2,226 research outputs found

    Safety considerations for fabricating lithium battery packs

    Get PDF
    Lithium cell safety is a major issue with both manufacturers and end users. Most manufacturers have taken great strides to develop the safest cells possible while still maintaining performance characteristics. The combining of lithium cells for higher voltages, currents, and capacities requires the fabricator of lithium battery packs to be knowledgable about the specific electrochemical system being used. Relatively high rate, spirally wound (large surface area) sulfur oxychloride cells systems, such as Li/Thionyl or Sulfuryl chloride are considered. Prior to the start of a design of a battery pack, a review of the characterization studies for the cells should be conducted. The approach for fabricating a battery pack might vary with cell size

    Dust Coagulation and Settling in Layered Protoplanetary Disks

    Get PDF
    Previous models of dust growth in protoplanetary disks considered either uniformly laminar or turbulent disks. This Letter explores how dust growth occurs in a layered protoplanetary disk in which the magnetorotational instability generates turbulence only in the surface layers of a disk. Two cases are considered: a completely laminar dead zone and a dead zone in which turbulence is ``stirred up'' from the MRI acting above. It is found that dust is depleted from high altitudes in layered disks faster than in those cases of a uniformly laminar or turblent disks. This is a result of the accelerated growth of particles in the turbulent regions and their storage in the lower levels where they escape energetic collisions which would result in disruption. Thus the regions of a protoplanetary disk above a dead zone would become rapidly depleted in small dust grains, whereas the outer regions, where the MRI is active throughout, will maintain a small dust poplulation at all heights due to the disruptive collisions and vertical mixing from turbulence. This structure is similar to that which has been inferred for disks around TW Hydra, GM Auriga, and CoKu Tau/4, which are depleted in dust close to the star, but are optically thick at larger heliocentric distances.Comment: 4 pages, 3 figures, accepted to ApJ Letter

    The Evolution of the Water Distribution in a Viscous Protoplanetary Disk

    Full text link
    (Abridged) Astronomical observations have shown that protoplanetary disks are dynamic objects through which mass is transported and accreted by the central star. Age dating of meteorite constituents shows that their creation, evolution, and accumulation occupied several Myr, and over this time disk properties would evolve significantly. Moreover, on this timescale, solid particles decouple from the gas in the disk and their evolution follows a different path. Here we present a model which tracks how the distribution of water changes in an evolving disk as the water-bearing species experience condensation, accretion, transport, collisional destruction, and vaporization. Because solids are transported in a disk at different rates depending on their sizes, the motions will lead to water being concentrated in some regions of a disk and depleted in others. These enhancements and depletions are consistent with the conditions needed to explain some aspects of the chemistry of chondritic meteorites and formation of giant planets. The levels of concentration and depletion, as well as their locations, depend strongly on the combined effects of the gaseous disk evolution, the formation of rapidly migrating rubble, and the growth of immobile planetesimals. We present examples of evolution under a range of plausible assumptions and demonstrate how the chemical evolution of the inner region of a protoplanetary disk is intimately connected to the physical processes which occur in the outer regions.Comment: 45 pages, 7 figures, revised for publication in Icaru

    Post-Impact Thermal Evolution of Porous Planetesimals

    Full text link
    Impacts between planetesimals have largely been ruled out as a heat source in the early Solar System, by calculations that show them to be an inefficient heat source and unlikely to cause global heating. However, the long-term, localized thermal effects of impacts on planetesimals have never been fully quantified. Here, we simulate a range of impact scenarios between planetesimals to determine the post-impact thermal histories of the parent bodies, and hence the importance of impact heating in the thermal evolution of planetesimals. We find on a local scale that heating material to petrologic type 6 is achievable for a range of impact velocities and initial porosities, and impact melting is possible in porous material at a velocity of > 4 km/s. Burial of heated impactor material beneath the impact crater is common, insulating that material and allowing the parent body to retain the heat for extended periods (~ millions of years). Cooling rates at 773 K are typically 1 - 1000 K/Ma, matching a wide range of measurements of metallographic cooling rates from chondritic materials. While the heating presented here is localized to the impact site, multiple impacts over the lifetime of a parent body are likely to have occurred. Moreover, as most meteorite samples are on the centimeter to meter scale, the localized effects of impact heating cannot be ignored.Comment: 38 pages, 9 figures, Revised for Geochimica et Cosmochimica Acta (Sorry, they do not accept LaTeX

    The Exoplanet Population Observation Simulator. I - The Inner Edges of Planetary Systems

    Full text link
    The Kepler survey provides a statistical census of planetary systems out to the habitable zone. Because most planets are non-transiting, orbital architectures are best estimated using simulated observations of ensemble populations. Here, we introduce EPOS, the Exoplanet Population Observation Simulator, to estimate the prevalence and orbital architectures of multi-planet systems based on the latest Kepler data release, DR25. We estimate that at least 42% of sun-like stars have nearly coplanar planetary systems with 7 or more exoplanets. The fraction of stars with at least one planet within 1 au could be as high as 100% depending on assumptions about the distribution of single transiting planets. We estimate an occurrence rate of planets in the habitable zone around sun-like stars of eta_earth=36+-14%. The innermost planets in multi-planet systems are clustered around an orbital period of 10 days (0.1 au), reminiscent of the protoplanetary disk inner edge or could be explained by a planet trap at that location. Only a small fraction of planetary systems have the innermost planet at long orbital periods, with fewer than ~8% and ~3% having no planet interior to the orbit of Mercury and Venus, respectively. These results reinforce the view that the solar system is not a typical planetary system, but an outlier among the distribution of known exoplanetary systems. We predict that at least half of the habitable zone exoplanets are accompanied by (non-transiting) planets at shorter orbital periods, hence knowledge of a close-in exoplanet could be used as a way to optimize the search for Earth-size planets in the Habitable Zone with future direct imaging missions.Comment: Accepted in AAS journals, code available on githu
    corecore