3,745 research outputs found
Quantum Hall effect in exfoliated graphene affected by charged impurities: metrological measurements
Metrological investigations of the quantum Hall effect (QHE) completed by
transport measurements at low magnetic field are carried out in
a-few--wide Hall bars made of monolayer (ML) or bilayer (BL)
exfoliated graphene transferred on substrate. From the
charge carrier density dependence of the conductivity and from the measurement
of the quantum corrections at low magnetic field, we deduce that transport
properties in these devices are mainly governed by the Coulomb interaction of
carriers with a large concentration of charged impurities. In the QHE regime,
at high magnetic field and low temperature (), the Hall
resistance is measured by comparison with a GaAs based quantum resistance
standard using a cryogenic current comparator. In the low dissipation limit, it
is found quantized within 5 parts in (one standard deviation, ) at the expected rational fractions of the von Klitzing constant,
respectively and in the ML and BL
devices. These results constitute the most accurate QHE quantization tests to
date in monolayer and bilayer exfoliated graphene. It turns out that a main
limitation to the quantization accuracy, which is found well above the
accuracy usually achieved in GaAs, is the low value of the QHE
breakdown current being no more than . The current dependence
of the longitudinal conductivity investigated in the BL Hall bar shows that
dissipation occurs through quasi-elastic inter-Landau level scattering,
assisted by large local electric fields. We propose that charged impurities are
responsible for an enhancement of such inter-Landau level transition rate and
cause small breakdown currents.Comment: 14 pages, 9 figure
Complex microwave conductivity of PrCeCuO thin films using a cavity perturbation method
We report a study of the microwave conductivity of electron-doped
PrCeCuO superconducting thin films using a
cavity perturbation technique. The relative frequency shifts obtained for the
samples placed at a maximum electric field location in the cavity are treated
using the high conductivity limit presented recently by Peligrad
Using two resonance modes, TE (16.5 GHz) and TE
(13 GHz) of the same cavity, only one adjustable parameter is needed
to link the frequency shifts of an empty cavity to the ones of a cavity loaded
with a perfect conductor. Moreover, by studying different sample
configurations, we can relate the substrate effects on the frequency shifts to
a scaling factor. These procedures allow us to extract the temperature
dependence of the complex penetration depth and the complex microwave
conductivity of two films with different quality. Our data confirm that all the
physical properties of the superconducting state are consistent with an order
parameter with lines of nodes. Moreover, we demonstrate the high sensitivity of
these properties on the quality of the films
Heating process in the pre-Breakdown regime of the Quantum Hall Efect : a size dependent effect
Our study presents experimental measurements of the contact and longitudinal
voltage drops in Hall bars, as a function of the current amplitude. We are
interested in the heating phenomenon which takes place before the breakdown of
the quantum Hall effect, i.e. the pre-breakdown regime. Two types of samples
has been investigated, at low temperature (4.2 and 1.5K) and high magnetic
field (up to 13 T). The Hall bars have several different widths, and our
observations clearly demonstrate that the size of the sample influences the
heating phenomenon. By measuring the critical currents of both contact and
longitudinal voltages, as a function of the filling factor (around ), we
highlight the presence of a high electric field domain near the source contact,
which is observable only in samples whose width is smaller than 400 microns.Comment: 4 pages, 5 igures, 7th International Symposium of Research in High
Magnetic Fields, to be published in physica
DNA adducts in peripheral blood lymphocytes from aluminum production plant workers determined by 32P-postlabeling and enzyme-linked immunosorbent assay
32P-Postlabeling analysis and enzyme-linked immunosorbent assay (ELISA) have been used to detect DNA adducts in peripheral blood lymphocytes from primary aluminum production plant workers who were exposed occupationally to a mixture of polycyclic aromatic hydrocarbons (PAHs). Preliminary results reported here are from a comparative study being performed in two aluminum plants. The levels of aromatic DNA adducts have been determined by the 32P-postlabeling assay in samples collected on two occasions, 1 year apart. PAH-DNA adduct levels have also been determined by competitive ELISA in the second set of DNA samples. The results show the necessity of follow-up biomonitoring studies to detect possible alterations in biological effect induced by changing exposures. The comparison of the results obtained by 32P-postlabeling and ELISA may lead to a better understanding of the power and weaknesses of the two methods applied in these studies
Search for Sub-TeV Gamma Rays Coincident with BATSE Gamma Ray Bursts
Project GRAND is a 100m x 100m air shower array of proportional wire chambers
(PWCs). There are 64 stations each with eight 1.29 m^2 PWC planes arranged in
four orthogonal pairs placed vertically above one another to geometrically
measure the angles of charged secondaries. A steel plate above the bottom pair
of PWCs differentiates muons (which pass undeflected through the steel) from
non-penetrating particles. FLUKA Monte Carlo studies show that a TeV gamma ray
striking the atmosphere at normal incidence produces 0.23 muons which reach
ground level where their angles and identities are measured. Thus,
paradoxically, secondary muons are used as a signature for gamma ray primaries.
The data are examined for possible angular and time coincidences with eight
gamma ray bursts (GRBs) detected by BATSE. Seven of the GRBs were selected
because of their good acceptance by GRAND and high BATSE Fluence. The eighth
GRB was added due to its possible coincident detection by Milagrito. For each
of the eight candidate GRBs, the number of excess counts during the BATSE T90
time interval and within plus or minus five degrees of BATSE's direction was
obtained. The highest statistical significance reported in this paper (2.7
sigma) is for the event that was predicted to be the most likely to be observed
(GRB 971110).Comment: To be presented at the XXVIII International Cosmic Ray Conference,
Tsukuba, Japa
Fractured-Aquifer Hydrogeology from Geophysical Logs; The Passaic Formation, New Jersey
The Passaic Formation consists of gradational sequences of mudstone, siltstone, and sandstone, and is a principal aquifer in central New Jersey. Ground-water flow is primarily controlled by fractures interspersed throughout these sedimentary rocks and characterizing these fractures in terms of type, orientation, spatial distribution, frequency, and transmissivity is fundamental towards understanding local fluid-transport processes. To obtain this information, a comprehensive suite of geophysical logs was collected in 10 wells roughly 46 m in depth and located within a .05 km2 area in Hopewell Township, New Jersey. A seemingly complex, heterogeneous network of fractures identified with an acoustic televiewer was statistically reduced to two principal subsets corresponding to two distinct fracture types: (1) bedding-plane partings and (2) high-angle fractures. Bedding-plane partings are the most numerous and have an average strike of N84° Wand dip of 20° N. The high-angle fractures are oriented subparallel to these features, with an average strike of N79° E and dip of 71 0 S, making the two fracture types roughly orthogonal. Their intersections form linear features that also retain this approximately east-west strike. Inspection of fluid temperature and conductance logs in conjunction with flowmeter measurements obtained during pumping allows the transmissive fractures to be distinguished from the general fracture population. These results show that, within the resolution capabilities ofthe logging tools, approximately 51 (or 18 percent) of the 280 total fractures are water producing. The bedding-plane partings exhibit transmissivities that average roughly 5 m2/day and that generally diminish in magnitude and frequency with depth. The high-angle fractures have average transmissivities that are about half those of the bedding-plane partings and show no apparent dependence upon depth. The geophysical logging results allow us to infer a distinct hydrogeologic structure within this aquifer that is defined by fracture type and orientation. Fluid flow near the surface is controlled primarily by the highly transmissive, subhorizontal bedding-plane partings. As depth increases, the high-angle fractures apparently become more dominant hydrologically
Quantum Hall resistance standards from graphene grown by chemical vapor deposition on silicon carbide
Replacing GaAs by graphene to realize more practical quantum Hall resistance
standards (QHRS), accurate to within in relative value, but operating
at lower magnetic fields than 10 T, is an ongoing goal in metrology. To date,
the required accuracy has been reported, only few times, in graphene grown on
SiC by sublimation of Si, under higher magnetic fields. Here, we report on a
device made of graphene grown by chemical vapour deposition on SiC which
demonstrates such accuracies of the Hall resistance from 10 T up to 19 T at 1.4
K. This is explained by a quantum Hall effect with low dissipation, resulting
from strongly localized bulk states at the magnetic length scale, over a wide
magnetic field range. Our results show that graphene-based QHRS can replace
their GaAs counterparts by operating in as-convenient cryomagnetic conditions,
but over an extended magnetic field range. They rely on a promising hybrid and
scalable growth method and a fabrication process achieving low-electron density
devices.Comment: 12 pages, 8 figure
Role of doped layers in dephasing of 2D electrons in quantum well structures
The temperature and gate voltage dependences of the phase breaking time are
studied experimentally in GaAs/InGaAs heterostructures with single quantum
well. It is shown that appearance of states at the Fermi energy in the doped
layers leads to a significant decrease of the phase breaking time of the
carriers in quantum well and to saturation of the phase breaking time at low
temperature.Comment: 4 pages, 6 figure
Recommended from our members
Non-Verbal Short-Term Serial Memory In Autism Spectrum Disorder
In order to clarify the role of item and order memory in the serial recall of aduts with Autism Spectrum Disorder (ASD), we carried out two experiments in which adults with ASD and comparison participants matched on chronological age and verbal IQ saw sequences of seven dots appear sequentially in a 3 x 4 grid. In Experiment 1 (serial recall), they had to recall the locations and the presentation order of the dots by tapping locations on an empty grid. In Experiment 2, (order reconstruction) the studied dots were provided at test and participants had to touch them in their order of appearance at study. Experiment 1 revealed diminished item and order recall in the ASD group; Experiment 2 revealed diminished order recall only when verbal IQ was controlled. The results support the view that people with ASD have particular difficulty with serial order recall but may use their language ability to achieve better serial recall performance
- …