61 research outputs found

    Study on Morbidity and Mortality Rates in Buffaloes in Pune Division of Maharashtra State in India

    Get PDF
    The present study was carried out to analyse morbidity and mortality rate in buffaloes and its associated factors in Pune division of Maharashtra state in India. Stratified two stages random sampling design was adopted & the data of total 564 buffaloes were collected through pre-tested modified schedule from 157 buffalo owners. The data were analysed statistically by SAS 9.3 software for evaluation of Chi-square and Logistic regression analysis. Overall morbidity (28.01%) and mortality (7.98%) rates were recorded in study area. Digestive diseases and respiratory diseases are major cause of the higher morbidity and mortality in buffaloes, respectively. Statistically, there wasn't significant association of overall disease incidence with age or sex. However, the Chi-square analysis of overall mortality rate showed significance (p<0.01) difference among age and sex. Logistic regression analysis also suggested the same results. Mortality rates were recorded higher in calves and male buffaloes as compared to their respective counterparts. It is suggested that digestive and respiratory problems may be reduced by improving feeding and management practices. This study provides the important tool for determining the health status of buffaloes and has special importance in planning of prevention and control strategies designed to reduce the incidences of diseases in livestock and therefore economic status of farmers

    Mutant Prourokinase with Adjunctive C1-Inhibitor Is an Effective and Safer Alternative to tPA in Rat Stroke

    Get PDF
    A single-site mutant (M5) of native urokinase plasminogen activator (prouPA) induces effective thrombolysis in dogs with venous or arterial thrombosis with a reduction in bleeding complications compared to tPA. This effect, related to inhibition of two-chain M5 (tcM5) by plasma C1-inhibitor (C1I), thereby preventing non-specific plasmin generation, was augmented by the addition of exogenous C1I to plasma in vitro. In the present study, tPA, M5 or placebo +/− C1I were administered in two rat stroke models. In Part-I, permanent MCA occlusion was used to evaluate intracranial hemorrhage (ICH) by the thrombolytic regimens. In Part II, thromboembolic occlusion was used with thrombolysis administered 2 h later. Infarct and edema volumes, and ICH were determined at 24 h, and neuroscore pre (2 h) and post (24 h) treatment. In Part I, fatal ICH occurred in 57% of tPA and 75% of M5 rats. Adjunctive C1I reduced this to 25% and 17% respectively. Similarly, semiquantitation of ICH by neuropathological examination showed significantly less ICH in rats given adjunctive C1I compared with tPA or M5 alone. In Part-II, tPA, M5, and M5+C1I induced comparable ischemic volume reductions (>55%) compared with the saline or C1I controls, indicating the three treatments had a similar fibrinolytic effect. ICH was seen in 40% of tPA and 50% of M5 rats, with 1 death in the latter. Only 17% of the M5+C1I rats showed ICH, and the bleeding score in this group was significantly less than that in either the tPA or M5 group. The M5+C1I group had the best Benefit Index, calculated by dividing percent brain salvaged by the ICH visual score in each group. In conclusion, adjunctive C1I inhibited bleeding by M5, induced significant neuroscore improvement and had the best Benefit Index. The C1I did not compromise fibrinolysis by M5 in contrast with tPA, consistent with previous in vitro findings

    Corrosion Protection Effect of Chitosan on the Performance Characteristics of A6063 Alloy

    Get PDF
    This article outlines the behaviour of water-soluble chitosan as an effective inhibitor on aluminium alloy in 3.65% NaCl at room temperature. The inhibitive ability of water-soluble chitosan was examined using electrochemical potentiodynamic polarization techniques, mass loss measurements and computational studies. The outcome of the experiment reveals that chitosan inhibited aluminium alloy in sodium chloride solution exhibits better corrosion protection than the uninhibited because chitosan nanoparticles minimize the ingression of chloride ion into the active sites of aluminium alloy by forming thin film on its surface. The losses in mass by the inhibited aluminium alloy were found to reduce as the concentration of chitosan increases. Results obtained showed that chitosan could offer inhibition efficiency above 70%. Polarization curve demonstrated that chitosan in 3.65% NaCl at room temperature acted as a mixed-type inhibitor. Adsorption of chitosan nanoparticles on the aluminium alloy was found to follow Langmuir adsorption isotherm with correlation regression coefficient (R2 ) value of 0.9961

    Study of dielectric relaxation and thermally activated a.c. conduction in glassy Se70Te30 and Se70Te28M2 (M = Ag, Zn and Cd) alloys

    Get PDF
    A detailed study of conduction mechanism of glassy Se70Te30 and Se70Te28M2 (M = Ag, Zn and Cd) alloys has been carried out in terms of dielectric properties and a.c. conductivity. Temperature and frequency dependent dielectric constant, dielectric loss and σac for the same system were measured in the frequency spectrum, 1 kHz to 1 MHz and temperature range, 303–338 K. The a.c. conductivity (σac) is found to be proportional to ωs (s < 1). The temperature dependence of both a.c. conductivity and frequency exponent (s) is reasonably well interpreted by the correlated barrier hopping (CBH) model. We showed that the bi-polaron hopping is dominant over the potential barrier and estimated the density of defect states (DOS) at 10 kHz. We found a good agreement between bi-polaron conductivity and experimental results
    corecore