Three dimensional scattering center imaging techniques

Two methods to image scattering centers in 3-D are presented. The first method uses 2-D images generated from Inverse Synthetic Aperture Radar (ISAR) measurements taken by two vertically offset antennas. This technique is shown to provide accurate 3-D imaging capability which can be added to an existing ISAR measurement system, requiring only the addition of a second antenna. The second technique uses target impulse responses generated from wideband radar measurements from three slightly different offset antennas. This technique is shown to identify the dominant scattering centers on a target in nearly real time. The number of measurements required to image a target using this technique is very small relative to traditional imaging techniques

Decentralized approach for translational motion estimation with multistatic inverse synthetic aperture radar systems

This paper addresses the estimation of the target translational motion by using a multistatic Inverse Synthetic Aperture Radar (ISAR) system composed of an active radar sensor and multiple receiving-only devices. Particularly, a two-step decentralized technique is derived: the first step estimates specific signal parameters (i.e., Doppler frequency and Doppler rate) at the single-sensor level, while the second step exploits these estimated parameters to derive the target velocity and acceleration components. Specifically, the second step is organized in two stages: the former is for velocity estimation, while the latter is devoted to velocity estimation refinement if a constant velocity model motion can be regarded as acceptable, or to acceleration estimation if a constant velocity assumption does not apply. A proper decision criterion to select between the two motion models is also provided. A closed-form theoretical performance analysis is provided for the overall technique, which is then used to assess the achievable performance under different distributions of the radar sensors. Additionally, a comparison with a state-of-the-art centralized approach has been carried out considering computational burden and robustness. Finally, results obtained against experimental multisensory data are shown confirming the effectiveness of the proposed technique and supporting its practical application

ISAR image matching and three-dimensional scattering imaging based on extracted dominant scatterers

This paper studies inverse synthetic aperture radar (ISAR) image matching and three-dimensional (3D) scattering imaging based on extracted dominant scatterers. In the condition of a long baseline between two radars, it is easy for obvious rotation, scale, distortion, and shift to occur between two-dimensional (2D) radar images. These problems lead to the difficulty of radar-image matching, which cannot be resolved by motion compensation and cross-correlation. What is more, due to the anisotropy, existing image-matching algorithms, such as scale invariant feature transform (SIFT), do not adapt to ISAR images very well. In addition, the angle between the target rotation axis and the radar line of sight (LOS) cannot be neglected. If so, the calibration result will be smaller than the real projection size. Furthermore, this angle cannot be estimated by monostatic radar. Therefore, instead of matching image by image, this paper proposes a novel ISAR imaging matching and 3D imaging based on extracted scatterers to deal with these issues. First, taking advantage of ISAR image sparsity, radar images are converted into scattering point sets. Then, a coarse scatterer matching based on the random sampling consistency algorithm (RANSAC) is performed. The scatterer height and accurate affine transformation parameters are estimated iteratively. Based on matched scatterers, information such as the angle and 3D image can be obtained. Finally, experiments based on the electromagnetic simulation software CADFEKO have been conducted to demonstrate the effectiveness of the proposed algorithm

Two-dimensional Length Extraction of Ballistic Target from ISAR Images Using a New Scaling Method by Affine Registration

The length of ballistic target is one of the most important features for target recognition. It can be extracted from ISAR Images. Unlike from the optical image, the length extraction from ISAR image has two difficulties. The first one is that it is hard to get the actual position of scattering centres by the traditional target extraction method. The second one is that the ISAR image’s cross scale is not known because of the target’s complex rotation. Here we propose two methods to solve these problems. Firstly, we use clustering method to get scattering centers. Secondly we propose to get cross scale of the ISAR images by affine registration. Experiments verified that our approach is realisable and has good performance.Defence Science Journal, Vol. 64, No. 5, September 2014, pp.458-463, DOI:http://dx.doi.org/10.14429/dsj.64.500

Sparse representation for the ISAR image reconstruction

In this paper, a sparse representation for the data form a multi-input multi-output based inverse synthetic aperture radar (ISAR) system is derived for two dimensions. The proposed sparse representation motivates the use a of a Convex Optimization directly that recovers the image without the loss information of the image with far less samples that that is required by Nyquist–Shannon sampling theorem, which increases the efficiency and decrease the cost of calculation in radar imaging

Compressive sensing for interferometric inverse synthetic aperture radar applications

The applicability of interferometric inverse synthetic aperture radar (InISAR) techniques to images reconstructed via compressive sensing (CS)-based algorithms is investigated. Specifically, the three-dimensional (3D) reconstruction algorithm is applied after exploiting CS for data compression and image reconstruction. The InISAR signal model is derived and formalised in a CS framework. A comparison between conventional CS reconstruction and global sparsity constrained reconstruction techniques is performed for different compression rates and different signal-to-noise ratio conditions. Performances on the 2D and 3D reconstructions are evaluated. Results obtained on real data acquired during the NATO-SET 196 trial are shown

Scattering Center Extraction and Recognition Based on ESPRIT Algorithm

Inverse Synthetic Aperture Radar (ISAR) generates high quality radar images even in low visibility. And it provides important physical features for space target recognition and location. This thesis focuses on ISAR rapid imaging, scattering center information extraction, and target classification. Based on the principle of Fourier imaging, the backscattering field of radar target is obtained by physical optics (PO) algorithm, and the relation between scattering field and objective function is deduced. According to the resolution formula, the incident parameters of electromagnetic wave are set reasonably. The interpolation method is used to realize three-dimensional (3D) simulation of aircraft target, and the results are compared with direct imaging results. CLEAN algorithm extracts scattering center information effectively. But due to the limitation of resolution parameters, traditional imaging can’t meet the actual demand. Therefore, the super-resolution Estimation of Signal Parameters via Rotational Invariance Techniques (ESPRIT) algorithm is used to obtain spatial target location information. The signal subspace and noise subspace are orthogonal to each other. By combining spatial smoothing method with ESPRIT algorithm, the physical characteristics of geometric target scattering center are obtained accurately. In particular, the proposed method is validated on complex 3D aircraft targets and it proves that this method is applied to most scattering mechanisms. The distribution of scattering centers reflects the geometric information of the target. Therefore, the electromagnetic image to be recognized and ESPRIT image are matched by the domain matching method. And the classification results under different radii are obtained. In addition, because the neural network can extract rich image features, the improved ALEX network is used to classify and recognize target data processed by ESPRIT. It proves that ESPRIT algorithm can be used to expand the existing datasets and prepare for future identification of targets in real environments. Final a visual classification system is constructed to visually display the results