It's just a standard deviation!

postprin

Ghost in the machine

published_or_final_versio

The Efficacy and Clinical Safety of Various Analgesic Combinations for Post-Operative Pain after Third Molar Surgery: A Systematic Review and Meta-Analysis.

Objectives To run a systematic review and meta-analysis of randomized clinical trials aiming to answer the clinical question "which analgesic combination and dosage is potentially the most effective and safe for acute post-operative pain control after third molar surgery?". Materials and Methods A systematic search of computer databases and journals was performed. The search and the evaluations of articles were performed by 2 independent reviewers in 3 rounds. Randomized clinical trials related to analgesic combinations for acute post-operative pain control after lower third molar surgery that matched the selection criteria were evaluated to enter in the final review. Results Fourteen studies with 3521 subjects, with 10 groups (17 dosages) of analgesic combinations were included in the final review. The analgesic efficacy were presented by the objective pain measurements including sum of pain intensity at 6 hours (SPID6) and total pain relief at 6 hours (TOTPAR6). The SPID6 scores and TOTPAR6 scores of the reported analgesic combinations were ranged from 1.46 to 6.44 and 3.24 - 10.3, respectively. Ibuprofen 400mg with oxycodone HCL 5mg had superior efficacy (SPID6: 6.44, TOTPAR6: 9.31). Nausea was the most common adverse effect, with prevalence ranging from 0-55%. Ibuprofen 200mg with caffeine 100mg or 200mg had a reasonable analgesic effect with fewer side effects. Conclusion This systematic review and meta-analysis may help clinicians in their choices of prescribing an analgesic combination for acute post-operative pain control after lower third molar surgery. It was found in this systematic review Ibuprofen 400mg combined with oxycodone HCL 5mg has superior analgesic efficacy when compared to the other analgesic combinations included in this study.published_or_final_versio

Modelling the Interconnected Synchronous Generators and its State Estimations

© 2018 IEEE. In contrast to the traditional centralized power system state estimation approaches, this paper investigates the optimal filtering problem for distributed dynamic systems. Particularly, the interconnected synchronous generators are modeled as a state-space linear equation where sensors are deployed to obtain measurements. As the synchronous generator states are unknown, the estimation is required to know the operating conditions of large-scale power networks. Availability of the system states gives the designer an accurate picture of power networks to avoid blackouts. Basically, the proposed algorithm is based on the minimization of the mean squared estimation error, and the optimal gain is determined by exchanging information with their neighboring estimators. Afterward, the convergence of the developed algorithm is proved so that it can be applied to real-time applications in modern smart grids. Simulation results demonstrate the efficacy of the developed algorithm

Efficacy of Pregabalin in Acute Postoperative Pain Under Different Surgical Categories: a meta-analysis

published_or_final_versio

Reduction of Motion Artifacts and Improvement of R Peak Detecting Accuracy Using Adjacent Non-Intrusive ECG Sensors

Non-intrusive electrocardiogram (ECG) monitoring has many advantages: easy to measure and apply in daily life. However, motion noise in the measured signal is the major problem of non-intrusive measurement. This paper proposes a method to reduce the noise and to detect the R peaks of ECG in a stable manner in a sitting arrangement using non-intrusive sensors. The method utilizes two capacitive ECG sensors (cECGs) to measure ECG, and another two cECGs located adjacent to the sensors for ECG are added to obtain the information on motion. Then, active noise cancellation technique and the motion information are used to reduce motion noise. To verify the proposed method, ECG was measured indoors and during driving, and the accuracy of the detected R peaks was compared. After applying the method, the sum of sensitivity and positive predictivity increased 8.39% on average and 26.26% maximally in the data. Based on the results, it was confirmed that the motion noise was reduced and that more reliable R peak positions could be obtained by the proposed method. The robustness of the new ECG measurement method will elicit benefits to various health care systems that require noninvasive heart rate or heart rate variability measurements.1145Ysciescopu

Dimerization-Induced Fermi-Surface Reconstruction in IrTe2

We report a de Haas-van Alphen (dHvA) oscillation study on IrTe2 single crystals showing complex dimer formations. By comparing the angle dependence of dHvA oscillations with band structure calculations, we show distinct Fermi surface reconstruction induced by a 1/5-type and a 1/8-type dimerizations. This verifies that an intriguing quasi-two-dimensional conducting plane across the layers is induced by dimerization in both cases. A phase transition to the 1/8 phase with higher dimer density reveals that local instabilities associated with intra-and interdimer couplings are the main driving force for complex dimer formations in IrTe2.X11149sciescopu

Two-dimensional imaging of edge-localized modes in KSTAR plasmas unperturbed and perturbed by n=1 external magnetic fields

The temporal evolution of edge-localized modes (ELMs) has been studied using a 2-D electron cyclotron emission imaging system in the KSTAR tokamak. The ELMs are observed to evolve in three distinctive stages: the initial linear growth of multiple filamentary structures having a net poloidal rotation, the interim state of regularly spaced saturated filaments, and the final crash through a short transient phase characterized by abrupt changes in the relative amplitudes and distance among filaments. The crash phase, typically consisted of multiple bursts of a single filament, involves a complex dynamics, poloidal elongation of the bursting filament, development of a fingerlike bulge, and fast localized burst through the finger. Substantial alterations of the ELM dynamics, such as mode number, poloidal rotation, and crash time scale, have been observed under external magnetic perturbations with the toroidal mode number n = 1. (C) 2012 American Institute of Physics. [http://dx.doi.org/10.1063/1.3694842]X1125sciescopu