Low energy proton radiation damage to (AlGa)As-GaAs solar cells

Twenty-seven 2 times 2 sq cm (AlGa)As-GaAs solar cells were fabricated and subjected to 50 keV, 100 keV, and 290 keV of proton irradiation along with eighteen high efficiency silicon solar cells. The results of the study further corroborate the advantages for space missions offered by GaAs cells over state of the art silicon cells. Thus, even though the GaAs cells showed greater degradation when irradiated by protons with energy less than 5 MeV, the solar cells were normally protected from these protons by the glass covers used in space arrays. The GaAs cells also offered superior end of life power capability compared with silicon. The change in the open circuit voltage, short circuit current, spectral response, and dark 1-5 characteristics after irradiation at each proton energy and fluence were found to be consistent with the explanation of the effect of the protons. Also dark 1-5 characteristics showed that a new recombination center dominates the current transport mechanism after irradiation

Medium energy proton radiation damage to (AlGa)As-GaAs solar cells

The performance of (AlGa)As-GaAs solar cells irradiated by medium energy 2, 5, and 10 MeV protons was evaluated. The Si cells without coverglass and a number of GaAs solar cells with 12 mil coverglass were irradiated simultaneously with bare GaAs cells. The cell degradation is directly related to the penetration of depth of protons with GaAs. The influence of periodic and continuous thermal annealing on the GaAs solar cells was investigated

GaAs solar cells for concentrator systems in space

Cells for operation in space up to more than 100 suns were made, and an AMO efficiency of 21% at 100 suns with these cells was obtained. The increased efficiency resulted not only from the higher open circuit voltage associated with the higher light intensity (higher short circuit current); it also benefitted from the increase in fill factor caused by the lower relative contribution of the generation recombination current to the forward bias current when the cell's operating current density is increased. The experimental cells exhibited an AMO efficiency close to 16% at 200 C. The prospect of exploiting this capability for the continuous annealing of radiation damage or for high temperature missions (e.g., near Sun missions) remains therefore open. Space systems with concentration ratios on the order of 100 suns are presently under development. The tradeoff between increased concentration ratio and increased loss due to the cell's series resistance remains attractive even for space applications at a solar concentrator ratio of 100 suns. In the design of contact configuration with low enough series resistance for such solar concentration ratios, the shallow junction depth needed for good radiation hardness and the thin AlGaAs layer thickness needed to avoid excessive optical absorption losses have to be retained

A binary signature in the non-thermal radio-emitter Cyg OB2 #9

Aims: Non-thermal radio emission associated with massive stars is believed to arise from a wind-wind collision in a binary system. However, the evidence of binarity is still lacking in some cases, notably Cyg OB2 #9 Methods: For several years, we have been monitoring this heavily-reddened star from various observatories. This campaign allowed us to probe variations both on short and long timescales and constitutes the first in-depth study of the visible spectrum of this object. Results: Our observations provide the very first direct evidence of a companion in Cyg OB2 #9, confirming the theoretical wind-wind collision scenario. These data suggest a highly eccentric orbit with a period of a few years, compatible with the 2yr-timescale measured in the radio range. In addition, the signature of the wind-wind collision is very likely reflected in the behaviour of some emission lines.Comment: accepted by A&A, 4 p, 3figure

Fabrication of high efficiency and radiation resistant GaAs solar cells

Systematic improvements in fabrication yield were obtained by appropriate control of the liquid phase epitaxial growth process, contact fabrication and surface preparation. To improve radiation hardness, the junction depth was decreased while overcoming the penalty in decreased solar cell efficiency which tends to go hand-in-hand with the reduction of junction depth in (AlGa) As-GaAs solar cells. Cells were made with an AMO efficiency of 18% and a junction depth of 0.5 micrometers, as compared to junction depths on the order of 1.0 micrometers. With respect to the damage caused by proton irradiation, the nature of the observed damage was correlated to the energy and penetration depth of the damaging protons

Adaptive Transmission Techniques for Mobile Satellite Links

Adapting the transmission rate in an LMS channel is a challenging task because of the relatively fast time variations, of the long delays involved, and of the difficulty in mapping the parameters of a time-varying channel into communication performance. In this paper, we propose two strategies for dealing with these impairments, namely, multi-layer coding (MLC) in the forward link, and open-loop adaptation in the return link. Both strategies rely on physical-layer abstraction tools for predicting the link performance. We will show that, in both cases, it is possible to increase the average spectral efficiency while at the same time keeping the outage probability under a given threshold. To do so, the forward link strategy will rely on introducing some latency in the data stream by using retransmissions. The return link, on the other hand, will rely on a statistical characterization of a physical-layer abstraction measure.Comment: Presented at the 30th AIAA International Communications Satellite Systems Conference (ICSSC), Ottawa, Canada, 2012. Best Professional Paper Awar

An automated method for comparing motion artifacts in cine four-dimensional computed tomography images.

The aim of this study is to develop an automated method to objectively compare motion artifacts in two four-dimensional computed tomography (4D CT) image sets, and identify the one that would appear to human observers with fewer or smaller artifacts. Our proposed method is based on the difference of the normalized correlation coefficients between edge slices at couch transitions, which we hypothesize may be a suitable metric to identify motion artifacts. We evaluated our method using ten pairs of 4D CT image sets that showed subtle differences in artifacts between images in a pair, which were identifiable by human observers. One set of 4D CT images was sorted using breathing traces in which our clinically implemented 4D CT sorting software miscalculated the respiratory phase, which expectedly led to artifacts in the images. The other set of images consisted of the same images; however, these were sorted using the same breathing traces but with corrected phases. Next we calculated the normalized correlation coefficients between edge slices at all couch transitions for all respiratory phases in both image sets to evaluate for motion artifacts. For nine image set pairs, our method identified the 4D CT sets sorted using the breathing traces with the corrected respiratory phase to result in images with fewer or smaller artifacts, whereas for one image pair, no difference was noted. Two observers independently assessed the accuracy of our method. Both observers identified 9 image sets that were sorted using the breathing traces with corrected respiratory phase as having fewer or smaller artifacts. In summary, using the 4D CT data of ten pairs of 4D CT image sets, we have demonstrated proof of principle that our method is able to replicate the results of two human observers in identifying the image set with fewer or smaller artifacts

Cooling is hotting up in the UK

The cooling of buildings is currently responsible for about 20% of total electricity use worldwide. It is estimated that the electricity needed for cooling will more than triple by 2050. Despite this concerning outlook, little attention has been paid to cooling demand in policy and research in the United Kingdom (UK). The demand for space cooling in the UK’s domestic and non-domestic buildings is currently small—about 10% of total electricity use. However, this has the potential to increase as the climate warms and expectations of comfort grow. This paper reviews UK cooling demand and how this has been considered in energy policy. Following a thorough review of the existing literature using a cooling decarbonisation framework (Avoid, Improve and Shift), it is clear there is a limited understanding of the future UK cooling demand for domestic buildings in a warmer future as well as how policy makers and households should act. More importantly, this sector appears under-represented in the UK research and policy landscape compared to heating despite obvious technological crossovers associated with electrification. Several policy and research recommendations have been made based on these findings