Enhanced quality factors and force sensitivity by attaching magnetic beads to cantilevers for atomic force microscopy in liquid

Dynamic-mode atomic force microscopy (AFM) in liquid remains complicated due to the strong viscous damping of the cantilever resonance. Here we show that a high-quality resonance (Q>20) can be achieved in aqueous solution by attaching a microgram-bead at the end of the nanogram-cantilever. The resulting increase in cantilever mass causes the resonance frequency to drop significantly. However, the force sensitivity --- as expressed via the minimum detectable force gradient --- is hardly affected, because of the enhanced quality factor. Via the enhancement of the quality factor, the attached bead also reduces the relative importance of noise in the deflection detector. It can thus yield an improved signal-to-noise ratio when this detector noise is significant. We describe and analyze these effects for a set-up which includes magnetic actuation of the cantilevers and which can be easily implemented in any AFM system that is compatible with an inverted optical microscope.Comment: The following article has been accepted by Journal of Applied Physics. After it is published, it will be found at http://jap.aip.org

Straightforward route to superhydrophilic poly(2-oxazoline)s via acylation of well-defined polyethylenimine

Herein, we describe a new method for the synthesis of superhydrophilic poly(2-alkyl-2-oxazoline)s (PAOx) from poly(2-ethyl-2-oxazoline) (PEtOx). A well-defined linear polyethylenimine was prepared from PEtOx by controlled acidic hydrolysis of its side-chains followed by reacylation with different carboxylic acids. Using this protocol, we obtained a series of new hydrophilic PAOx containing side-chain ether groups with potential in biomaterials science. The relative hydrophilicity of the polymers was assessed, revealing that poly(2-methoxymethyl-2-oxazoline) (PMeO-MeOx) is the most hydrophilic PAOx reported to date. Additionally, the amorphous poly(2-methoxy-ethoxy-ethoxymethyl-2-oxazoline) (PDEGOx) shows the lowest reported glass transition temperature (-25 degrees C) within the PAOx family to date. The biomedical potential of the prepared polymers was further fortified by an in vitro cytotoxicity study, where all polymers appeared to be noncytotoxic. The described synthetic protocol is universal and can be extremely versatile, especially for PAOx that are difficult to prepare by conventional cationic ring-opening polymerization due to the monomer interference and/or degradation

A generic platform for the visualization of all monomer sequences in individual copolymer chains

C

The elusive seven-membered cyclic imino ether tetrahydrooxazepine

Cyclic imino ether heterocycles are used as ligands in transition metal catalysis, in various drugs and as reactive monomers in living cationic ring-opening polymerization (CROP). While five- and six-membered cyclic imino ethers, i.e. 2-oxazolines and 4,S-dihydro-1,3-oxazines, have extensively been studied in these areas, their seven-membered ring counterparts have remained unexplored. Herein, we report the synthesis of 2-phenyl-4,5,6,7-tetrahydro-1,3-oxazepine allowing reassignment of the earlier, incorrectly reported 4,5,6,7-tetrahydro-1,3-oxazepines as their N-acylated pyrrolidine isomers. Finally, we also report a comparison of the CROP reactivity of a homologous series of cyclic imino ethers with a 2-carbon, 3-carbon, and 4-carbon methylene bridge, revealing a remarkable ring size effect

Visualization and design of the functional group distribution during statistical copolymerization

Even though functional copolymers with a low percentage of functional comonomer units (up to 20 mol%) are widely used, for instance for the development of polymer therapeutics and hydrogels, insights in the functional group distribution over the actual chains are lacking and the average composition is conventionally used to describe the functionalization degree. Here we report the visualization of the monomer distribution over the different polymer chains by a synergetic combination of experimental and theoretical analysis aiming at the construction of functionality-chain length distributions (FUNC-CLDs). A successful design of the chemical structure of the comonomer pair, the initial functional comonomer amount (13 mol%), and the temperature (100 °C) is performed to tune the FUNC-CLD of copoly(2-oxazoline)s toward high functionalization degree for both low (100) and high (400) target degrees of polymerization. The proposed research strategy is generic and extendable to a broad range of copolymerization chemistries, including reversible deactivation radical polymerization

Cooperative amyloid fibre binding and disassembly by the Hsp70 disaggregase

Although amyloid fibres are highly stable protein aggregates, a specific combination of human Hsp70 system chaperones can disassemble them, including fibres formed of α-synuclein, huntingtin, or Tau. Disaggregation requires the ATPase activity of the constitutively expressed Hsp70 family member, Hsc70, together with the J domain protein DNAJB1 and the nucleotide exchange factor Apg2. Clustering of Hsc70 on the fibrils appears to be necessary for disassembly. Here we use atomic force microscopy to show that segments of in vitro assembled α-synuclein fibrils are first coated with chaperones and then undergo bursts of rapid, unidirectional disassembly. Cryo-electron tomography and total internal reflection fluorescence microscopy reveal fibrils with regions of densely bound chaperones, preferentially at one end of the fibre. Sub-stoichiometric amounts of Apg2 relative to Hsc70 dramatically increase recruitment of Hsc70 to the fibres, creating localised active zones that then undergo rapid disassembly at a rate of ~ 4 subunits per second. The observed unidirectional bursts of Hsc70 loading and unravelling may be explained by differences between the two ends of the polar fibre structure

Efficient cationic ring-opening polymerization of diverse cyclic imino ethers: unexpected copolymerization behavior

The recently developed fast microwave-assisted cationic ring-opening polymerization procedure for 2-oxazolines seems to be ideally suited for slower polymerizing cyclic imino ether monomers. In this study we report the effect of the cyclic imino ether structure on the polymerization rate under exactly the same microwave-assisted conditions revealing that indeed less reactive cyclic imino ethers, including 2-oxazines as well as 4- and 5-substituted 2-oxazolines, can be polymerized to at least 50% conversion for the slowest monomer, namely 5-methyl-2-butyl-2-oxazoline, within 10 h. In addition, the copolymerization behavior of 4-ethyl-2-butyl-2-oxazoline with 2-methyl-2-oxazoline and 2-phenyl-2-oxazoline unexpectedly revealed faster incorporation of the less reactive 4-ethy1-2-buty1-2-oxazoline monomer compared to 2-phenyl-2-oxazoline due to the increased bulk of the latter monomer amplifying the sterical hindrance for polymerization onto the 4-ethyl-2-butyl-2-oxazolinium propagating species