24,721 research outputs found
Performance potential of combined cycles integrated with low-Btu gasifiers for future electric utility applications
A comparison and an assessment of 10 advanced utility power systems on a consistent basis and to a common level of detail were analyzed. Substantial emphasis was given to a combined cycle systems integrated with low-Btu gasifiers. Performance and cost results from that study were presented for these combined cycle systems, together with a comparative evaluation. The effect of the gasifier type and performance and the interface between the gasifier and the power system were discussed
Silicon strain sensors enable pressure measurement at cryogenic temperatures
Miniature pressure transducers with diffused, heavily doped silicon strain-gage sensor elements, operates over a wide temperature range. Small thermal mass combined with close coupling between a metallic diaphragm and sensor elements minimizes sensitivity to temperature transients
Stability of fluorescence of sodium salicylate
Sodium salicylate fluorescence stability over long periods of time - prevention of contamination by impuritie
Analysis of noise produced by jet impingement near the trailing edge of a flat and a curved plate
The sound fields produced by the interaction of a subsonic cold gas jet with the trailing edge of a large flat plate and a curved plate were analyzed. The analyses were performed to obtain a better understanding of the dominant noise source and the mechanism governing the peak sound-pressure-level frequencies of the broadband spectra. An analytical expression incorporating an available theory and experimental data predicts sound field data over an arc of approximately 105 deg measured from the upstream jet axis for the two independent sets of data. The dominant noise as detected on the impingement side of either plate results from the jet impact (eighth power of the velocity dependence) rather than a trailing-edge disturbance (fifth or sixth power of the velocity dependence). Also, the frequency of the peak SPL may be governed by a phenomenon which produces periodic formation and shedding of ring vortices from the nozzle lip
Externally blown flap trailing edge noise reduction by slot blowing: A preliminary study
Short takeoff and landing (STOL) aircraft using externally blown flaps (EBF) for lift augmentation develop considerable jet-flap interaction noise. A proposed method to reduce the EBF trailing edge noise is to locate a slot near the trailing edge of a flap through which low velocity secondary air is blown. Limited OASPL noise data were obtained from the interaction of the jet exhaust from a 5.08 cm diameter convergent nozzle with the trailing edge of a plate, and are presented for five slot configurations located near or at the trailing edge of the plate. Also presented are some significant jet trailing edge interaction data using a mixer nozzle with one of the slot configurations
Factorization and reduction methods for optimal control of distributed parameter systems
A Chandrasekhar-type factorization method is applied to the linear-quadratic optimal control problem for distributed parameter systems. An aeroelastic control problem is used as a model example to demonstrate that if computationally efficient algorithms, such as those of Chandrasekhar-type, are combined with the special structure often available to a particular problem, then an abstract approximation theory developed for distributed parameter control theory becomes a viable method of solution. A numerical scheme based on averaging approximations is applied to hereditary control problems. Numerical examples are given
Development and Verification of a Flight Stack for a High-Altitude Glider in Ada/SPARK 2014
SPARK 2014 is a modern programming language and a new state-of-the-art tool
set for development and verification of high-integrity software. In this paper,
we explore the capabilities and limitations of its latest version in the
context of building a flight stack for a high-altitude unmanned glider. Towards
that, we deliberately applied static analysis early and continuously during
implementation, to give verification the possibility to steer the software
design. In this process we have identified several limitations and pitfalls of
software design and verification in SPARK, for which we give workarounds and
protective actions to avoid them. Finally, we give design recommendations that
have proven effective for verification, and summarize our experiences with this
new language
Disposal of radioactive iodine in space
The possibility of space disposal of iodine waste from nuclear power reactors is investigated. The space transportation system utilized relies upon the space shuttle, a liquid hydrogen/liquid oxygen orbit transfer vehicle, and a solid propellant final stage. The iodine is assumed to be in the form of either an iodide or an iodate, and calculations assume that the final destination is either solar orbit or solar system escape. It is concluded that space disposal of iodine is feasible
Performance and operational economics estimates for a coal gasification combined-cycle cogeneration powerplant
A performance and operational economics analysis is presented for an integrated-gasifier, combined-cycle (IGCC) system to meet the steam and baseload electrical requirements. The effect of time variations in steam and electrial requirements is included. The amount and timing of electricity purchases from sales to the electric utility are determined. The resulting expenses for purchased electricity and revenues from electricity sales are estimated by using an assumed utility rate structure model. Cogeneration results for a range of potential IGCC cogeneration system sizes are compared with the fuel consumption and costs of natural gas and electricity to meet requirements without cogeneration. The results indicate that an IGCC cogeneration system could save about 10 percent of the total fuel energy presently required to supply steam and electrical requirements without cogeneration. Also for the assumed future fuel and electricity prices, an annual operating cost savings of 21 percent to 26 percent could be achieved with such a cogeneration system. An analysis of the effects of electricity price, fuel price, and system availability indicates that the IGCC cogeneration system has a good potential for economical operation over a wide range in these assumptions
An experimental investigation of the effect of boundary layer refraction on the noise from a high-speed propeller
Models of supersonic propellers were previously tested for acoustics in the Lewis 8- by 6-Foot Wind Tunnel using pressure transducers mounted in the tunnel ceiling. The boundary layer on the tunnel ceiling is believed to refract some of the propeller noise away from the measurement transducers. Measurements were made on a plate installed in the wind tunnel which had a thinner boundary layer than the ceiling boundary layer. The plate was installed in two locations for comparison with tunnel ceiling noise data and with fuselage data taken on the NASA Dryden Jetstar airplane. Analysis of the data indicates that the refraction increases with: increasing boundary layer thickness; increasing free stream Mach number; increasing frequency; and decreasing sound radiation angle (toward the inlet axis). At aft radiation angles greater than about 100 deg there was little or no refraction. Comparisons with the airplane data indicated that not only is the boundary layer thickness important but also the shape of the velocity profile. Comparisons with an existing two-dimensional theory, using an idealized shear layer to approximate the boundary layer, showed that the theory and data had the same trends. Analysis of the data taken in the tunnel at two different distances from the propeller indicates a decay with distance in the wind tunnel at high Mach numbers but the decay at low Mach numbers is not as clear
- …