The role of surface chemical reactivity in the stability of electronic nanodevices based on two-dimensional materials "beyond graphene" and topological insulators

Here, we examine the influence of surface chemical reactivity toward ambient gases on the performance of nanodevices based on two-dimensional materials "beyond graphene" and novel topological phases of matter. While surface oxidation in ambient conditions was observed for silicene and phosphorene with subsequent reduction of the mobility of charge carriers, nanodevices with active channels of indium selenide, bismuth chalcogenides and transition-metal dichalcogenides are stable in air. However, air-exposed indium selenide suffers of p-type doping due to water decomposition on Se vacancies, whereas the low mobility of charge carriers in transition-metal dichalcogenides increases the response time of nanodevices. Conversely, bismuth chalcogenides require a control of crystalline quality, which could represent a serious hurdle for up scaling

Bismuth vanadate photoanodes for water splitting deposited by radio frequency plasma reactive co-sputtering

Photoactive bismuth vanadate (BiVO4) thin coatings were deposited on fluorine-doped tin oxide glass by plasma reactive sputtering from Bi2O3 and vanadium (V) radio frequency (RF) powered targets. The films were characterized by x-ray diffraction, scanning electron microscopy, energy dispersion spectroscopy, and UV-vis spectroscopy. The effects that the power density supplied to the Bi2O3 target, the post-annealing treatment, and the film thickness have on the structural features and on the photoelectrochemical (PEC) performances of the so obtained BiVO4 film-based photoelectrodes were investigated. Their PEC performance in water splitting was evaluated in a three-electrode cell by both incident photon to current efficiency (IPCE) and linear sweep voltammetry measurements under AM 1.5 G simulated solar light irradiation. A monoclinic phase of BiVO4, which is more photoactive than the tetragonal BiVO4 phase, was obtained by optimizing the power density supplied to the Bi2O3 target, i.e., by tuning the Bi:V:O atomic ratio. The best PEC performance was obtained for a stoichiometric 1:1 Bi:V atomic ratio, attained with 20 W power supplied at the Bi2O3 target and 300 W power supplied at the vanadium target, and an optimal 200 nm thickness of the BiVO4 film, with a 0.65 mA/cm2 photocurrent density attained at 1.23 V vs. standard calomel electrode, under simulated solar light. These results show the suitability of plasma reactive sputtering with two RF powered electrodes for the deposition of BiVO4 photoanodes for water splitting

Deep-well ultrafast manipulation of a SQUID flux qubit

Superconducting devices based on the Josephson effect are effectively used for the implementation of qubits and quantum gates. The manipulation of superconducting qubits is generally performed by using microwave pulses with frequencies from 5 to 15 GHz, obtaining a typical operating clock from 100MHz to 1GHz. A manipulation based on simple pulses in the absence of microwaves is also possible. In our system a magnetic flux pulse modifies the potential of a double SQUID qubit from a symmetric double well to a single deep well condition. By using this scheme with a Nb/AlOx/Nb system we obtained coherent oscillations with sub-nanosecond period (tunable from 50ps to 200ps), very fast with respect to other manipulating procedures, and with a coherence time up to 10ns, of the order of what obtained with similar devices and technologies but using microwave manipulation. We introduce the ultrafast manipulation presenting experimental results, new issues related to this approach (such as the use of a feedback procedure for cancelling the effect of "slow" fluctuations), and open perspectives, such as the possible use of RSFQ logic for the qubit control.Comment: 9 pages, 7 figure

Dynamics of Josephson junctions and single-flux-quantum networks with superconductor-insulator-normal metal junction shunts

Within the framework of the microscopic model of tunneling, we modelled the behavior of the Josephson junction shunted by the Superconductor-Insulator-Normal metal (SIN) tunnel junction. We found that the electromagnetic impedance of the SIN junction yields both the frequency-dependent damping and dynamic reactance which leads to an increase in the effective capacitance of the circuit. We calculated the dc I-V curves and transient characteristics of these circuits and explained their quantitative differences to the curves obtained within the resistively shunted junction model. The correct operation of the basic single-flux-quanta circuits with such SIN-shunted junctions, i.e. the Josephson transmission line and the toggle flip-flop, have also been modelled.Comment: 8 pages incl. 7 figure

Commissioning of the MEG II tracker system

The MEG experiment at the Paul Scherrer Institut (PSI) represents the state of the art in the search for the charged Lepton Flavour Violating (cLFV) $\mu^+ \rightarrow e^+ \gamma$ decay. With the phase 1, MEG set the new world best upper limit on the \mbox{BR}(\mu^+ \rightarrow e^+ \gamma) < 4.2 \times 10^{-13} (90% C.L.). With the phase 2, MEG II, the experiment aims at reaching a sensitivity enhancement of about one order of magnitude compared to the previous MEG result. The new Cylindrical Drift CHamber (CDCH) is a key detector for MEG II. CDCH is a low-mass single volume detector with high granularity: 9 layers of 192 drift cells, few mm wide, defined by $\sim 12000$ wires in a stereo configuration for longitudinal hit localization. The filling gas mixture is Helium:Isobutane (90:10). The total radiation length is $1.5 \times 10^{-3}$ \mbox{X}_0, thus minimizing the Multiple Coulomb Scattering (MCS) contribution and allowing for a single-hit resolution $< 120$ $\mu$m and an angular and momentum resolutions of 6 mrad and 90 keV/c respectively. This article presents the CDCH commissioning activities at PSI after the wiring phase at INFN Lecce and the assembly phase at INFN Pisa. The endcaps preparation, HV tests and conditioning of the chamber are described, aiming at reaching the final stable working point. The integration into the MEG II experimental apparatus is described, in view of the first data taking with cosmic rays and $\mu^+$ beam during the 2018 and 2019 engineering runs. The first gas gain results are also shown. A full engineering run with all the upgraded detectors and the complete DAQ electronics is expected to start in 2020, followed by three years of physics data taking.Comment: 10 pages, 12 figures, 1 table, proceeding at INSTR'20 conference, accepted for publication in JINS

Single-hit resolution measurement with MEG II drift chamber prototypes

Drift chambers operated with helium-based gas mixtures represent a common solution for tracking charged particles keeping the material budget in the sensitive volume to a minimum. The drawback of this solution is the worsening of the spatial resolution due to primary ionisation fluctuations, which is a limiting factor for high granularity drift chambers like the MEG II tracker. We report on the measurements performed on three different prototypes of the MEG II drift chamber aimed at determining the achievable single-hit resolution. The prototypes were operated with helium/isobutane gas mixtures and exposed to cosmic rays, electron beams and radioactive sources. Direct measurements of the single hit resolution performed with an external tracker returned a value of 110 $\mu$m, consistent with the values obtained with indirect measurements performed with the other prototypes.Comment: 18 pages, 18 figure

An Optimal Tunable Josephson Element for Quantum Computing

We introduce a three-junction SQUID that can be effectively used as an optimal tunable element in Josephson quantum computing applications. This device can replace the simple dc SQUID generally used as tunable element in this kind of applications, with a series of advantages for the coherence time and for the tolerance to small errors. We study the device both theoretically and experimentally at 4.2 K, obtaining a good agreement between the results.Comment: 3 pages, 4 figure