The half saturation removal approach and mechanism of Lead (II) removal using eco-friendly industrial fish bone meal waste biosorbent

Lead (II)-laden wastewater from lead acid battery and printed wire board industries are hazardous to human health and environment due to their toxicity and persistent characteristics. This study focuses on ecofriendly industrial Lutjanus erythropterus fish bone meal waste as biosorbent for Lead (II) removal. In this study, the effects of optimization of biosorption, isotherm, kinetic, thermodynamic, characterization of biosorbent were investigated, and the characteristics of biosorbent were compared with those of commercial resins. The half saturation removal of biosorbent amount was determined at 0.09 g in order to represent the excessive metal in real industrial wastewater condition compared to biosorbent and to minimize the consumption of chemicals and biosorption operation time. Such approach is supported by optimization results and Langmuir isotherm. Results obtained were better with Freundlich than with Langmuir isotherm, confirming the presence of heterogeneous monolayer with reversible binding sites. The biosorption mean energy inferred that chemisorption occurred in Lead (II) biosorption, and pseudo-second-order kinetics implied that chemisorption mechanism is the rate-limiting factor

Distribution and Analysis of Heavy Metals Contamination in Soil, Perlis, Malaysia

The concentration of six heavy metals such as Cu, Cr, Ni, Cd, Zn and Mn were studied in the soils around Perlis. The aim of the study is to assess the heavy metals contamination distribution due to industrialisation and agricultural activities. Soil samples were collected at depth of 0 – 15 cm in five stations around Perlis. The soil samples are subjected to soil extraction and the concentration of heavy metals was determined via ICP - OES. Overall concentrations of Cr, Cu, Zn, Ni, Cd and Mn in the soil samples ranged from 0.003 - 0.235 mg/L, 0.08 - 41.187 mg/L, 0.065 - 45.395 mg/L, 0.031 - 2.198 mg/L, 0.01 - 0.174 mg/L and 0.165 - 63.789 mg/L respectively. The concentration of heavy metals in the soil showed the following decreasing trend, Mn > Zn > Cu > Ni > Cr > Cd. From the result, the level of heavy metals in the soil near centralised Chuping industrial areas gives maximum value compared to other locations in Perlis. As a conclusion, increasing anthropogenic activities have influenced the environment, especially in increasing the pollution loading

Distribution and Analysis of Heavy Metals Contamination in Soil, Perlis, Malaysia

The concentration of six heavy metals such as Cu, Cr, Ni, Cd, Zn and Mn were studied in the soils around Perlis. The aim of the study is to assess the heavy metals contamination distribution due to industrialisation and agricultural activities. Soil samples were collected at depth of 0 – 15 cm in five stations around Perlis. The soil samples are subjected to soil extraction and the concentration of heavy metals was determined via ICP - OES. Overall concentrations of Cr, Cu, Zn, Ni, Cd and Mn in the soil samples ranged from 0.003 - 0.235 mg/L, 0.08 - 41.187 mg/L, 0.065 - 45.395 mg/L, 0.031 - 2.198 mg/L, 0.01 - 0.174 mg/L and 0.165 - 63.789 mg/L respectively. The concentration of heavy metals in the soil showed the following decreasing trend, Mn > Zn > Cu > Ni > Cr > Cd. From the result, the level of heavy metals in the soil near centralised Chuping industrial areas gives maximum value compared to other locations in Perlis. As a conclusion, increasing anthropogenic activities have influenced the environment, especially in increasing the pollution loading

Identification of Trihalomethanes (THMs) Levels in Water Supply: A Case Study in Perlis, Malaysia

In Malaysia, chlorination is used for drinking water disinfection at water treatment plants due to its cost-effectiveness and efficiency. However, the use of chlorine poses potential health risks due to the formation of disinfection by-products such as trihalomethanes (THMs). THMs are formed due to the reaction between chlorine and some natural organic matter. The objective of the study is to analyze the level of THMs in the water supply in Perlis, Malaysia. The water samples were collected from end-user tap water near the water treatment plant (WTP) located in Perlis, including Timah Tasoh WTP, Kampung Sungai Baru WTP, Arau Phase I, II, III, and IV WTPs. The THMs were analyzed using a Gas Chromatography-Mass Spectrometry (GC/MS). The results showed that the water supply from Timah Tasoh WTP generates the most THMs, whereas Kuala Sungai Baru shows the fewest amounts of total THMs. In conclusion, the presence of THMs in tap water has caused great concern since these components can cause cancer in humans. Therefore, the identification of THM formation is crucial in order to make sure that the tap water quality remains at acceptable safety levels

Identification of Trihalomethanes (THMs) Levels in Water Supply: A Case Study in Perlis, Malaysia

In Malaysia, chlorination is used for drinking water disinfection at water treatment plants due to its cost-effectiveness and efficiency. However, the use of chlorine poses potential health risks due to the formation of disinfection by-products such as trihalomethanes (THMs). THMs are formed due to the reaction between chlorine and some natural organic matter. The objective of the study is to analyze the level of THMs in the water supply in Perlis, Malaysia. The water samples were collected from end-user tap water near the water treatment plant (WTP) located in Perlis, including Timah Tasoh WTP, Kampung Sungai Baru WTP, Arau Phase I, II, III, and IV WTPs. The THMs were analyzed using a Gas Chromatography-Mass Spectrometry (GC/MS). The results showed that the water supply from Timah Tasoh WTP generates the most THMs, whereas Kuala Sungai Baru shows the fewest amounts of total THMs. In conclusion, the presence of THMs in tap water has caused great concern since these components can cause cancer in humans. Therefore, the identification of THM formation is crucial in order to make sure that the tap water quality remains at acceptable safety levels

Study of Point and Non Point Sources Pollution -A Case Study of Timah Tasoh Lake in Perlis, Malaysia

Abstract. Water resources in the catchment area come from various sources. Timah Tasoh catchment is surrounded with many types of land use activities ranging from urbanization to agriculture and quarrying. The objective of this study are to establish the number of point and non point sources pollution in the surrounding of Timah Tasoh Lake and to identify which area source pollutions are have potential to increase the pollution rate in Timah Tasoh Lake. This study involved both field and laboratory study. Field study has conducted to establish the number of point and non point sources pollution and in-situ measurement of selected variables; while the laboratory study has done to analyze the water quality parameters such as physical, chemical and biological. National Water Quality Standard (NWQS) for Malaysia and DOE Water Quality Index Classification applied in this study. Based on analysis of water quality that compliance with these standards, it can concluded that point and non point sources pollution that toward Station 1 (Tasoh River) and Station 2 (Pelarit River), both have potential to increase pollution rate in the Timah Tasoh catchment area

The acute toxicity of the metaldehyde on the climbing perch

In Asia, Climbing perch (Anabas testudineus) is commonly found in paddy fields and irrigation systems. Due to its habitat, Climbing perch is exposed to toxic pesticides used in paddy fields such as metaldehyde which is one of the most widely used molluscicide. This study aims to determine the acute toxicity Lethal Concentration50 (LC50) of metaldehyde and its effect on the behaviour and physical changes of the Climbing perch. The fish mortality responses to six different metaldehyde concentrations ranging from 180 to 330 mg/L were investigated. The 96-h LC50 values were determined and analysed using three different analysis methods which is arithmetic, logarithmic and probit graphic. The LC50 values obtained in this study were 239, 234 and 232 mg/L, respectively. After 96-h of exposure to metaldehyde, the fish showed a series of abnormal behavioural response in all cases: imbalance position, and restlessness of movement. The LC50 values show that metaldehyde is moderately toxic to the Climbing perch indicating that metaldehyde is not destructive to Climbing perch. However, long term exposure of aquatic organisms to the metaldehyde means a continuous health risk for the fish population as they are more vulnerable and it is on high risk for human to consume this toxicated fishes

The acute toxicity of the metaldehyde on the climbing perch

In Asia, Climbing perch (Anabas testudineus) is commonly found in paddy fields and irrigation systems. Due to its habitat, Climbing perch is exposed to toxic pesticides used in paddy fields such as metaldehyde which is one of the most widely used molluscicide. This study aims to determine the acute toxicity Lethal Concentration50 (LC50) of metaldehyde and its effect on the behaviour and physical changes of the Climbing perch. The fish mortality responses to six different metaldehyde concentrations ranging from 180 to 330 mg/L were investigated. The 96-h LC50 values were determined and analysed using three different analysis methods which is arithmetic, logarithmic and probit graphic. The LC50 values obtained in this study were 239, 234 and 232 mg/L, respectively. After 96-h of exposure to metaldehyde, the fish showed a series of abnormal behavioural response in all cases: imbalance position, and restlessness of movement. The LC50 values show that metaldehyde is moderately toxic to the Climbing perch indicating that metaldehyde is not destructive to Climbing perch. However, long term exposure of aquatic organisms to the metaldehyde means a continuous health risk for the fish population as they are more vulnerable and it is on high risk for human to consume this toxicated fishes