Small-signal amplifier based on single-layer MoS2

In this Letter we demonstrate the operation of an analog small-signal amplifier based on single-layer MoS2, a semiconducting analogue of graphene. Our device consists of two transistors integrated on the same piece of single-layer MoS2. The high intrinsic band gap of 1.8 eV allows MoS2-based amplifiers to operate with a room temperature gain of 4. The amplifier operation is demonstrated for the frequencies of input signal up to 2 kHz preserving the gain higher than 1. Our work shows that MoS2 can effectively amplify signals and that it could be used for advanced analog circuits based on two-dimensional materials.Comment: Submitted version of the manuscrip

Visibility of dichalcogenide nanolayers

Dichalcogenides with the common formula MX2 are layered materials with electrical properties that range from semiconducting to superconducting. Here, we describe optimal imaging conditions for optical detection of ultrathin, two-dimensional dichalcogenide nanocrystals containing single, double and triple layers of MoS2, WSe2 and NbSe2. A simple optical model is used to calculate the contrast for nanolayers deposited on wafers with varying thickness of SiO2. The model is extended for imaging using the green channel of a video camera. Using AFM and optical imaging we confirm that single layers of MoS2, WSe2 and NbSe2 can be detected on 90nm and 270 nm SiO2 using optical means. By measuring contrast under broad-band green illumination we are also able to distinguish between nanostructures containing single, mono and triple layers of MoS2, WSe2 and NbSe2

Structural stability and local electronic properties of some EC synthesized magnetite nanopowders

Structural and electronic properties, oxidation and aging effect of electrochemically (EC) synthesized magnetite nanopowders (NPs) are studied by means of X–ray diffraction (XRD), X–ray absorption fine structure (XAFS) and X–ray magnetic circular dichroism (XMCD). The obtained results enabled to get a direct insight into the structure and electronic properties of Fe immediate surrounding and to elucidate the influence of preparation conditions on stoichiometry of NPs and their stability in ambient conditions. All investigated NPs are produced as non–stoichiometric Fe$_{3−δ}$O$_4$ oxide phases, with the lattice constant and the Fe$^{2+}$/Fe$^{3+}$ ratio both in–between the values for bulk maghemite and magnetite. NPs synthesized under smaller current density (J = 200 mA/dm$^2$) are more magnetite–alike, whereas larger current density (J = 1000 mA/dm$^2$) has led to formation of NPs closer to maghemite. Oxidation of magnetite–like NPs is slower, although in the course of time particles agglomerate and oxide penetrates into the core. Maghemite–like NPs oxidize much faster and the oxide layer which is confined close to the particles' surface protects the core from further oxidation. In all NPs the fist coordination around Fe is pretty stable against both temperature and oxidation process. The temperature change from 293 K to 20 K considerably affects the second coordination around Fe, which is most likely a consequence of the Verwey transition present in all investigated samples

Optoelectronics with electrically tunable PN diodes in a monolayer dichalcogenide

One of the most fundamental devices for electronics and optoelectronics is the PN junction, which provides the functional element of diodes, bipolar transistors, photodetectors, LEDs, and solar cells, among many other devices. In conventional PN junctions, the adjacent p- and n-type regions of a semiconductor are formed by chemical doping. Materials with ambipolar conductance, however, allow for PN junctions to be configured and modified by electrostatic gating. This electrical control enables a single device to have multiple functionalities. Here we report ambipolar monolayer WSe2 devices in which two local gates are used to define a PN junction exclusively within the sheet of WSe2. With these electrically tunable PN junctions, we demonstrate both PN and NP diodes with ideality factors better than 2. Under excitation with light, the diodes show photodetection responsivity of 210 mA/W and photovoltaic power generation with a peak external quantum efficiency of 0.2%, promising numbers for a nearly transparent monolayer sheet in a lateral device geometry. Finally, we demonstrate a light-emitting diode based on monolayer WSe2. These devices provide a fundamental building block for ubiquitous, ultra-thin, flexible, and nearly transparent optoelectronic and electronic applications based on ambipolar dichalcogenide materials.Comment: 14 pages, 4 figure

Electric Field Effects on Graphene Materials

Understanding the effect of electric fields on the physical and chemical properties of two-dimensional (2D) nanostructures is instrumental in the design of novel electronic and optoelectronic devices. Several of those properties are characterized in terms of the dielectric constant which play an important role on capacitance, conductivity, screening, dielectric losses and refractive index. Here we review our recent theoretical studies using density functional calculations including van der Waals interactions on two types of layered materials of similar two-dimensional molecular geometry but remarkably different electronic structures, that is, graphene and molybdenum disulphide (MoS$_2$). We focus on such two-dimensional crystals because of they complementary physical and chemical properties, and the appealing interest to incorporate them in the next generation of electronic and optoelectronic devices. We predict that the effective dielectric constant ($\varepsilon$) of few-layer graphene and MoS$_2$ is tunable by external electric fields ($E_{\rm ext}$). We show that at low fields ($E_{\rm ext}^{}<0.01$ V/\AA) $\varepsilon$ assumes a nearly constant value $\sim$4 for both materials, but increases at higher fields to values that depend on the layer thickness. The thicker the structure the stronger is the modulation of $\varepsilon$ with the electric field. Increasing of the external field perpendicular to the layer surface above a critical value can drive the systems to an unstable state where the layers are weakly coupled and can be easily separated. The observed dependence of $\varepsilon$ on the external field is due to charge polarization driven by the bias, which show several similar characteristics despite of the layer considered.Comment: Invited book chapter on Exotic Properties of Carbon Nanomatter: Advances in Physics and Chemistry, Springer Series on Carbon Materials. Editors: Mihai V. Putz and Ottorino Ori (11 pages, 4 figures, 30 references

The Nature of Electronic States in Atomically Thin MoS2 Field-Effect Transistors

We present low temperature electrical transport experiments in five field effect transistor devices consisting of monolayer, bilayer and trilayer MoS2 films, mechanically exfoliated onto Si/SiO2 substrate. Our experiments reveal that the electronic states in all films are localized well up to the room temperature over the experimentally accessible range of gate voltage. This manifests in two dimensional (2D) variable range hopping (VRH) at high temperatures, while below \sim 30 K the conductivity displays oscillatory structures in gate voltage arising from resonant tunneling at the localized sites. From the correlation energy (T0) of VRH and gate voltage dependence of conductivity, we suggest that Coulomb potential from trapped charges in the substrate are the dominant source of disorder in MoS2 field effect devices, which leads to carrier localization as well.Comment: 10 pages, 5 figures; ACS Nano (2011

Optical signature of symmetry variations and spin-valley coupling in atomically thin tungsten dichalcogenides

Motivated by the triumph and limitation of graphene for electronic applications, atomically thin layers of group VI transition metal dichalcogenides are attracting extensive interest as a class of graphene-like semiconductors with a desired band-gap in the visible frequency range. The monolayers feature a valence band spin splitting with opposite sign in the two valleys located at corners of 1st Brillouin zone. This spin-valley coupling, particularly pronounced in tungsten dichalcogenides, can benefit potential spintronics and valleytronics with the important consequences of spin-valley interplay and the suppression of spin and valley relaxations. Here we report the first optical studies of WS2 and WSe2 monolayers and multilayers. The efficiency of second harmonic generation shows a dramatic even-odd oscillation with the number of layers, consistent with the presence (absence) of inversion symmetry in even-layer (odd-layer). Photoluminescence (PL) measurements show the crossover from an indirect band gap semiconductor at mutilayers to a direct-gap one at monolayers. The PL spectra and first-principle calculations consistently reveal a spin-valley coupling of 0.4 eV which suppresses interlayer hopping and manifests as a thickness independent splitting pattern at valence band edge near K points. This giant spin-valley coupling, together with the valley dependent physical properties, may lead to rich possibilities for manipulating spin and valley degrees of freedom in these atomically thin 2D materials

Switching Mechanism in Single-Layer Molybdenum Disulfide Transistors: an Insight into Current Flow across Schottky Barriers

In this article, we study the properties of metal contacts to single-layer molybdenum disulfide (MoS2) crystals, revealing the nature of switching mechanism in MoS2 transistors. On investigating transistor behavior as contact length changes, we find that the contact resistivity for metal/MoS2 junctions is defined by contact area instead of contact width. The minimum gate dependent transfer length is ~0.63 {\mu}m in the on-state for metal (Ti) contacted single-layer MoS2. These results reveal that MoS2 transistors are Schottky barrier transistors, where the on/off states are switched by the tuning the Schottky barriers at contacts. The effective barrier heights for source and drain barriers are primarily controlled by gate and drain biases, respectively. We discuss the drain induced barrier narrowing effect for short channel devices, which may reduce the influence of large contact resistance for MoS2 Schottky barrier transistors at the channel length scaling limit.Comment: ACS Nano, ASAP (2013

Interlayer Registry Determines the Sliding Potential of Layered Metal Dichalcogenides: The case of 2H-MoS2

We provide a simple and intuitive explanation for the interlayer sliding energy landscape of metal dichalcogenides. Based on the recently introduced registry index (RI) concept, we define a purely geometrical parameter which quantifies the degree of interlayer commensurability in the layered phase of molybdenum disulphide (2HMoS2). A direct relation between the sliding energy landscape and the corresponding interlayer registry surface of 2H-MoS2 is discovered thus marking the registry index as a computationally efficient means for studying the tribology of complex nanoscale material interfaces in the wearless friction regime.Comment: 13 pages, 7 figure

Mechanical properties of freely suspended semiconducting graphene-like layers based on MoS2

We fabricate freely suspended nanosheets of molybdenum disulphide (MoS2) which are characterized by quantitative optical microscopy and high-resolution friction force microscopy. We study the elastic deformation of freely suspended nanosheets of MoS2 using an atomic force microscope. The Young's modulus and the initial pre-tension of the nanosheets are determined by performing a nanoscopic version of a bending test experiment. MoS2 sheets show high elasticity and an extremely high Young's modulus (0.30 TPa, 50% larger than steel). These results make them a potential alternative to graphene in applications requiring flexible semiconductor materials