field 'x' (where x = 0, 0.25, 0.75 T), and finally up to 1 T. The applied field was then held at 1 T for 1500 s, and the magnetization decay was measured. The decay was found to vary from 8% to 14% after 1500 s, depending on the preinjection field cycle