Experimental study of one- and two-component low-turbulence confined coaxial flows

Fluid mechanics experiments to investigate methods for reducing mixing between confined coaxial flows in cylindrical chambers for application to open-cycle gaseous-core nuclear rocket

Mass and Momentum Turbulent Transport Experiments with Confined Coaxial Jets

Downstream mixing of coaxial jets discharging in an expanded duct was studied to obtain data for the evaluation and improvement of turbulent transport models currently used in a variety of computational procedures throughout the propulsion community for combustor flow modeling. Flow visualization studies showed four major shear regions occurring; a wake region immediately downstream of the inlet jet inlet duct; a shear region further downstream between the inner and annular jets; a recirculation zone; and a reattachment zone. A combination of turbulent momentum transport rate and two velocity component data were obtained from simultaneous measurements with a two color laser velocimeter (LV) system. Axial, radial and azimuthal velocities and turbulent momentum transport rate measurements in the r-z and r-theta planes were used to determine the mean value, second central moment (or rms fluctuation from mean), skewness and kurtosis for each data set probability density function (p.d.f.). A combination of turbulent mass transport rate, concentration and velocity data were obtained system. Velocity and mass transport in all three directions as well as concentration distributions were used to obtain the mean, second central moments, skewness and kurtosis for each p.d.f. These LV/LIF measurements also exposed the existence of a large region of countergradient turbulent axial mass transport in the region where the annular jet fluid was accelerating the inner jet fluid

Combined inhibitory effect of nisin with EDTA against Listeria monocytogenes in soy-protein edible coating on turkey frankfurters stored at 4°C and 10°C

Several food contamination outbreaks are linked to Listeria monocytogenes. More effective methods are needed to prevent the growth and recontamination of L. monocytogenes on ready-to-eat (RTE) food products. Therefore, the objectives of this study were to evaluate the inhibitory activities of nisin (10,000 IU/mL), EDTA (sodium Ethylenediaminetetraacetic acid: 1.6 mg/mL), and the combination of nisin (10,000 IU/mL) with EDTA 1.6 mg/mL either in brain-heart-infusion (BHI) media at 37°C for 72 h or in soy-protein edible coating on the surface of full-fat commercial turkey frankfurters against the cell populations of approximately 106 colony forming units (CFU/mL) of L. monocytogenes. The surface-inoculated frankfurters were dipped into soy-protein film forming solutions with and without the addition of antimicrobial agents [(nisin (10,000 IU) or EDTA (0.16%) or the combination)] and stored at either 4°C or 10°C. The inhibitory effects of edible coatings were evaluated on a weekly basis for 45 d. The greatest inhibitory activities of 6 log cycle reductions of L. monocytogenes were found when nisin was combined with EDTA and eliminated 6 log cycles of L. monocytogenes in both systems. In the combined nisin (10,000 IU) with EDTA (0.16%) treatment, the L. monocytogenes population was reduced to undetectable levels after 15 h or 7 d incubation in BHI at 37°C or on turkey frankfurters stored at 4°C and 10°C, respectively. This research has demonstrated that the use of an edible film coating containing nisin with EDTA is a promising means of controlling the growth and recontamination of L. monocytogenes on RTE meat products

Microwave nondestructive evaluation of aircraft radomes

As the aviation industry continues to experience increased demand on maintenance turn-around time with decreased budgets, the airlines in particular seek advances in cost and efficiency for inspection technology. Such improvements not only increase aviation safety, but also lead to significant cost savings and avoidances. One particular inspection need is that of aircraft radomes, often found as the nosecone such as that seen in Figure 1.1, housing the plane\u27s weather radar. This structure, fabricated out of low-loss/permittivity composite materials (such as fiberglass), must appear as electrically transparent as possible to the radar. Like a window to the human eye, any variations (in the form of changes in the radome\u27s electrical permittivity) or excess material will make sensing the outside world through the structure difficult. Defects such as water ingression, excess paint, and impact damage hinder the radar\u27s ability to sense accurately. No field-ready technique exists to evaluate the electrical properties or electrical consistency of the radome

A preliminary study of the ecology of the native wild ducks of Iowa ...

http://www.worldcat.org/oclc/2432433

Silicon device performance measurements to support temperature range enhancement

Semiconductor power devices are typically rated for operation below 150 C. Little data is known for power semiconductors over 150 C. In most cases, the device is derated to zero operating power at 175 C. At the high temperature end of the temperature range, the intrinsic carrier concentration increases to equal the doping concentration level and the silicon behaves as an intrinsic semiconductor. The increase in intrinsic carrier concentration results in a shift of the Fermi level toward mid-bandgap at elevated temperatures. This produces a shift in devices characteristics as a function of temperature. By increasing the doping concentration higher operating temperatures can be achieved. This technique was used to fabricate low power analog and digital devices in silicon with junction operating temperatures in excess of 300 C. Additional temperature effects include increased p-n junction leakage with increasing temperature, resulting in increased resistivity. The temperature dependency of physical properties results in variations in device characteristics. These must be quantified and understood in order to develop extended temperature range operation

Universal Properties of Linear Magnetoresistance in Strongly Disordered Semiconductors

Linear magnetoresistance occurs in semiconductors as a consequence of strong electrical disorder and is characterized by nonsaturating magnetoresistance that is proportional to the applied magnetic field. By investigating a disordered MnAs-GaAs composite material, it is found that the magnitude of the linear magnetoresistance (LMR) is numerically equal to the carrier mobility over a wide range and is independent of carrier density. This behavior is complementary to the Hall effect that is independent of the mobility and dependent on the carrier density. Moreover, the LMR appears to be insensitive to the details of the disorder and points to a universal explanation of classical LMR that can be applied to other material systems.Comment: Accepted by Phys. Rev. B (2010

Transcutaneous electrical nerve stimulation for cancer pain in adults.

Background Cancer-related pain is complex and multi-dimensional but the mainstay of cancer pain management has predominately used a biomedical approach. There is a need for non-pharmacological and innovative approaches. Transcutaneous Electric Nerve Stimulation (TENS) may have a role for a significant number of patients but the effectiveness of TENS is currently unknown. Objectives The aim of this systematic review was to determine the effectiveness of TENS for cancer-related pain in adults. Search strategy We searched The Cochrane Library, MEDLINE, EMBASE, CINAHL, PsychINFO, AMED and PEDRO databases (11/04/08). Selection criteria Only randomised controlled trials (RCTS) investigating the use of TENS for the management of cancer-related pain in adults were included. Data collection and analysis The search strategy identified 37 possible published studies which were divided between two pairs of review authors that decided on study selection. A study eligibility form was used to screen each abstract and where study eligibility could not be determined from the abstract, the full paper was obtained and assessed by one pair of review authors. A standardised data extraction sheet was used to collect information on the studies and the quality of the studies was assessed independently by two review authors using the validated five-point Oxford Quality Scale. Final scores were discussed and agreed between all four review authors. The small sample sizes and differences in patient study populations of the two included studies prevented meta-analysis. Main results Only two RCTs met the eligibility criteria (64 participants). These studies were heterogenous with respect to study population, sample size, study design, methodological quality, mode of TENS, treatment duration, method of administration and outcome measures used. In one RCT, there were no significant differences between TENS and placebo in women with chronic pain secondary to breast cancer treatment. In the other RCT, there were no significant differences between acupuncture-type TENS and sham in palliative care patients; this study was underpowered. Authors' conclusions The results of this systematic review are inconclusive due to a lack of suitable RCTs. Large multi-centre RCTs are required to assess the value of TENS in the management of cancer-related pain in adults