Evaporation of particle-stabilised emulsion sunscreen films

We recently showed (Binks et al., ACS Appl. Mater. Interfaces, 2016, DOI: 10.1021/acsami.6b02696) how evaporation of sunscreen films consisting of solutions of molecular UV filters leads to loss of UV light absorption and derived sun protection factor (SPF). In the present work, we investigate evaporation-induced effects for sunscreen films consisting of particle-stabilized emulsions containing a dissolved UV filter. The emulsions contained either droplets of propylene glycol (PG) in squalane (SQ), droplets of SQ in PG or droplets of decane in PG. In these different emulsion types, the SQ is involatile and shows no evaporation, the PG is volatile and evaporates relatively slowly, whereas the decane is relatively very volatile and evaporates quickly. We have measured the film mass and area, optical micrographs of the film structure, and the UV absorbance spectra during evaporation. For emulsion films containing the involatile SQ, evaporation of the PG causes collapse of the emulsion structure with some loss of specular UV absorbance due to light scattering. However, for these emulsions with droplets much larger than the wavelength of light, the light is scattered only at small forward angles so does not contribute to the diffuse absorbance and the film SPF. The UV filter remains soluble throughout the evaporation and thus the UV absorption by the filter and the SPF remain approximately constant. Both PG-in-SQ and SQ-in-PG films behave similarly and do not show area shrinkage by dewetting. In contrast, the decane-in-PG film shows rapid evaporative loss of the decane, followed by slower loss of the PG resulting in precipitation of the UV filter and film area shrinkage by dewetting which cause the UV absorbance and derived SPF to decrease. Measured UV spectra during evaporation are in reasonable agreement with spectra calculated using models discussed here

Spectrophotometry of thin films of light absorbing particles

Thin films of dispersions of light absorbing solid particles or emulsions containing a light absorbing solute all have a non-uniform distribution of light absorbing species throughout the sample volume. This results in non-uniform light absorption over the illuminated area which causes the optical absorbance, as measured using a conventional specular UV-vis spectrophotometer, to deviate from the Beer-Lambert relationship. We have developed a theoretical model to account for the absorbance properties of such films which are shown to depend on the size and volume fraction of the light absorbing particles plus other sample variables. We have compared model predictions with measured spectra for samples consisting of emulsions containing a dissolved light absorbing solute. Using no adjustable parameters, the model successfully predicts the behaviour of non-uniform, light absorbing emulsion films with varying values of droplet size, volume fraction and other parameters

Continuity of Optimal Control Costs and its application to Weak KAM Theory

We prove continuity of certain cost functions arising from optimal control of affine control systems. We give sharp sufficient conditions for this continuity. As an application, we prove a version of weak KAM theorem and consider the Aubry-Mather problems corresponding to these systems.Comment: 23 pages, 1 figures, added explanations in the proofs of the main theorem and the exampl

Effects of temperature in relation to sheet metal stamping

The demand to reduce the use of lubricants and increase tool life in sheet metal stamping has resulted in increased research on the sliding contact between the tool and the sheet materials. Unlubricated sliding wear tests for soft carbon steel sliding on D2 tool steel were performed using a pin-on-disk tribometer. The results revealed that temperature has an influencing role in the wear of tool steel and that material transfer between tool and sheet can be minimized at a certain temperature range in sheet metal stamping

Adsorption of benzyldimethyldodecylammonium chloride onto stainless steel using the quartz crystal microbalance and the depletion methods: An optimisation study

The adsorption behaviour of benzyldimethyldodecylammonium chloride (C12BDMAC) corrosion inhibitor from aqueous solutions onto a stainless steel surface has been investigated using the quartz crystal microbalance (QCM) technique and the depletion-HPLC method. Three different experimental procedures were used to carry out the adsorption measurements using the QCM. The results revealed that the employed experimental procedure had a marked influence on both of the measured frequency and dissipation energy changes. Additionally, the measured changes in the normalized frequency and dissipation changes were found to be overtone-dependent. The adsorbed amounts determined by QCM were higher than those determined by depletion due to strong contributions from the bulk liquid properties. The direct application of the measured frequency shifts corresponding to the lowest dissipation changes, ?flowestD, in the Sauerbrey equation was effective in minimising these contributions within an acceptable experimental tolerance. A correction procedure, based on the Kanazawa equation, has been proposed and applied successfully to separate the contribution from the bulk effects to the calculated adsorbed mass. The adsorption isotherms obtained from the corrected frequency shifts and the depletion method were perfectly matched over the whole range of concentrations investigated

Calling in Call-out Culture: An Analysis on Call-out Culture and its influence on Filipino Twitter

Call-out culture has become a questionable phenomenon in and out of Filipino Twitter due to the differing ideologies that participants have perpetuated, separating Filipino communities based on their standing on certain topics on the internet. The reason it has become dubious is due to the bullying that occurs because of the call-outs. Previous research had stated that call-outs have started shifting from being a tool used to oppose abuse into an accessory for building fame on the internet. The researchers used Foucauldian Discourse Analysis to analyze several replies, tweets, and quoted tweets from Filipinos on Twitter. The data was put under the lens of the synopticon theory and Althusser’s concept of the Ideological State Apparatus. The analysis has led to the conclusion that there is an evident divide between Filipino communities, and, amid the discord with themes of colonialism and racism, public figures can use it as a device to manipulate the mindset of the masses

A cryogenic liquid-mirror telescope on the moon to study the early universe

We have studied the feasibility and scientific potential of zenith observing liquid mirror telescopes having 20 to 100 m diameters located on the moon. They would carry out deep infrared surveys to study the distant universe and follow up discoveries made with the 6 m James Webb Space Telescope (JWST), with more detailed images and spectroscopic studies. They could detect objects 100 times fainter than JWST, observing the first, high-red shift stars in the early universe and their assembly into galaxies. We explored the scientific opportunities, key technologies and optimum location of such telescopes. We have demonstrated critical technologies. For example, the primary mirror would necessitate a high-reflectivity liquid that does not evaporate in the lunar vacuum and remains liquid at less than 100K: We have made a crucial demonstration by successfully coating an ionic liquid that has negligible vapor pressure. We also successfully experimented with a liquid mirror spinning on a superconducting bearing, as will be needed for the cryogenic, vacuum environment of the telescope. We have investigated issues related to lunar locations, concluding that locations within a few km of a pole are ideal for deep sky cover and long integration times. We have located ridges and crater rims within 0.5 degrees of the North Pole that are illuminated for at least some sun angles during lunar winter, providing power and temperature control. We also have identified potential problems, like lunar dust. Issues raised by our preliminary study demand additional in-depth analyses. These issues must be fully examined as part of a scientific debate we hope to start with the present article.Comment: 35 pages, 11 figures. To appear in Astrophysical Journal June 20 200