16 research outputs found
Determination of Thermal-Diffusivity Dependence on Temperature of YAG Single Crystals with Different Concentrations of Yb3+ and V3+ Doping Ions
Thermal Wave Measurements with a Mirage Detection for Investigation of Thermal Diffusivity of GdCa4O(BO3)3 Single Crystals
Single crystals of GdCa4O(BO3)3 were examined to determine their thermal properties. Samples were grown by the Czochralski pulling technique. There were three types of samples: a pure crystal, the crystal doped
with neodymium (4 at.% of Nd), and the third one doped with ytterbium (7 at.% of Yb). All samples were rectangular prisms with edges parallel to the axes of the optical indicatrix X, Y , Z (principal axes). The thermal
diffusivity was determined by means of the thermal wave method with the optical detection of the temperature disturbance based on a mirage effect. Experimental results showed anisotropy of the thermal diffusivity. The thermal diffusivity along Y direction has the highest value while values obtained in X and Z axes are much lower. Dopants cause decrease in the thermal diffusivity for all investigated directions
Thermal diffusivity, effusivity and conductivity of CdMnTe mixed crystals
Cd1-xMnxTe mixed crystals belong to a class of materials called ââsemimagnetic semiconductorââ or diluted magnetic semiconductor (DMS) with addition of magnetic ions like Mn2+ implemented into crystal structure. The crystals under investigation were grown from the melt by the high pressure high temperature modified Bridgman method in the range of composition 0 < x < 0.7. Thermal properties of these compounds have been investigated by means of photopyroelectric (PPE) calorimetry in both, back and front detection configuration. The values of the thermal diffusivity and effusivity were derived from experimental data. Thermal conductivity of the specimens was calculated from the simple theoretical dependencies between thermal parameters. The influence of Mn concentration on thermal properties of Cd1-xMnxTe crystals have been presented and discussed
Investigation of thermal properties of SiC using photothermal method
A photothermal measurements were carried out for a few samples of
silicon carbide (SiC). Thickness of the SiC plates was about 1âmm.
Samples were highly inhomogeneous and differed in crystal structure.
Experimental setup was typical for such investigation. The
photothermal signal was measured using mirage detection. Experiment
was performed for two configurations: probing beam was running over
and under the sample surface. Analysis of experimental data was done
according to one dimensional model of thermal wave propagation in
multilayer system. Thermal diffusivities and optical absorption
coefficients of the samples were determined based on multiparameter
fitting procedure
New approach to data analysis in modified à ngström's method
The conditions required for the accurate measurement of
the thermal diffusivity of solids by the modified Ă
ngström's method
are studied. Authors know that this method is suitable for determination of
the thermal diffusivity of thick samples with low thermal diffusivity and it
is difficult to determine thermal diffusivity of relatively thin samples of
good thermal conductors. Up till now thermal properties of the transitional
layers â layers between the thermocouple and the sample - were not taken
into account in data analysis. It is shown that thermal resistances of the
intermediate layers and noises should be taken into account in analysis of
measured signals. Based on that new methodology for analysis of experimental
data is proposed
Correlation between the thermal diffusivity and the velocity of ultrasound in YVO
Four single crystals of YVO4 were examined to
determine their thermal and elastic properties. The thermal diffusivity was
investigated by photothermal method using the mirage effect. The velocity of
ultrasound in crystals was measured using the pulse echo method. Two of
investigated samples were doped with neodymium (1 at.% and 2 at.% of
Nd), one with calcium and thulium (0.4 at.% of Ca and 5 at.% of Tm),
and one was pure crystal. Experimental results showed anisotropy of the
thermal diffusivity and the velocity of ultrasound. The thermal diffusivity
as well as the sound velocity is lower in (001) crystallographic plane than
in [001] direction (c-axis). Both quantities decrease with growing
concentration of dopants for all crystallographic direction, but the
influence of dopants is more distinct in the case of the thermal
diffusivity. This fact allows to draw the conclusion that impurity atoms
create scattering centres in crystal structure which result in shortening of
phonon mean free paths and lowering of the thermal conductivity
Determination of the thermal diffusivity of pure and doped yttrium orthovanadate by à ngström's method
Thermal diffusivities of pure YVO4 single crystal
and single crystals doped with Nd, Tm and Ca ions are measured using a
modified Ă
ngström's method. Measurements were carried out for main
crystallographic directions ([100], [010] and [001]). Obtained results show
that the thermal diffusivity in [001] direction is considerably higher than
in (001) plane. Decrease of the thermal diffusivity is observed with growing
concentration of dopants. For the heavier doped sample (5% at. of Tm +
0.4% at. of Ca) a drop of the thermal diffusivity is about 35%
Determination of the thermal diffusivity of pure and doped yttrium orthovanadate by à ngström's method
Correlation between the thermal diffusivity and the velocity of ultrasound in \mbox{\sffamily\bfseries YVO}_{\hbox{\sffamily\bfseries\fontsize{12}{12}\selectfont 4}} single crystals
Thermal Wave Measurements with a Mirage Detection for Investigation of Thermal Diffusivity of Single Crystals
Single crystals of were examined to determine their thermal properties. Samples were grown by the Czochralski pulling technique. There were three types of samples: a pure crystal, the crystal doped with neodymium (4 at.% of Nd), and the third one doped with ytterbium (7 at.% of Yb). All samples were rectangular prisms with edges parallel to the axes of the optical indicatrix X, Y, Z (principal axes). The thermal diffusivity was determined by means of the thermal wave method with the optical detection of the temperature disturbance based on a mirage effect. Experimental results showed anisotropy of the thermal diffusivity. The thermal diffusivity along Y direction has the highest value while values obtained in X and Z axes are much lower. Dopants cause decrease in the thermal diffusivity for all investigated directions