Two-stage code reference beamformer in mobile communications

This paper addresses a new architecture for blind adaptive beamforming when dealing with frequency hopping (FH) modulation in cellular mobile communications systems. The proposed code reference beamformer (CRB) takes advantage of the inherent frequency diversity to estimate beforehand the noise plus interference correlation matrix, which is employed as the first part of the framework. Then, a second stage is adaptively obtained without any a priori knowledge of either the direction of arrival or the array manifold. Using this information, the first stage is in turn readjusted and, as a result, the scheme is able to track non-stationary scenarios following the channel variations with no previous referencesPeer ReviewedPostprint (published version

Iterative turbo beamforming for OFDM based hybrid terrestrial-satellite mobile system

In the context of orthogonal frequency division multiplexing (OFDM)-based systems, pilot-based beamforming (BF) exhibits a high degree of sensitivity to the pilot sub-carriers. Increasing the number of reference pilots significantly improves BF performance as well as system performance. However, this increase comes at the cost of data throughput, which inevitably shrinks due to transmission of additional pilots. Hence an approach where reference signals available to the BF process can be increased without transmitting additional pilots can exhibit superior system performance without compromising throughput. Thus, the authors present a novel three-stage iterative turbo beamforming (ITBF) algorithm for an OFDM-based hybrid terrestrial-satellite mobile system, which utilises both pilots and data to perform interference mitigation. Data sub-carriers are utilised as virtual reference signals in the BF process. Results show that when compared to non-iterative conventional BF, the proposed ITBF exhibits bit error rate gain of up to 2.5 dB with only one iteration

Adaptive Beamforming for High Bit Rate Services in the FDD Mode of UTRA

Most time-reference beamforming algorithms suffer from severe beampattern distortion effects when applied to high bit rate services in WCDMA, causing serious performance degradation in terms of output BER, especially at high input SINR levels. These shortcomings are essentially caused by the uplink multiplexing of the traffic channel, which is seen by the base station as a powerful interfering source coming from the direction of arrival of the desired user. In this paper, a semi-blind beamforming technique is proposed as a valid solution to overcome this effect. The suggested scheme resorts to a conditional maximum likelihood approach to the underlying estimation problem and is designed to operate in an iterative fashion.Peer ReviewedPostprint (published version

Novel ring resonator-based integrated photonic beamformer for broadband phased array receive antennas - part I: design and performance analysis

A novel optical beamformer concept is introduced that can be used for seamless control of the reception angle in broadband wireless receivers employing a large phased array antenna (PAA). The core of this beamformer is an optical beamforming network (OBFN), using ring resonator-based broadband delays, and coherent optical combining. The electro-optical conversion is performed by means of single-sideband suppressed carrier modulation, employing a common laser, Mach-Zehnder modulators, and a common optical sideband filter after the OBFN. The unmodulated laser signal is then re-injected in order to perform balanced coherent optical detection, for the opto-electrical conversion. This scheme minimizes the requirements on the complexity of the OBFN, and has potential for compact realization by means of full integration on chip. The impact of the optical beamformer concept on the performance of the full receiver system is analyzed, by modeling the combination of the PAA and the beamformer as an equivalent two-port RF system. The results are illustrated by a numerical example of a PAA receiver for satellite TV reception, showing that—when properly designed—the beamformer hardly affects the sensitivity of the receiver

Performance evaluation of interference cancellation techniques using adaptive antennas

Two array-based algorithms, which jointly exploit or compensate for the spatial and temporal characteristics of the propagation channel, are proposed for intercell interference suppression in UMTS scenarios. The first one is the array extension of the Viterbi algorithm and is referred to as Vector Viterbi algorithm (VVA). The second algorithm, known as filtered training sequence multisensor receiver (FTS-MR), belongs to a class of algorithms in which a narrowband beamformer is placed prior to the MLSE detector. In order to assess performance of the proposed schemes, a set of link-level computer simulations adopting FRAMES' proposal for UMTS air-interface as well as realistic channel models for third generation communication systems is provided, Simulation results reveal gains, in terms of C/I, of 7-10 dB for the VVA with respect to the conventional VA and even higher for the FTS-MR.Peer ReviewedPostprint (published version

Pilot-aided ML schemes for joint beamforming and channel estimation in WCDMA systems

This paper proposes semi-blind channel estimation and interference cancellation schemes for the reception of pilot-aided signals in WCDMA systems. It is shown that the performance of classical training-based schemes is severely degraded due to the code-multiplexing (as opposed to time-multiplexing) of traffic and pilot signals. The time-dispersivity of the channel destroys the orthogonality between the traffic signal and the pilot, and consequently the traffic signal appears as a new interfering signal for the channel estimation/beamforming algorithm. In order to avoid this effect, we propose techniques that exploit both the presence of the training sequence and the structure of the traffic signal in a semi-blind fashion.Peer ReviewedPostprint (published version

Subspace Tracking and Least Squares Approaches to Channel Estimation in Millimeter Wave Multiuser MIMO

The problem of MIMO channel estimation at millimeter wave frequencies, both in a single-user and in a multi-user setting, is tackled in this paper. Using a subspace approach, we develop a protocol enabling the estimation of the right (resp. left) singular vectors at the transmitter (resp. receiver) side; then, we adapt the projection approximation subspace tracking with deflation and the orthogonal Oja algorithms to our framework and obtain two channel estimation algorithms. We also present an alternative algorithm based on the least squares approach. The hybrid analog/digital nature of the beamformer is also explicitly taken into account at the algorithm design stage. In order to limit the system complexity, a fixed analog beamformer is used at both sides of the communication links. The obtained numerical results, showing the accuracy in the estimation of the channel matrix dominant singular vectors, the system achievable spectral efficiency, and the system bit-error-rate, prove that the proposed algorithms are effective, and that they compare favorably, in terms of the performance-complexity trade-off, with respect to several competing alternatives.Comment: To appear on the IEEE Transactions on Communication

Spatio-Temporal processing for Optimum Uplink-Downlink WCDMA Systems

The capacity of a cellular system is limited by two different phenomena, namely multipath fading and multiple access interference (MAl). A Two Dimensional (2-D) receiver combats both of these by processing the signal both in the spatial and temporal domain. An ideal 2-D receiver would perform joint space-time processing, but at the price of high computational complexity. In this research we investigate computationally simpler technique termed as a Beamfom1er-Rake. In a Beamformer-Rake, the output of a beamfom1er is fed into a succeeding temporal processor to take advantage of both the beamformer and Rake receiver. Wireless service providers throughout the world are working to introduce the third generation (3G) and beyond (3G) cellular service that will provide higher data rates and better spectral efficiency. Wideband COMA (WCDMA) has been widely accepted as one of the air interfaces for 3G. A Beamformer-Rake receiver can be an effective solution to provide the receivers enhanced capabilities needed to achieve the required performance of a WCDMA system. We consider three different Pilot Symbol Assisted (PSA) beamforming techniques, Direct Matrix Inversion (DMI), Least-Mean Square (LMS) and Recursive Least Square (RLS) adaptive algorithms. Geometrically Based Single Bounce (GBSB) statistical Circular channel model is considered, which is more suitable for array processing, and conductive to RAKE combining. The performances of the Beam former-Rake receiver are evaluated in this channel model as a function of the number of antenna elements and RAKE fingers, in which are evaluated for the uplink WCDMA system. It is shown that, the Beamformer-Rake receiver outperforms the conventional RAKE receiver and the conventional beamformer by a significant margin. Also, we optimize and develop a mathematical formulation for the output Signal to Interference plus Noise Ratio (SINR) of a Beam former-Rake receiver. In this research, also, we develop, simulate and evaluate the SINR and Signal to Noise Ratio (Et!Nol performances of an adaptive beamforming technique in the WCDMA system for downlink. The performance is then compared with an omnidirectional antenna system. Simulation shows that the best perfom1ance can be achieved when all the mobiles with same Angle-of-Arrival (AOA) and different distance from base station are formed in one beam

Beamforming management and beam training in 5G system

Massive multiple-input-multiple-output (MIMO) antenna system with beamforming technique is an integral part of upcoming 5G new radio (NR) system. For the upcoming deployment of 5G NR system in both stand-alone (SA) and non-stand-alone (NSA) structure, beamforming plays an important role to achieve its key features and meet the estimated requirement. To be employed with massive MIMO antenna structure, beamforming will allow 5G system to serve several users at a time with better throughput and spectral usage. Beamforming will also minimize the path loss due to high susceptibility of millimetre wave and provide beamforming gain. For a wide range of benefit scheme, beamforming is currently a hot topic regarding the deployment of 5G. With the advantage of both analog and digital beamforming, hybrid beamforming structure can provide better system benchmark performance in terms of cost and flexibility. Switched beam training and adaptive beam training approaches and algorithms are developed in order to reduce training time, signalling overhead and misdetection probability. Some of the approaches and algorithm are addressed in this thesis. Beamforming management ensures the initiation and sustainability of the established link between transmitter and receiver through different processes. Beam tracking helps to keep track of the receiver devices during mobility. As beamforming is related to antenna configuration, near-field spherical wave front incident problem was ignored, and all the references and examples presented in this topic was obtained with a far-field propagation perspective. To avoid mutual coupling between antenna elements and grating lobe problems in antenna radiation pattern, each element is separated by half of the wavelength. This thesis paper aims to provide a broader view into beamforming scenario, starting from the basics of beamforming to training the beams and management aspects in the hardware part of 5G structure. Another goal is to present the necessity of beamforming in a 5G system by stating different benefits scheme such as spatial diversity, interference suppression, energy efficiency, spectral efficiency and so on. These benefits are justified by evaluating various research paper and MATLAB simulations

Interference-Mitigating Waveform Design for Next-Generation Wireless Systems

A brief historical perspective of the evolution of waveform designs employed in consecutive generations of wireless communications systems is provided, highlighting the range of often conflicting demands on the various waveform characteristics. As the culmination of recent advances in the field the underlying benefits of various Multiple Input Multiple Output (MIMO) schemes are highlighted and exemplified. As an integral part of the appropriate waveform design, cognizance is given to the particular choice of the duplexing scheme used for supporting full-duplex communications and it is demonstrated that Time Division Duplexing (TDD) is substantially outperformed by Frequency Division Duplexing (FDD), unless the TDD scheme is combined with further sophisticated scheduling, MIMOs and/or adaptive modulation/coding. It is also argued that the specific choice of the Direct-Sequence (DS) spreading codes invoked in DS-CDMA predetermines the properties of the system. It is demonstrated that a specifically designed family of spreading codes exhibits a so-called interference-free window (IFW) and hence the resultant system is capable of outperforming its standardised counterpart employing classic Orthogonal Variable Spreading Factor (OVSF) codes under realistic dispersive channel conditions, provided that the interfering multi-user and multipath components arrive within this IFW. This condition may be ensured with the aid of quasisynchronous adaptive timing advance control. However, a limitation of the system is that the number of spreading codes exhibiting a certain IFW is limited, although this problem may be mitigated with the aid of novel code design principles, employing a combination of several spreading sequences in the time-frequency and spatial-domain. The paper is concluded by quantifying the achievable user load of a UTRA-like TDD Code Division Multiple Access (CDMA) system employing Loosely Synchronized (LS) spreading codes exhibiting an IFW in comparison to that of its counterpart using OVSF codes. Both system's performance is enhanced using beamforming MIMOs