Aerodynamic effects of a split flap on the spinning characteristics of a monoplane model

The investigation described in this report was made to determine the change in aerodynamic forces and moments produced by split flaps in a steady spin. The test were made with the spinning balance in the NACA 5-foot vertical wind tunnel. A low-wing monoplane model was tested with and without the split flaps in 12 spinning attitudes chosen to cover the probable spinning range. The changes in coefficients produced by adding the split flaps are given for longitudinal force, normal force, and rolling and yawing moments about body axes. The results obtained indicate that the use of split flaps on an airplane is unlikely, in any case, to have much beneficial effect on a spin, and it might make the spin dangerous. The change in the spin will depend upon the aerodynamic and inertia characteristics of the particular airplane. A dangerous condition is most likely to be attained with airplanes which are statically stable in yaw in the spinning attitude and which have large weights distributed along wings

The Aerodynamic Forces and Moments on a Spinning Model of the F4B-2 Airplane as Measured by the Spinning Balance

The aerodynamic forces and moments on a 1/12-scale model of the F4B-2 airplane were measured with the spinning balance in nine spinning attitudes with three sets of tail surfaces, namely, F4B-2 surfaces; F4B-4 fin and rudder with rectangular stabilizer; and with all tail surfaces removed. In one of these attitudes measurements were made to determine the effect upon the forces and moments of independent and of simultaneous displacement of the rudder and elevator for two of the sets of tail surfaces. Additional measurements were made for a comparison of model and full-scale data for six attitudes that were determined from flight tests with various control settings. The characteristics were found to vary in the usual manner with angle of attack and sideslip. The F4B-2 surfaces were quite ineffective as a source of yawing moments. The F4B-4 fin and F4B-2 stabilizer gave a greater damping yawing moment when controls were against the spin than did the F4B-2 surfaces but otherwise there was little difference. Substitution of a rectangular stabilizer for the F4B-2 stabilizer made no appreciable difference in the coefficient. Further comparisons with other airplane types are necessary before final conclusions can be drawn as to the relations between model and full-scale spin measurements

Spinning characteristics of wings II : rectangular Clark Y biplane cellule: 25 percent stagger; 0 degree decalage; gap/chord 1.0

General methods of theoretical analysis of airplane spinning characteristics have been available for some time. Some of these methods of analysis might be used by designers to predict the spinning characteristics of proposed airplane designs if the necessary aerodynamic data were known. The present investigation, to determine the spinning characteristics of wings, is planned to include variations in airfoil sections, plan forms, and tip shapes of monoplane wings and variations in stagger, gap, and decalage for biplane cellules. The first series of tests, made on a rectangular Clark Y monoplane wing, are reported in reference 1. That report also gives an analysis of the data for predicting the probable effects of various important parameters on the spin for normal airplanes using such a wing. The present report is the second of the series. It gives the aerodynamic characteristics of a rectangular Clark Y biplane cellule in spinning attitudes and includes a discussion of the data, using the method of analysis given in reference 1

Online store brand experience impacting on online brand trust and online repurchase intention: The moderating role of online brand attachment

The scope of this research is to examine the impact of online store brand experience on online brand trust and online repurchase intention. Additionally, the study tests whether online brand attachment moderates these influences. Data was gathered in two cites in Pakistan and path relationships in the theoretical model were analysed using partial least squares structural equation modelling. The study results confirm that onlinebrand attachment and online brand experience have a direct relationship with online brand trust and online repurchase intention. Conclusively, online brand attachment significantly moderates the two relationships between a) online brand experiences and online brand trust and b) online brand experiences and online repurchase intention.The study provides insights for online retail store managers to focus on improving the online experience for its customers in order to promote online brand trust and online repurchase intentions

Measuring attitudes towards Global Learning among future educators in England

This paper reports upon a multi-agency approach to measuring attitudes towards global learning among future educators at a university in the north-west of England. This study provides a response to concerns that global learning research and evaluation of global education interventions tend to focus upon short-term, observable outcomes rather than longer-term changes in behaviour, attitude, and practice. It is based upon the assumption that global learning in teacher education must focus upon the development of who the educator is as a person, including his or her values, attitudes, and associated dispositions. This paper will outline the process of constructing an attitude inventory, based upon Thurstone scaling, by a range of professionals working in local government, teacher education, and non-government organizations that promote global education. It reports upon the use of this survey at the beginning, middle, and end of a compulsory course completed by a cohort of 154 undergraduate students of primary teacher education. The findings show positive changes in attitudes towards global learning among females and eradication of the most negative attitudes towards global learning during the course of study. Causal factors relating to cultural practice are suggested. The limitations of this particular tool for researching global learning are discussed alongside the insight gained from this collaborative process of evaluation

Spinning Characteristics of the XN2Y-1 Airplane Obtained from the Spinning Balance and Compared with Results from the Spinning Tunnel and from Flight Tests

Report presents the results of tests of a 1/10-scale model of the XN2Y-1 airplane tested in the NACA 5-foot vertical wind tunnel in which the six components of forces and moments were measured. The model was tested in 17 attitudes in which the full-scale airplane had been observed to spin, in order to determine the effects of scale, tunnel, and interference. In addition, a series of tests was made to cover the range of angles of attack, angles of sideslip, rates of rotation, and control setting likely to be encountered by a spinning airplane. The data were used to estimate the probable attitudes in steady spins of an airplane in flight and of a model in the free-spinning tunnel. The estimated attitudes of steady spin were compared with attitudes measured in flight and in the spinning tunnel. The results indicate that corrections for certain scale and tunnel effects are necessary to estimate full-scale spinning attitudes from model results

Wind-tunnel Investigation of Effect of Yaw on Lateral-stability Characteristics I : Four N.A.C.A. 23012 Wings of Various Plan Forms with and Without Dihedral

Four N.A.C.A. 23012 wings were tested at several angles of yaw in the N.A.C.A. 7- by 10-foot wind tunnel. All the wings have rounded tips and, in plan form, one is rectangular and the others are tapered 3:1 with various amounts of sweep. Each wing was tested with two amounts of dihedral and with partial-span split flaps. The coefficients of lift, drag, and pitching moment are given for all the models at zero yaw. The coefficients of rolling moment, yawing moment, and side force are given for the rectangular wing at all values of yaw tested. The rate of change in the coefficients with angle of yaw is given in convenient form for stability calculations

Spinning Characteristics of Wings III : a Rectangular and Tapered Clark Y Monoplane Wing with Rounded Tips

An investigation was made to determine the spinning characteristics of Clark Y monoplane wings with different plan forms. A rectangular wing and a wing tapered 5:2, both with rounded tips, were tested on the N.A.C.A. spinning balance in the 5-foot vertical wind tunnel. The aerodynamic characteristics of the models and a prediction of the angles of sideslip for steady spins are given. Also included is an estimate of the yawning moment that must be furnished by the parts of the airplane to balance the inertia couples and wing yawing moment for spinning equilibrium. The effects on the spin of changes in plan form and of variations of some of the important parameters are discussed and the results are compared with those for a rectangular wing with square tips. It is concluded that for a conventional monoplane using Clark Y wing the sideslip will be algebraically larger for the wing with the rounded tip than for the wing with the square tip and will be largest for the tapered wing. The effect of plan form on the spin will vary with the type of airplane; and the provision of a yawing-moment coefficient of -0.025 (i.e., opposing the spin) by the tail, fuselage, and interference effects will insure against the attainment of equilibrium on a steady spin for any of the plan forms tested and for any of the parameters used in the analysis