655 research outputs found

    Demonstration and Comparison of Operation of Photomultiplier Tubes at Liquid Argon Temperature

    Full text link
    Liquified noble gases are widely used as a target in direct Dark Matter searches. Signals from scintillation in the liquid, following energy deposition from the recoil nuclei scattered by Dark Matter particles (e.g. WIMPs), should be recorded down to very low energies by photosensors suitably designed to operate at cryogenic temperatures. Liquid Argon based detectors for Dark Matter searches currently implement photo multiplier tubes for signal read-out. In the last few years PMTs with photocathodes operating down to liquid Argon temperatures (87 K) have been specially developed with increasing Quantum Efficiency characteristics. The most recent of these, Hamamatsu Photonics Mod. R11065 with peak QE up to about 35%, has been extensively tested within the R&D program of the WArP Collaboration. During these testes the Hamamatsu PMTs showed superb performance and allowed obtaining a light yield around 7 phel/keVee in a Liquid Argon detector with a photocathodic coverage in the 12% range, sufficient for detection of events down to few keVee of energy deposition. This shows that this new type of PMT is suited for experimental applications, in particular for new direct Dark Matter searches with LAr-based experiments

    Signal and Noise Analysis in TRION -Time-Resolved Integrative Optical Fast Neutron Detector

    Full text link
    TRION is a sub-mm spatial resolution fast neutron imaging detector, which employs an integrative optical time-of-flight technique. The detector was developed for fast neutron resonance radiography, a method capable of detecting a broad range of conventional and improvised explosives. In this study we have analyzed in detail, using Monte-Carlo calculations and experimentally determined parameters, all the processes that influence the signal and noise in the TRION detector. In contrast to event-counting detectors where the signal-to-noise ratio is dependent only on the number of detected events (quantum noise), in an energy-integrating detector additional factors, such as the fluctuations in imparted energy, number of photoelectrons, system gain and other factors will contribute to the noise. The excess noise factor (over the quantum noise) due to these processes was 4.3, 2.7, 2.1, 1.9 and 1.9 for incident neutron energies of 2, 4, 7.5, 10 and 14 MeV, respectively. It is shown that, even under ideal light collection conditions, a fast neutron detection system operating in an integrative mode cannot be quantum-noise-limited due to the relatively large variance in the imparted proton energy and the resulting scintillation light distributions.Comment: 18 page

    The Cause of ‘Weak-Link’ Grain Boundary Behaviour in Polycrystalline Bi2Sr2CaCu2O8 and Bi2Sr2Ca2Cu3O10 Superconductors

    Get PDF
    The detrimental effects of grain boundaries have long been considered responsible for the low critical current densities (J_c) in high temperature superconductors. In this paper, we apply the quantitative approach used to identify the cause of the 'weak-link' grain boundary behaviour in YBa2Cu3O7 [1], to the Bi2Sr2CaCu2O8 and Bi2Sr2Ca2Cu3O10 materials that we have fabricated. Magnetic and transport measurements are used to characterise the grain and grain boundary properties of micro- and nanocrystalline material. Magnetisation measurements on all nanocrystalline materials show non-Bean-like behaviour and are consistent with surface pinning. Bi2Sr2CaCu2O8: Our microcrystalline material has very low grain boundary resistivity (ρ_GB), which is similar to that of the grains (ρ_G) such that ρ_GB≈ρ_G=2×〖10〗^(-5) Ωm (assuming a grain boundary thickness (d) of 1 nm) equivalent to an areal resistivity of ρ_G=2×〖10〗^(-14) Ωm^2. The transport J_c values are consistent with well-connected grains and very weak grain boundary pinning. However, unlike low temperature superconductors in which decreasing grain size increases the pinning along the grain boundary channels, any increase in pinning produced by making the grains in our Bi2Sr2CaCu2O8 materials nanocrystalline was completely offset by a decrease in the depairing current density of the grain boundaries caused by their high resistivity. We suggest a different approach to increasing J_c from that used in LTS materials, namely incorporating additional strong grain and grain boundary pinning sites in microcrystalline materials to produce high J_c values. Bi2Sr2Ca2Cu3O10: Both our micro- and nanocrystalline samples have ρ_GB/ρ_G of at least 10^3. This causes strong suppression of J_c across the grain boundaries, which explains the low transport J_c values we find experimentally. Our calculations show that low J_c in untextured polycrystalline Bi2Sr2Ca2Cu3O10 material is to be expected and the significant effort in the community in texturing samples and removing grain boundaries altogether is well-founded

    National identity in fragile states: insights from tertiary students in Melanesia and Timor-Leste

    Full text link
    The challenges of nation building in Melanesia and Timor-Leste have often been neglected in the regional focus on state-building challenges. High levels of ethno-linguistic diversity, combined with an array of regional, historical and cultural divisions, continue to present obstacles to the creation of a cohesive sense of national political community leading these nations to be labelled ‘fragile’. This paper presents the findings of a comparative study on the attitudes of tertiary students in Melanesia and Timor-Leste to national identity and nation building. A strong pan-Melanesian pattern of group identification was identified, common to Papua New Guinea, Solomon Islands and Vanuatu. The ongoing importance of traditional authority and custom in informing conceptions of political community and identity was evident in all four case study sites, but was in each case matched by indicators of respect for modern state authority. The survey also reveals some significant gender differences in key attitudes towards national identity, including the role of traditional authorities. Most importantly, the study reveals high degrees of national pride, and faith in democratic principles and citizenship; but conversely, low levels of pride in contemporary democratic performance and inter-group tolerance

    famoz : a software for parentage analysis using dominant, codominant and uniparentally inherited markers

    Get PDF
    Abstract FAMOZ (an acronym for father/mother) is a software useful in reconstructing parentage for dominant, codominant and uniparentally inherited markers. It is written in C and TclTk languages and is available for Unix, Linux and Windows systems at http://www.pierroton.inra.fr/ genetics/labo/Software/Famoz/index.html. Parameters and assumptions used in the calculations are few and simple. Exclusion and identity probabilities, log-likelihoods of any genetic relationship, potential father and parent or parent pair, half-and full-sibship are calculated based on real or simulated data. Error rates for genotypic mistyping can be introduced. Simulations can be done to build statistical tests for parentage assignment

    General Practitioners involvement in enteral tube feeding at home: a qualitative study

    Get PDF
    <p>Abstract</p> <p>Background</p> <p>Complex medical treatment is moving from hospital to primary care and General Practitioners (GPs) are increasingly asked to undertake new roles. There are now an estimated 19,500 patients being fed in the UK in the community on enteral tube feeding using a variety of different feeding tubes (Percutaneous endoscopic gastrostomy (PEG), Jejunostomy, or nasogastric (NG). The majority of patients are over the age of 65 years when they had artificial feeding initiated and mainly because of dysphagia. The aim of this study was to explore GPs knowledge, attitudes and skills relating to enteral feeding in the community.</p> <p>Methods</p> <p>Semi-structured one-to-one interviews with a convenience sample of GPs in Northern Ireland.</p> <p>Results</p> <p>Twenty-three GPs in three health boards in Northern Ireland participated in the study. Most found dealing with enteral feeding to be a predominantly negative experience. They had little involvement in patient selection for the procedure and poor or no discharge information. GPs felt inadequately trained, there was poor communication between primary and secondary care and little support. There was anger and frustration among GPs about lack of resources (funding and training), and the perception that primary care was used as a dumping ground.</p> <p>Conclusion</p> <p>Moving complex medical treatment from secondary to primary care has major implications for GPs who should be included in the patient selection process, have adequate discharge information about their patients, be adequately resourced and have appropriate support and training.</p

    A Toy Model for Testing Finite Element Methods to Simulate Extreme-Mass-Ratio Binary Systems

    Full text link
    Extreme mass ratio binary systems, binaries involving stellar mass objects orbiting massive black holes, are considered to be a primary source of gravitational radiation to be detected by the space-based interferometer LISA. The numerical modelling of these binary systems is extremely challenging because the scales involved expand over several orders of magnitude. One needs to handle large wavelength scales comparable to the size of the massive black hole and, at the same time, to resolve the scales in the vicinity of the small companion where radiation reaction effects play a crucial role. Adaptive finite element methods, in which quantitative control of errors is achieved automatically by finite element mesh adaptivity based on posteriori error estimation, are a natural choice that has great potential for achieving the high level of adaptivity required in these simulations. To demonstrate this, we present the results of simulations of a toy model, consisting of a point-like source orbiting a black hole under the action of a scalar gravitational field.Comment: 29 pages, 37 figures. RevTeX 4.0. Minor changes to match the published versio

    Single-dose liposomal amphotericin B (AmBisome®) for the treatment of Visceral Leishmaniasis in East Africa: study protocol for a randomized controlled trial

    Get PDF
    BACKGROUND: AmBisome® is an efficacious, safe anti-leishmanial treatment. There is growing interest in its use, either as a single dose or in combination treatments. In East Africa, the minimum optimal single-dosage has not been identified. METHODS/DESIGN: An open-label, 2-arm, non-inferiority, multi-centre randomised controlled trial is being conducted to determine the optimal single-dose treatment with AmBisome®.Patients in the single-dose arm will receive one infusion on day 1, at a dose depending on body weight. For the first group of patients entered to the trial, the dose will be 7.5 mg/kg, but if this dose is found to be ineffective then in subsequent patient series the dose will be escalated progressively to 10, 12.5 and 15 mg/kg. Patients in the reference arm will receive a multi-dose regimen of AmBisome® (3 mg/kg/day on days 1-5, 14 and 21: total dose 21 mg/kg). Patients will be hospitalised for approximately one month after the start of treatment and then followed up at three and six months. The primary endpoint is the status of patients six months after treatment. A secondary endpoint is assessment at day 30. Treatment success is determined as the absence of parasites on microscopy samples taken from bone marrow, lymph node or splenic aspirates. Interim analyses to assess the comparative efficacy of the single dose are planned after recruitment of 20 and 40 patients per arm. The final non-inferiority analysis will include 120 patients per arm, to determine if the single-dose efficacy 6 months after treatment is not more than 10% inferior to the multi-dose. DISCUSSION: An effective, safe single-dose treatment would reduce hospitalization and treatment costs. Results will inform the design of combination treatment studies. TRIAL REGISTRATION: ClinicalTrials.gov NCT00832208

    Choral singing therapy following stroke or Parkinsons disease: An exploration of participants experiences

    Get PDF
    © 2015 Informa UK Ltd. Purpose: People with stroke or Parkinsons disease (PD) live with reduced mood, social participation and quality of life (QOL). Communication difficulties affect 90% of people with PD (dysarthria) and over 33% of people with stroke (aphasia). These consequences are disabling in many ways. However, as singing is typically still possible, its therapeutic use is of increasing interest. This article explores the experiences of and factors influencing participation in choral singing therapy (CST) by people with stroke or PD and their significant others. Method: Participants (eight people with stroke, six with PD) were recruited from a community music therapy choir running CST. Significant others (seven for stroke, two for PD) were also recruited. Supported communication methods were used as needed to undertake semi-structured interviews (total N = 23). Results: Thematic analysis indicated participants had many unmet needs associated with their condition, which motivated them to explore self-management options. CST participation was described as an enjoyable social activity, and participation was perceived as improving mood, language, breathing and voice. Conclusions: Choral singing was perceived by people with stroke and PD to help them self-manage some of the consequences of their condition, including social isolation, low mood and communication difficulties.Implications for RehabilitationChoral singing therapy (CST) is sought out by people with stroke and PD to help self-manage symptoms of their condition.Participation is perceived as an enjoyable activity which improves mood, voice and language symptoms.CST may enable access to specialist music therapy and speech language therapy protocols within community frameworks

    Alexithymia, but not Autism Spectrum Disorder, may be Related to the Production of Emotional Facial Expressions

    Get PDF
    Background A prominent diagnostic criterion of autism spectrum disorder (ASD) relates to the abnormal or diminished use of facial expressions. Yet little is known about the mechanisms that contribute to this feature of ASD. Methods We showed children with and without ASD emotionally charged video clips in order to parse out individual differences in spontaneous production of facial expressions using automated facial expression analysis software. Results Using hierarchical multiple regression, we sought to determine whether alexithymia (characterized by difficulties interpreting one’s own feeling states) contributes to diminished facial expression production. Across groups, alexithymic traits—but not ASD traits, IQ, or sex—were associated with quantity of facial expression production. Conclusions These results accord with a growing body of research suggesting that many emotion processing abnormalities observed in ASD may be explained by co-occurring alexithymia. Developmental and clinical considerations are discussed, and it is argued that alexithymia is an important but too often ignored trait associated with ASD that may have implications for subtyping individuals on the autism spectrum
    corecore