The biomechanics of Cornus canadensis stamens are ideal for catapulting pollen vertically

1.   Rapid movements in fungi and plants have evolved in different species to facilitate the dispersal of spores and seeds. The mechanisms of action can differ among species, but the effectiveness of these movements has rarely, if ever, been tested. Here we show through a quantitative biomechanical analysis that the stamens of Cornus canadensis L. (bunchberry) are ideal for catapulting pollen vertically at high speeds. 2.   We develop a biomechanical model to describe the explosive launch of pollen from the flowers of bunchberry. The model determines the equation of motion for the stamens based only on the morphology and measurements of the parts of the stamens. To measure the motion of the stamens to compare with our model, we analysed individual frames of a video taken at 10 000 fps. 3.   The thecae of adjacent stamens dehisce in bud so that the stomia face each other, retaining pollen between neighbouring anthers. As the flowers open, pollen is accelerated vertically as long as the thecae remain in contact. Pollen is released only when the anthers move horizontally and separate. 4.   The observed motion of the stamens matches the results from our model through release of the pollen. The model reveals that pollen release (horizontal movement of the anthers) occurs only after the vertical speed is at its maximum. Thus, for this particular catapult mechanism, the morphology of the stamens is optimal for launching light, dry pollen straight upwards at high speed. Pollen launched vertically at high speed both enhances insect pollination by helping to making pollen stick on visiting insects, and also allows for successful wind pollination by propelling pollen into the air column. Seed set by inflorescences in pollinator-exclosure cages further supports the ability of this flower to use wind as a pollination mechanism. Functional Ecology (2007) 21 , 219–225 doi: 10.1111/j.1365-2435.2007.01249.xPeer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/75735/1/j.1365-2435.2007.01249.x.pd

A century of trends in adult human height

Being taller is associated with enhanced longevity, and higher education and earnings. We reanalysed 1472 population-based studies, with measurement of height on more than 18.6 million participants to estimate mean height for people born between 1896 and 1996 in 200 countries. The largest gain in adult height over the past century has occurred in South Korean women and Iranian men, who became 20.2 cm (95% credible interval 17.5-22.7) and 16.5 cm (13.3-19.7) taller, respectively. In contrast, there was little change in adult height in some sub-Saharan African countries and in South Asia over the century of analysis. The tallest people over these 100 years are men born in the Netherlands in the last quarter of 20th century, whose average heights surpassed 182.5 cm, and the shortest were women born in Guatemala in 1896 (140.3 cm; 135.8-144.8). The height differential between the tallest and shortest populations was 19-20 cm a century ago, and has remained the same for women and increased for men a century later despite substantial changes in the ranking of countries

Rising rural body-mass index is the main driver of the global obesity epidemic in adults

Body-mass index (BMI) has increased steadily in most countries in parallel with a rise in the proportion of the population who live in cities 1,2 . This has led to a widely reported view that urbanization is one of the most important drivers of the global rise in obesity 3�6 . Here we use 2,009 population-based studies, with measurements of height and weight in more than 112 million adults, to report national, regional and global trends in mean BMI segregated by place of residence (a rural or urban area) from 1985 to 2017. We show that, contrary to the dominant paradigm, more than 55 of the global rise in mean BMI from 1985 to 2017�and more than 80 in some low- and middle-income regions�was due to increases in BMI in rural areas. This large contribution stems from the fact that, with the exception of women in sub-Saharan Africa, BMI is increasing at the same rate or faster in rural areas than in cities in low- and middle-income regions. These trends have in turn resulted in a closing�and in some countries reversal�of the gap in BMI between urban and rural areas in low- and middle-income countries, especially for women. In high-income and industrialized countries, we noted a persistently higher rural BMI, especially for women. There is an urgent need for an integrated approach to rural nutrition that enhances financial and physical access to healthy foods, to avoid replacing the rural undernutrition disadvantage in poor countries with a more general malnutrition disadvantage that entails excessive consumption of low-quality calories. © 2019, The Author(s)

Nociception in systemic inflammatory response: hyper- or hypoalgesia?

In experiments on male Wistar rats, the acute phase reaction was induced by a bolus intravenous injection of Escherichia coli lipopolysaccharide (10 microg/kg) through a silicon catheter pre-implanted into the jugular vein

Influences of nurses' scoring of children's postoperative pain

There is a lack of clarity as to why some nurses are not delivering optimal pain management to children post-operatively. This retrospective chart review study examined nurses’ pain scoring on 175 children during the first 24 hours post-operatively. Data were analysed on the amount of assessments made, assessment scores recorded, as well as the age, gender and type of surgery performed. One-quarter of children had no assessment record of their pain in the first 24 hours post-operatively. When the pain tool was part of an observation chart, nurses recorded more pain scores. Nurses’ scoring of children’s pain is influenced positively by children under five years of age and those who undergo abdominal surgery. Nurses who had access to one document for recording vital signs as well as pain scores were more likely to assess and record a child’s pain score than nurses who had to use a separate chart