The TerraSAR-X Mission and System Design

This paper describes the TerraSAR-X Mission Concept within the context of a public-private-partnership (PPP) agreement between the German Aerospace Center DLR and industry. It briefly describes the PPP-concept as well as the overall project organization. The paper then gives an overview of the satellite design, the corresponding Ground Segment as well as the main mission parameters. After a short introduction to the scientific and commercial exploitation scheme, the paper finally focuses on the mission accomplishments achieved so far during the ongoing mission

Scalloping Correction in TOPS Imaging Mode SAR Data

This paper presents an investigation on scalloping correction in the TOPS imaging mode for SAR systems with electronically steered phased array antennas. A theoretical simulation of the scalloping is performed and two correction methods are introduced. The simulation is based on a general cardinal sine (sinc) antenna model as well as on the TerraSAR-X antenna model. Real TerraSAR-X data acquired over rainforest are used for demonstration and verification of the scalloping simulation and correction. Furthermore a calibration approach taking into account the special TOPS imaging mode properties is introduced

Flight Dynamics Operations of the TanDEM-X Formation

Since end of 2010 the German TerraSAR-X and TanDEM-X satellites are routinely operated as the first configurable single-pass Synthetic Aperture Radar interferometer in space. The two 1340 kg satellites fly in a 514 km sun-synchronous orbit. In order to collect sufficient measurements for the generation of a global digital elevation model and to demonstrate new interferometric SAR techniques and applications, more than three years of formation flying are foreseen with flexible baselines ranging from 150 m to few kilometers. As a prerequisite for the close formation flight an extensive flight dynamics system was established at DLR/GSOC, which comprises of GPS-based absolute and relative navigation and impulsive orbit and formation control. Daily formation maintenance maneuvers are performed by TanDEM-X to counterbalance natural and artificial disturbances. The paper elaborates on the routine flight dynamics operations and its interactions with mission planning and ground-station network. The navigation and formation control concepts and the achieved control accuracy are briefly outlined. Furthermore, the paper addresses non-routine operations experienced during formation acquisition, frequent formation reconfiguration, formation maintenance problems and space debris collision avoidance, which is even more challenging than for single-satellite operations. In particular two close approaches of debris are presented, which were experienced in March 2011 and April 2012. Finally, a formation break-up procedure is discussed which could be executed in case of severe onboard failures

In-depth verification of Sentinel-1 and TerraSAR-X geolocation accuracy using the Australian Corner Reflector Array

This article shows how the array of corner reflectors (CRs) in Queensland, Australia, together with highly accurate geodetic synthetic aperture radar (SAR) techniques—also called imaging geodesy—can be used to measure the absolute and relative geometric fidelity of SAR missions. We describe, in detail, the end-to-end methodology and apply it to TerraSAR-X Stripmap (SM) and ScanSAR (SC) data and to Sentinel-1interferometric wide swath (IW) data. Geometric distortions within images that are caused by commonly used SAR processor approximations are explained, and we show how to correct them during postprocessing. Our results, supported by the analysis of 140 images across the different SAR modes and using the 40 reflectors of the array, confirm our methodology and achieve the limits predicted by theory for both Sentinel-1 and TerraSAR-X. After our corrections, the Sentinel-1 residual errors are 6 cm in range and 26 cm in azimuth, including all error sources. The findings are confirmed by the mutual independent processing carried out at University of Zurich (UZH) and German Aerospace Center (DLR). This represents an improve�ment of the geolocation accuracy by approximately a factor of four in range and a factor of two in azimuth compared with the standard Sentinel-1 products. The TerraSAR-X results are even better. The achieved geolocation accuracy now approaches that of the global navigation satellite system (GNSS)-based survey of the CRs positions, which highlights the potential of the end-to-end SAR methodology for imaging geodesy

Antenna Modeller for Synthetic Aperture Radar Applications. Electromagnetic and Radiometric Considerations

The objective of the present Master Thesis is designing an optimizer of the excitation coefficients of a phased array antenna

Ocean Surface Observations Using the TanDEM-X Satellite Formation

The TanDEM-X SAR satellite formation permits improved ocean surface observations by means of bistatic along-track interferometry (ATI) when compared to single-satellite systems. The flexible imaging geometry of its two cooperating SAR sensors forms an interferometer that can achieve very high sensitivity to motions of objects on ground. This way, radar imaging of surface currents with unprecedented accuracy, high spatial resolution and wide coverage at the same time becomes possible. We demonstrate the capabilities of the sensor in the contexts of tidal current mapping, measurement of thermohaline and wind-driven ocean currents as well as detection of areas with surface films. We have developed a dedicated postprocessing system for TanDEM-X image products that allows extracting surface current information from the data. By this paper, we address bistatic data acquisition and processing aspects for sea surface imaging with TanDEM-X like interferometric baseline geometry, temporal decorrelation, and phase calibration. We present a variety of examples of data evaluation that clearly demonstrate the application potential of the methodology

A very high resolution X- and Ku-band field study of a barley crop in support of the SWINTOL Project

SAR Wave INteraction for Natural Targets Over Land (SWINTOL) is a project funded by the European Space Agency. The study’s goal is to better understand the interaction of high frequency radar (> X-band) with vegetation and soils, in order to drive the development of a high-frequency electromagnetic model to simulate SAR imagery at high resolution (< 1 m). Existing models work well at C and X band frequencies, but do not work properly at higher frequencies. Cranfield University’s role in this project was to provide the field data necessary for model validation and development. Radar imagery was taken of a barley crop over an entire growing season. The portable outdoor GB-SAR system used the tomographic profiling (TP) technique to capture polarimetric imagery of the crop. TP is a scheme that provides detailed maps of the vertical backscatter pattern through a crop canopy, along a narrow transect directly beneath the radar platform. Fully-polarimetric imagery was obtained across overlapping 6.5 GHz bandwidths over the X- and Ku-band frequency range 8-20 GHz. This gave the opportunity to see the detailed scattering behaviour within the crop at the plant component level, from emergence of the crop through to harvesting. In combination with the imagery, full bio-geophysical characterisation of the crop and soil was made on each measurement date. Surface roughness characterisation of the soil was captured using a 3D optical stereoscopic system. This work details the measurements made, and provides a comparative assessment of the results in terms of understanding the backscatter in relation to biophysical and radar parameters

A Study of Types of Sensors used in Remote Sensing

Of late, the science of Remote Sensing has been gaining a lot of interest and attention due to its wide variety of applications. Remotely sensed data can be used in various fields such as medicine, agriculture, engineering, weather forecasting, military tactics, disaster management etc. only to name a few. This article presents a study of the two categories of sensors namely optical and microwave which are used for remotely sensing the occurrence of disasters such as earthquakes, floods, landslides, avalanches, tropical cyclones and suspicious movements. The remotely sensed data acquired either through satellites or through ground based- synthetic aperture radar systems could be used to avert or mitigate a disaster or to perform a post-disaster analysis

First results from the GPS atmosphere sounding experiment TOR aboard the TerraSAR-X satellite

GPS radio occultation events observed between 24 July and 17 November 2008 by the IGOR occultation receiver aboard the TerraSAR-X satellite are processed and analyzed. The comparison of 15 327 refractivity profiles with collocated ECMWF data yield a mean bias between zero and &amp;minus;0.30 % at altitudes between 5 and 30 km. Standard deviations decrease from about 1.4 % at 5 km to about 0.6 % at 10 km altitude, however, increase significantly in the upper stratosphere. At low latitudes mean biases and standard deviations are larger, in particular in the lower troposphere. The results are consistent with 15 159 refractivity observations collected during the same time period by the BlackJack receiver aboard GRACE-A and processed by GFZ's operational processing system. The main difference between the two occultation instruments is the implementation of open-loop signal tracking in the IGOR (TerraSAR-X) receiver which improves the tropospheric penetration depth in terms of ray height by about 2 km compared to the conventional closed-loop data acquired by BlackJack (GRACE-A)