48,657 research outputs found
Fixture for environmental exposure of structural materials under compression load
A device for stressing a deformable material specimen consists of top plate and a bottom plate sandwiching a guide cylinder. The specimen is positioned on the bottom plate and attached to a load piston. Force is applied through the top plate into the guide cylinder. Once the specimen is loaded, the stress is maintained by tightening tie bolt nuts
Development and evaluation of scatterometer data processing algorithms
There are no author-identified significant results in this report
PIA update: Correlation analyses of mass spectra
The PIA instrument aboard the Giotto spacecraft (a time of flight spectrometer) has been presented elsewhere. The mass spectra used in this analysis were decoded and mass numbers assigned according to the presence of carbon and silver, using the global values for these elements in their spectral absence. The results presented here were obtained using a frequency of occurrence based on analysis which correlated how often mass numbers appear in the mass spectra and which mass numbers tend to occur together in the same spectra; no amplitude information is utilized. The data are presented as plots of mass vs coincident mass for different subsets of the PIA data set, with both axes having units of atomic mass. Frequency contours are plotted at approximately five percent contour intervals, relative to the maximum AMU occurrence in that plot. The plots presented are symmetrical about the matrix diagonal, i.e., every mass is coincident with itself in a given spectra
The massive binary population of the starburst cluster Westerlund 1
We present initial results from a long-baseline radial velocity survey for massive binaries in the cluster Westerlund 1. Four systems are examined: the dust-producing WC binary W239, the double-lined eclipsing binary W13, and the single-lined B0 supergiants W43a and W3003. Finally, the evolutionary implications for the population of massive stars in Westerlund 1 are discussed
Effects of method of loading and specimen configuration on compressive strength of graphite/epoxy composite materials
Three test schemes were examined for testing graphite/epoxy (Narmco T300/5208) composite material specimens to failure in compression, including an adaptation of the IITRI "wedge grip" compression fixture, a face-supported-compression fixture, and an end-loaded-coupon fixture. The effects of specimen size, specimen support arrangement and method of load transfer on compressive behavior of graphite/epoxy were investigated. Compressive stress strain, strength, and modulus data obtained with the three fixtures are presented with evaluations showing the effects of all test parameters, including fiber orientation. The IITRI fixture has the potential to provide good stress/strain data to failure for unidirectional and quasi-isotropic laminates. The face supported fixture was found to be the most desirable for testing + or - 45 s laminates
Decrease in the high energy X-ray flux from Cen XR-2. Search for X-rays from the large and small Magellanic clouds
High energy X ray sky survey data on decreased intensity of Cen XR-2, and X ray energy flux from Magellanic clouds - Mildura, Australia, October 15 and 24, 196
Rangeland biomass estimation demonstration
Because of their sensitivity to chlorophyll density, green leaf density, and leaf water density, two hand-held radiometers which have sensor bands coinciding with thematic mapper bands 3, 4, and 5 were used to calibrate green biomass to LANDSAT spectral ratios as a step towards using portable radiometers to speed up ground data acquisition. Two field reflectance panels monitored incoming radiation concurrently with sampling. Software routines were developed and used to extract data from uncorrected tapes of MSS data provided in NASA LANDSAT universal format. A LANDSAT biomass calibration curve estimated the range biomass over a four scene area and displayed this information spatially as a product in a format of use to ranchers. The regional biomass contour map is discussed
Radio detection of H2O in comet Bradfield (1974b)
Results of observations of comet Bradfield using the Haystack telescope are summarized with emphasis on the detection of the 1.35 cm emission line of water in the comet. The excitation of water and methyl cyanide in comets is briefly considered
Generalized Thermalization in an Integrable Lattice System
After a quench, observables in an integrable system may not relax to the
standard thermal values, but can relax to the ones predicted by the generalized
Gibbs ensemble (GGE) [M. Rigol et al., Phys. Rev. Lett. 98, 050405 (2007)]. The
GGE has been shown to accurately describe observables in various
one-dimensional integrable systems, but the origin of its success is not fully
understood. Here we introduce a microcanonical version of the GGE and provide a
justification of the GGE based on a generalized interpretation of the
eigenstate thermalization hypothesis, which was previously introduced to
explain thermalization of nonintegrable systems. We study relaxation after a
quench of one-dimensional hard-core bosons in an optical lattice. Exact
numerical calculations for up to 10 particles on 50 lattice sites (~10^10
eigenstates) validate our approach.Comment: 8 pages, 9 figures, as publishe
Product Development in the World Auto Industry
macroeconomics, auto industry, management efficiency, productivity
- …