59,443 research outputs found
Self-acting lift-pad geometry for circumferential seals: A noncontacting concept
A segmented circumferential seal with lift pads for hydrodynamic action was analyzed over ranges of speed and sealed pressure. Performance predictions, which predicted noncontact operation for speeds as high as 600 revolutions per second at sealed pressures to 86 N/sq cm, are discussed. Performance tests were performed on the seals and compared with the performance predictions
Self-acting geometry for noncontact seals
Performance ot two self acting seal designs for a liquid oxygen (LOX) turbopump was predicted over ranges of pressure differential and speed. Predictions were compared with test results. Performance of a radial face seal for LOX was predicted up to 448 N/cu cm and 147 m/sec. Performance of a segmented circumferential seal for helium was predicted up to 69 N/cu cm and 189 m/sec. Results confirmed predictions of noncontact operation. Qualitative agreement between test and analysis was found. The LOX face seal evidently operated with mostly liquid in the self acting geometry and mostly gas across the dam
Computation of group table alphanumeric display
Computer program, using only group elements as input data, provides machine computation of group tables used for proving theorems and algorithms of finite groups. Program is written for second generation computers
Face-seal lubrication. 2: Theory of response to angular misalignement
A theoretical analysis was made of a hypothetical seal operating mode. The hypothetical seal model provides for three degrees of primary ring motion and includes the force and moments induced by primary ring response to seat angular misalignment. This ring response causes a relative angular misalignment between the faces of the primary seal. Hydrodynamic pressure generation is produced by this misalignment. The analysis is based on the Reynolds equation in short bearing form and on a balance of forces and moments that arise from hydrodynamic and secondary seal friction effects. A closed form solution was obtained that can be solved for film thickness and relative angular misalignment
Small-q electron-phonon scattering and linear dc resistivity in high-T_c oxides
We examine the effect on the DC resistivity of small-q electron-phonon
scattering, in a system with the electronic topology of the high-T_c oxides.
Despite the fact that the scattering is dominantly forward, its contribution to
the transport can be significant due to ``ondulations'' of the bands in the
flat region and to the umpklapp process. When the extended van-Hove
singularities are sufficiently close to the acoustic branch of the
phonons contribute significantly to the transport. In that case one can obtain
linear dependent resistivity down to temperatures as low as 10 K, even if
electrons are scattered also by optical phonons of about 500 K as reported by
Raman measurements.Comment: LATEX file and 4 Postscript figure
Effect of chlorine purification on oxidation resistance of some mechanical carbons
Oxidation experiments were conducted with some experimental and commercial mechanical carbons at 650 C in dry air flowing at 28 cc/sec (STP). In general, purification of these carbon-graphites with chlorine at 2800 C improved oxidation resistance. Additional improvements in oxidation resistance were obtained from purification followed by an antioxidant (zinc phosphate) treatment. For the commercial materials, purification alone gave greater oxidation resistance than the antioxidant treatment alone. The reverse, however, was the case for the experimental materials
Wear and friction of oxidation-resistant mechanical carbon graphites at 650 C in air
Studies were conducted to determine the friction and wear properties of experimental carbon-graphites. Hemispherically tipped carbon-graphite rider specimens were tested in sliding contact with rotating Inconel X-750 disks in air. A surface speed of 1.33 m/sec, a load of 500 g, and a specimen temperature of 650 C were used. Results indicate: (1) hardness is not a major factor in determining friction and wear under the conditions of these studies. (2) Friction and wear as low as or lower than those observed for a good commercial seal material were attained with some of the experimental materials studied. (3) The inclusion of boron carbide (as an oxidation inhibitor) has a strong influence on wear rate. (4) Phosphate treatment reduces the friction coefficient when boron carbide is not present in the base material
Understanding fragility in supercooled Lennard-Jones mixtures. I. Locally preferred structures
We reveal the existence of systematic variations of isobaric fragility in
different supercooled Lennard-Jones binary mixtures by performing molecular
dynamics simulations. The connection between fragility and local structures in
the bulk is analyzed by means of a Voronoi construction. We find that clusters
of particles belonging to locally preferred structures form slow, long-lived
domains, whose spatial extension increases by decreasing temperature. As a
general rule, a more rapid growth, upon supercooling, of such domains is
associated to a more pronounced super-Arrhenius behavior, hence to a larger
fragility.Comment: 14 pages, 14 figures, minor revisions, one figure adde
Vapor-liquid surface tension of strong short-range Yukawa fluid
The thermodynamic properties of strong short-range attractive Yukawa fluids,
k=10, 9, 8, and 7, are determined by combining the slab technique with the
standard and the replica exchange Monte Carlo (REMC) methods. A good agreement
was found among the coexistence curves of these systems calculated by REMC and
those previously reported in the literature. However, REMC allows exploring the
coexistence at lower temperatures, where dynamics turns glassy. To obtain the
surface tension we employed, for both methods, a procedure that yields the
pressure tensor components for discontinuous potentials. The surface tension
results obtained by the standard MC and REMC techniques are in good agreement.Comment: 6 pages, 4 figure
- …