Influence of Addition of Briquettes with Dust Content into the Charge of Electric Induction Furnace on Cast Iron Quality

Foundry dust from blasting and grinding of castings contain a high amount of iron, ergo it is possible its recycling in foundry process.Dust was compacted by briquetting, two kinds of briquettes were prepared (A contained 95% magnetic part of dust from casting blasting+5% bentonite and B contained 95% mixture of dust from casting grinding and magnetic part of dust from casting blasting + 5%bentonite) and used as a part of charge into the electric induction furnace. It was found that addition of briquettes has had an influence of a chemical composition of cast iron above all on content of sulphur, phosphorus and silicon. It was not reflected in decrease in tensile strength and in microstructure. Yield of metal from briquettes was not lower then 70%

Compacting of fly dusts from cupola and electric arc furnace

Recycling and utilization of dust waste is important not only from the point of view of its usage as an alternative source of raw materials, but regarding the environmental problems also. Dust emissions arise from thermal and chemical or physical processes and mechanical actions. Two kinds of fl y dusts from cupola furnaces (hot and cold blast cupola furnace) and fl y dust from electric arc furnace were used by experiments. They were pelletized only with addition of water and briquetted with diff erent addition of water glass, bentonite and cement. Quality of briquettes was tested by compression – strength test and by break down test in green state, after drying and afterstoring (1 month)

Point-contact spectroscopy of Al- and C-doped MgB2. Superconducting energy gaps and scattering studies

The two-band/two-gap superconductivity in aluminium and carbon doped MgB$_2$ has been addressed by the point-contact spectroscopy. Two gaps are preserved in all samples with $T_c's$ down to 22 K. The evolution of two gaps as a function of the critical temperature in the doped systems suggest the dominance of the band-filling effects but for the increased Al-doping the enhanced interband scattering approaching two gaps must be considered. The magnetic field dependences of the Andreev reflection excess currents as well as zero-energy density of states determined from the experimental data are used to analyze the intraband scattering. It is shown, that while the C-doping increases the intraband scattering in the $\pi$-band more rapidly then in the $\sigma$ band, the Al-doping does not change their relative weight.Comment: 8 pages, incl. 6 figure

Kompaktiranje lebdeće prašine iz kupolne i elektrolučne peći

Recycling and utilization of dust waste is important not only from the point of view of its usage as an alternative source of raw materials, but regarding the environmental problems also. Dust emissions arise from thermal and chemical or physical processes and mechanical actions. Two kinds of fl y dusts from cupola furnaces (hot and cold blast cupola furnace) and fl y dust from electric arc furnace were used by experiments. They were pelletized only with addition of water and briquetted with different addition of water glass, bentonite and cement. Quality of briquettes was tested by compression – strength test and by break down test in green state, after drying and after storing (1 month).Recikliranje i iskorištavanje otpadne prašine važno je zbog aspekta njezine uporabe kao alternativnog izvora sirovina, ali također i s obzirom na ekološke probleme. Emisija prašina nastaje iz termičkih, kemijskih ili fi zikalnih procesa te mehaničkih aktivnosti. U eksperimentalnom dijelu korištene su dvije vrste lebdeće prašine iz kupolne peći (s predgrijanim i hladnim zrakom) te elektrolučne peći. Prašina je peletizirana samo uz dodatak vode i briketirana s različitim dodatkom vodenog stakla, bentonita i cementa. Kvaliteta briketa je određena ispitivanjem tlačne čvrstoće u sirovom stanju, nakon sušenja i nakon skladištenja (1 mjesec)

Single gap superconductivity in beta-Bi2Pd

beta-Bi2Pd compound has been proposed as another example of a multi-gap superconductor [Y. Imai et al., J. Phys. Soc. Jap. 81, 113708 (2012)]. Here, we report on measurements of several important physical quantities capable to show a presence of multiple energy gaps on our superconducting single crystals of beta-Bi2Pd with the critical temperature Tc close to 5 K. The calorimetric study via a sensitive ac technique shows a sharp anomaly at the superconducting transition, however only a single energy gap is detected. Also other characteristics inferred from calorimetric measurements as the field dependence of the Sommerfeld coefficient and the temperature and angular dependence of the upper critical magnetic field point unequivocally to standard single s-wave gap superconductivity. The Hall-probe magnetometry provides the same result from the analysis of the temperature dependence of the lower critical field. A single-gapped BCS density of states is detected by the scanning tunneling spectroscopy measurements. Then, the bulk as well as the surface sensitive probes evidence a standard conventional superconductivity in this system where the topologically protected surface states have been recently detected by ARPES [M. Sakano et al., Nature Comm. 6, 8595 (2015)] .Comment: 7 pages, 4 figures, 1 tabl

Influence of foundry dust on moulding mixtures quality

The objective of this paper was to observe the effect of the addition of the dust from the moulding plant on the quality parameters of the moulding mixtures and determine tolerable content in the moulding mixture. Three types of moulding mixtures were used in experiments: mixture prepared from new quartz sand and bentonite, mixture which is recycled in the experimental foundry and mixture came from the small foundry. To these moulding mixture was added the dust from moulding plant in the range 0 – 10%. Influence of dust addition on the compression strength, splitting strength and permeability was observed in all three kinds of mixtures

Utilizing of the metallurgical slag for production of cementless concrete mixtures

In process of pig iron, steel and cast iron production besides main product, also secondary products are formed, that have character of secondary raw materials and industrial wastes. The most abundant secondary product originating in the metallurgical process is furnace slag. Total amount of accured slag, also its chemical, mineralogical, physical – chemical properties and similarity with natural stones predestinate its utilisation in different fields of industry. The contribution deals with production of cementless concrete mixtures, where the main parts were formed by blast furnace granulated slag grinded and different gravel slag from blast furnace, oxygen converter and electric arc furnace. As activators of solidification different kinds of water glass were tested

Interplay between magnetism and superconductivity and appearance of a second superconducting transition in alpha-FeSe at high pressure

We synthesized tetragonal alpha-FeSe by melting a powder mixture of iron and selenium at high pressure. Subsequent annealing at normal pressure results in removing traces of hexagonal beta- FeSe, formation of a rather sharp transition to superconducting state at Tc ~ 7 K, and the appearance of a magnetic transition near Tm = 120 K. Resistivity and ac-susceptibility were measured on the annealed sample at hydrostatic pressure up to 4.5 GPa. A magnetic transition visible in ac-susceptibility shifts down under pressure and the resistive anomaly typical for a spin density wave (SDW) antiferromagnetic transition develops near the susceptibility anomaly. Tc determined by the appearance of a diamagnetic response in susceptibility, increases linearly under pressure at a rate dTc/dP = 3.5 K/GPa. Below 1.5 GPa, the resistive superconducting transition is sharp; the width of transition does not change with pressure; and, Tc determined by a peak in drho/dT increases at a rate ~ 3.5 K/GPa. At higher pressure, a giant broadening of the resistive transition develops. This effect cannot be explained by possible pressure gradients in the sample and is inherent to alpha-FeSe. The dependences drho(T)/dT show a signature for a second peak above 3 GPa which is indicative of the appearance of another superconducting state in alpha-FeSe at high pressure. We argue that this second superconducting phase coexists with SDW antiferromagnetism in a partial volume fraction and originates from pairing of charge carriers from other sheets of the Fermi surface