C–O–H–S fluids and granitic magma : how S partitions and modifies CO2 concentrations of fluid-saturated felsic melt at 200 MPa

Author Posting. © The Author(s), 2011. This is the author's version of the work. It is posted here by permission of Springer for personal use, not for redistribution. The definitive version was published in Contributions to Mineralogy and Petrology 162 (2011): 849-865, doi:10.1007/s00410-011-0628-1.Hydrothermal volatile-solubility and partitioning experiments were conducted with fluid-saturated haplogranitic melt, H2O, CO2, and S in an internally heated pressure vessel at 900°C and 200 MPa; three additional experiments were conducted with iron-bearing melt. The run-product glasses were analyzed by electron microprobe, FTIR, and SIMS; and they contain ≤ 0.12 wt% S, ≤ 0.097 wt.% CO2, and ≤ 6.4 wt.% H2O. Apparent values of log ƒO2 for the experiments at run conditions were computed from the [(S6+)/(S6++S2-)] ratio of the glasses, and they range from NNO-0.4 to NNO+1.4. The C-O-H-S fluid compositions at run conditions were computed by mass balance, and they contained 22-99 mol% H2O, 0-78 mol% CO2, 0-12 mol% S, and < 3 wt% alkalis. Eight S-free experiments were conducted to determine the H2O and CO2 concentrations of melt and fluid compositions and to compare them with prior experimental results for C-O-H fluid-saturated rhyolite melt, and the agreement is excellent. Sulfur partitions very strongly in favor of fluid in all experiments, and the presence of S modifies the fluid compositions, and hence, the CO2 solubilities in coexisting felsic melt. The square of the mole fraction of H2O in melt increases in a linear fashion, from 0.05-0.25, with the H2O concentration of the fluid. The mole fraction of CO2 in melt increases linearly, from 0.0003-0.0045, with the CO2 concentration of C-O-H-S fluids. Interestingly, the CO2 concentration in melts, involving relatively reduced runs (log ƒO2 ≤ NNO+0.3) that contain 2.5-7 mol% S in the fluid, decreases significantly with increasing S in the system. This response to the changing fluid composition causes the H2O and CO2 solubility curve for C-O-H-S fluid-saturated haplogranitic melts at 200 MPa to shift to values near that modeled for C-O-H fluid-saturated, S-free rhyolite melt at 150 MPa. The concentration of S in haplogranitic melt increases in a linear fashion with increasing S in C-O-H-S fluids, but these data show significant dispersion that likely reflects the strong influence of ƒO2 on S speciation in melt and fluid. Importantly, the partitioning of S between fluid and melt does not vary with the (H2O/H2O+CO2) ratio of the fluid. The fluid-melt partition coefficients for H2O, CO2, and S and the atomic (C/S) ratios of the run-product fluids are virtually identical to thermodynamic constraints on volatile partitioning and the H, S, and C contents of pre-eruptive magmatic fluids and volcanic gases for subduction-related magmatic systems thus confirming our experiments are relevant to natural eruptive systems.This research was supported in part by National Science Foundation awards EAR 0308866 and EAR-0836741 to J.D.W

Amphibole and apatite insights into the evolution and mass balance of Cl and S in magmas associated with porphyry copper deposits

Chlorine and sulfur are of paramount importance for supporting the transport and deposition of ore metals at magmatic–hydrothermal systems such as the Coroccohuayco Fe–Cu–Au porphyry–skarn deposit, Peru. Here, we used recent partitioning models to determine the Cl and S concentration of the melts from the Coroccohuayco magmatic suite using apatite and amphibole chemical analyses. The pre-mineralization gabbrodiorite complex hosts S-poor apatite, while the syn- and post-ore dacitic porphyries host S-rich apatite. Our apatite data on the Coroccohuayco magmatic suite are consistent with an increasing oxygen fugacity (from the gabbrodiorite complex to the porphyries) causing the dominant sulfur species to shift from S2− to S6+ at upper crustal pressure where the magmas were emplaced. We suggest that this change in sulfur speciation could have favored S degassing, rather than its sequestration in magmatic sulfides. Using available partitioning models for apatite from the porphyries, pre-degassing S melt concentration was 20–200 ppm. Estimates of absolute magmatic Cl concentrations using amphibole and apatite gave highly contrasting results. Cl melt concentrations obtained from apatite (0.60 wt% for the gabbrodiorite complex; 0.2–0.3 wt% for the porphyries) seems much more reasonable than those obtained from amphibole which are very low (0.37 wt% for the gabbrodiorite complex; 0.10 wt% for the porphyries). In turn, relative variations of the Cl melt concentrations obtained from amphibole during magma cooling are compatible with previous petrological constraints on the Coroccohuayco magmatic suite. This confirms that the gabbrodioritic magma was initially fluid undersaturated upon emplacement, and that magmatic fluid exsolution of the gabbrodiorite and the pluton rooting the porphyry stocks and dikes were emplaced and degassed at 100–200 MPa. Finally, mass balance constraints on S, Cu and Cl were used to estimate the minimum volume of magma required to form the Coroccohuayco deposit. These three estimates are remarkably consistent among each other (ca. 100 km3) and suggest that the Cl melt concentration is at least as critical as that of Cu and S to form an economic mineralization

Solubilities of O-H-C-S-Cl volatile components in fluids and silicate melts and their control on magmatic processes.

La comunicazione riporta i risultati di esperimenti di solubilità su componenti volatili, quali O, H, C, S, Cl, in melts silicatici e relativi processi magmatici

C-O-H-S-Cl-F volatile solubilities, partitioning, and mixing properties in phonolitic-trachytic melts and aqueous-carbonic vapor ± saline liquid at 200 MPa

Hydrothermal experiments were conducted at 200MPa and 900^10188C to determine the solubilities, fluid(s)^melt partitioning, and mixing properties of H2O, CO2, S, Cl, and F in phonolitic^trachytic melts saturated in vapor, vapor plus saline liquid, or saline liquid.The bulk compositions and S, Cl, and F concentrations of the run-product glasses were determined by electron microprobe and the H2O and CO2 contents by Fourier-transform infrared spectroscopy (FTIR). A new parameterization was developed to calculate molar absorption coefficients for FTIR analysis of carbonate in glasses and applied to the run-product glasses.The concentrations of volatiles in the fluid(s) were determined by mass-balance calculations and checked with chloridometer analysis and gravimetry.The range in oxygen fugacity of these experiments is NNO to NNOþ2 (where NNO is nickel^nickel oxide buffer). The phonolitic trachytic melts dissolved up to 75wt % H2O, 094 wt % Cl, 073 wt % CO2, 075 wt % F, and 016 wt % S, and the integrated bulk fluid(s) contained up to 99 mol % H2O, 34 mol % Cl, 82 mol % CO2, 17 mol % F, and 37 mol % S.The mixing relationships of H2O, CO2, and Cl in melt versus fluid(s) are complex and strongly non-ideal at these pressure^temperature conditions, particularly with two fluid phases stable. The concentrations of H2O and CO2 in melt change with the addition of ClS to the system, and the solubility of Cl in melt varies with S. The reductions in H2O and CO2 solubility in melt exceed those resulting from simple dilution of the coexisting fluid(s) owing to addition of other volatiles.The partitioning of H2O and CO2 between fluid(s) and melt varies as a function of fluid(s) and melt composition. The experimental data are applied to phonolitic and related magmas of Mt. Somma-Vesuvius, Italy, Mt. Erebus, Antarctica, and Cripple Creek, USA, to better interpret processes of fluid(s) exsolution in eruptive and mineralizing systems. Application of the experimental results also provides constraints on eruptive and mineralizing fluid(s) compositions