Electrically active defects in polycrystalline and single crystal metal halide perovskite

We studied electrically active defects in CsPbBr3 polycrystalline films and single crystals samples using the thermally stimulated currents (TSC) technique in the temperature range 100–400 K. Below room temperature, both polycrystalline and single-crystals TSC emission is composed by a quasi-continuum of energy levels in the range 0.1–0.3 eV, and capture cross sections ~10−21 cm2. Above room temperature, TSC analysis reveals the presence of defect states in the range 0.40–0.52 eV only in polycrystalline samples, whereas these intermediate energy states are absent in TSC detected in single crystals. In polycrystalline films, the occupancy changes of an energy level at 0.45 eV strongly influences the room temperature photoconductivity, giving rise to slow transients due to defect passivation. In single-crystals, where intermediate energy states are absent, the photoconductivity response during illumination is almost stable and characterized by fast rise/decay times, a promising result for future applications of this material in photodetection and dosimetry

Gas sensing properties of In2O3 nano-films obtained by low temperature pulsed electron deposition technique on alumina substrates

Nanostructured Indium(III) oxide (In2O3) films deposited by low temperature pulsed electron deposition (LPED) technique on customized alumina printed circuit boards have been manufactured and characterized as gas sensing devices. Their electrical properties have monitored directly during deposition to optimize their sensing performance. Experimental results with oxidizing (NO2) as well as reducing (CO) gases in both air and inert gas carriers are discussed and modeled

Electrical and Optical Characterization of CsPbCl3 Films around the High-Temperature Phase Transitions

Large-area CsPbCl(3) films in the range 0.1–1.5 μm have been grown by radio frequency (RF)-magnetron sputtering on glass substrates by means of a one-step procedure. Three structural phase transitions have been detected, which are associated with hysteresis behavior in the electrical current when measured as a function of temperature in the range 295–330 K. Similarly, photoluminescence (PL) experiments in the same temperature range bring evidence of a non-monotonic shift of the PL peak. Detailed electrical characterizations evidenced how phase transitions are not influencing detrimentally the electrical transport properties of the films. In particular, the activation energy (0.6–0.8 eV) extracted from the temperature-dependent film resistivity does not appear to be correlated with phase changes. A non-linear trend of the photoconductivity response as a function of a ultra violet (UV) 365 nm light emitting diode (LED) power has been interpreted considering the presence of an exponential tail of intragap defects. Thermally stimulated currents after exposure with the same LED measured from room temperature up to 370 K showed no evidence of trapping effects due to intragap states on the electrical transport properties at room temperature of the films. As a consequence, measured photocurrents at room temperature appear to be well reproducible and stable in time, which are attractive features for possible future applications in photodetection

Effect of material elastic properties and surface roughness on grip performances of ski boot soles under wet and icy conditions

A set of thermoplastic materials employed in soles for alpine skiing boots were characterized in terms of chemical composition, cristallinity, hardness, surface roughness, and grip. The results of friction experiments on different substrates reproducing the real environmental scenarios point out that materials provide more grip as they become softer. Moreover, higher roughness results in lower dynamic coefficient of friction (COF). Finite element simulations corroborate the experimental measures of COF and let to rationalize the role of material elasticity and surface roughness on the frictional characteristics of soles. The measure of grip on an inclined wet surface provides analogous results, indicating that COF can be used as key performance indicator in the design of ski-boot soles and of other anti-slip equipments in wet and icy environments

Development of a Self-Sufficient LoRaWAN Sensor Node with Flexible and Glass Dye-Sensitized Solar Cell Modules Harvesting Energy from Diffuse Low-Intensity Solar Radiation

This paper aims to demonstrate the viability of energy harvesting for wide area wireless sensing systems based on dye-sensitized solar cells (DSSCs) under diffuse sunlight conditions, proving the feasibility of deploying autonomous sensor nodes even under unfavorable outdoor scenarios, such as during cloudy days, in the proximity of tall buildings, among the trees in a forest and during winter days in general. A flexible thin-film module and a glass thin-film module, both featuring an area smaller than an A4 sheet of paper, were initially characterized in diffuse solar light. Afterward, the protype sensor nodes were tested in a laboratory in two different working conditions, emulating outdoor sunlight in unfavorable lighting and weather to reconstruct a worst-case scenario. A Li-Po battery was employed as a power reserve for a long-range wide area network (LoRaWAN)-based sensor node that transmitted data every 8 h and every hour. To this end, an RFM95x LoRa module was used, while the node energy management was attained by exploiting a nano-power boost charger buck converter integrated circuit conceived for the nano-power harvesting from the light source and the managing of the battery charge and protection. A positive charge balance was demonstrated by monitoring the battery trend along two series of 6 and 9 days, thus allowing us to affirm that the system’s permanent energy self-sufficiency was guaranteed even in the worst-case lighting and weather scenario

Characterization of the Response of Magnetron Sputtered In2O3−x Sensors to NO2

The response of resistive In2O3−x sensing devices was investigated as a function of the NO2 concentration in different operative conditions. Sensing layers are 150 nm thick films manufactured by oxygen-free room temperature magnetron sputtering deposition. This technique allows for a facile and fast manufacturing process, at same time providing advantages in terms of gas sensing performances. The oxygen deficiency during growth provides high densities of oxygen vacancies, both on the surface, where they are favoring NO2 absorption reactions, and in the bulk, where they act as donors. This n-type doping allows for conveniently lowering the thin film resistivity, thus avoiding the sophisticated electronic readout required in the case of very high resistance sensing layers. The semiconductor layer was characterized in terms of morphology, composition and electronic properties. The sensor baseline resistance is in the order of kilohms and exhibits remarkable performances with respect to gas sensitivity. The sensor response to NO2 was studied experimentally both in oxygen-rich and oxygen-free atmospheres for different NO2 concentrations and working temperatures. Experimental tests revealed a response of 32%/ppm at 10 ppm NO2 and response times of approximately 2 min at an optimal working temperature of 200 °C. The obtained performance is in line with the requirements of a realistic application scenario, such as in plant condition monitoring

Hall effect measurements on proton-irradiated ROSE samples

Bulk samples obtained from two wafers of a silicon monocrystal material produced by Float-Zone refinement have been analyzed using the four-point probe method. One of the wafers comes from an oxygenated ingot; two sets of pure and oxygenated samples have been irradiated with 24 GeV/c protons in the fluence range from 10{sup 13} p/cm{sup 2} to 2x10{sup 14} p/cm{sup 2}. Van der Pauw resistivity and Hall coefficient have been measured before and after irradiation as a function of the temperature. A thermal treatment (30 minutes at 100C) has been performed to accelerate the reverse annealing effect in the irradiated silicon. The irradiated samples show the same exponential dependence of the resistivity and of the Hall coefficient on the temperature from 370K to 100K, corresponding to the presence of radiation-induced deep energy levels around 0.6-0.7eV in the silicon gap. The free carrier concentrations (n, p) have been evaluated in the investigated fluence range. The inversion of the conductivity type from n to p occurred respectively at 7x10{sup 13} p/cm{sup 2} and at 4x10{sup 13} p/cm{sup 2} before and after the annealing treatment, for both the two sets. Only slight differences have been detected between the pure and oxygenated samples

1. The fraction of cancer attributable to lifestyle and environmental factors in the UK in 2010: Introduction

The overall objective of the study is to estimate the percentage of cancers (excluding non-melanoma skin cancer) in the UK in 2010 that were the result of exposure to 14 major lifestyle, dietary and environmental risk factors: tobacco, alcohol, four elements of diet (consumption of meat, fruit and vegetables, fibre and salt), overweight, lack of physical exercise, occupation, infections, radiation (ionising and solar), use of hormones and reproductive history (breast feeding). The number of new cases attributable to suboptimal exposure levels in the past, relative to a theoretical optimum exposure distribution, is evaluated. For most of the exposures, the attributable fraction was calculated based on the distribution of exposure prevalence (around 2000), the difference from the theoretical optimum (by age group and sex) and the relative risk per unit difference. For tobacco smoking, the method developed by Peto et al (1992) was used, which relies on the ratio between observed incidence of lung cancer in smokers and that in non-smokers, to calibrate the risk. This article outlines the structure of the supplement – a section for each of the 14 exposures, followed by a Summary chapter, which considers the relative contributions of each factor to the total number of cancers diagnosed in the UK in 2010 that were, in theory, avoidable