Resilient Wireless Sensor Networks Using Topology Control: A Review

Wireless sensor networks (WSNs) may be deployed in failure-prone environments, and WSNs nodes easily fail due to unreliable wireless connections, malicious attacks and resource-constrained features. Nevertheless, if WSNs can tolerate at most losing k − 1 nodes while the rest of nodes remain connected, the network is called k − connected. k is one of the most important indicators for WSNs’ self-healing capability. Following a WSN design flow, this paper surveys resilience issues from the topology control and multi-path routing point of view. This paper provides a discussion on transmission and failure models, which have an important impact on research results. Afterwards, this paper reviews theoretical results and representative topology control approaches to guarantee WSNs to be k − connected at three different network deployment stages: pre-deployment, post-deployment and re-deployment. Multi-path routing protocols are discussed, and many NP-complete or NP-hard problems regarding topology control are identified. The challenging open issues are discussed at the end. This paper can serve as a guideline to design resilient WSNs

An Individual Node Delay Based Efficient Power Aware Routing Protocol for Wireless Heterogeneous Sensor Networks

Miscellaneous node transmission ranges builds up Wireless Heterogeneous Sensor Networks (WHSNs). Designing an efficient, reliable and scalable routing protocol for WHSNs with intermittent asymmetric links is a challenging task. In this paper, we propose an efficient power aware routing scheme for WHSNs, which can provide loop-free, stateless, source-to-sink routing scheme without using prior information about neighbor. It uses both symmetric and asymmetric links to forward data from source to sink. The source node broadcasts location information to all its neighbor nodes. Each neighbor node calculates a delay slot based on the information obtained from the source to forward its power value to it. The node that has a minimum delay slot forwards the power earlier than the other nodes during contention phase and the delay slot is used to suppress the selection of unsuitable low-power nodes at that time. We also prove that our protocol is loop-free assuming no failures in greedy forwarding. By simulations we show that our protocol significantly outperforms the existing protocols in WHSNs

Localisation in wireless sensor networks for disaster recovery and rescuing in built environments

A thesis submitted to the University of Bedfordshire in partial fulfilment of the requirements for the degree of Doctor of PhilosophyProgress in micro-electromechanical systems (MEMS) and radio frequency (RF) technology has fostered the development of wireless sensor networks (WSNs). Different from traditional networks, WSNs are data-centric, self-configuring and self-healing. Although WSNs have been successfully applied in built environments (e.g. security and services in smart homes), their applications and benefits have not been fully explored in areas such as disaster recovery and rescuing. There are issues related to self-localisation as well as practical constraints to be taken into account. The current state-of-the art communication technologies used in disaster scenarios are challenged by various limitations (e.g. the uncertainty of RSS). Localisation in WSNs (location sensing) is a challenging problem, especially in disaster environments and there is a need for technological developments in order to cater to disaster conditions. This research seeks to design and develop novel localisation algorithms using WSNs to overcome the limitations in existing techniques. A novel probabilistic fuzzy logic based range-free localisation algorithm (PFRL) is devised to solve localisation problems for WSNs. Simulation results show that the proposed algorithm performs better than other range free localisation algorithms (namely DVhop localisation, Centroid localisation and Amorphous localisation) in terms of localisation accuracy by 15-30% with various numbers of anchors and degrees of radio propagation irregularity. In disaster scenarios, for example, if WSNs are applied to sense fire hazards in building, wireless sensor nodes will be equipped on different floors. To this end, PFRL has been extended to solve sensor localisation problems in 3D space. Computational results show that the 3D localisation algorithm provides better localisation accuracy when varying the system parameters with different communication/deployment models. PFRL is further developed by applying dynamic distance measurement updates among the moving sensors in a disaster environment. Simulation results indicate that the new method scales very well

Virtual Router Approach For Wireless Ad Hoc Networks

Wireless networks have become increasingly popular in recent years. There are two variations of mobile wireless networks: infrastructure mobile networks and infrastructureless mobile networks. The latter are also known as mobile ad hoc network (MANET). MANETs have no fixed routers. Instead, mobile nodes function as relay nodes or routers, which discover and maintain communication connections between source nodes and destination nodes for various data transmission sessions. In other words, an MANET is a self-organizing multi-hop wireless network in which all nodes within a given geographical area participate in the routing and data forwarding process. Such networks are scalable and self-healing. They support mobile applications where an infrastructure is either not available (e.g., rescue operations and underground networks) or not desirable (e.g., harsh industrial environments). In many ad hoc networks such as vehicular networks, links among nodes change constantly and rapidly due to high node speed. Maintaining communication links of an established communication path that extends between source and destination nodes is a significant challenge in mobile ad hoc networks due to movement of the mobile nodes. In particular, such communication links are often broken under a high mobility environment. Communication links can also be broken by obstacles such as buildings in a street environment that block radio signal. In a street environment, obstacles and fast moving nodes result in a very short window of communication between nodes on different streets. Although a new communication route can be established when a break in the communication path occurs, repeatedly reestablishing new routes incurs delay and substantial overhead. To address this iv limitation, we introduce the Virtual Router abstraction in this dissertation. A virtual router is a dynamically-created logical router that is associated with a particular geographical area. Its routing functionality is provided by the physical nodes (i.e., mobile devices) currently within the geographical region served by the virtual router. These physical nodes take turns in forwarding data packets for the virtual router. In this environment, data packets are transmitted from a source node to a destination node over a series of virtual routers. Since virtual routers do not move, this scheme is much less susceptible to node mobility. There can be two virtual router approaches: Static Virtual Router (SVR) and Dynamic Virtual Router (DVR). In SVR, the virtual routers are predetermined and shared by all communication sessions over time. This scheme requires each mobile node to have a map of the virtual routers, and use a global positioning system (GPS) to determine if the node is within the geographical region of a given router. DVR is different from SVR with the following distinctions: (1) virtual routers are dynamically created for each communication sessions as needed, and deprecated after their use; (2) mobile nodes do not need to have a GPS; and (3) mobile nodes do not need to know whereabouts of the virtual routers. In this dissertation, we apply Virtual Router approach to address mobility challenges in routing data. We first propose a data routing protocol that uses SVR to overcome the extreme fast topology change in a street environment. We then propose a routing protocol that does not require node locations by adapting a DVR approach. We also explore how the Virtual Router Approach can reduce the overhead associated with initial route or location requests used by many existing routing protocols to find a destination. An initial request for a destination is expensive v because all the nodes need to be reached to locate the destination. We propose two broadcast protocols; one in an open terrain environment and the other in a street environment. Both broadcast protocols apply SVR. We provide simulation results to demonstrate the effectiveness of the proposed protocols in handling high mobility. They show Virtual Router approach can achieve several times better performance than traditional routing and broadcast approach based on physical routers (i.e., relay nodes

Distance-based sensor node localization by using ultrasound, RSSI and ultra-wideband - A comparision between the techniques

Wireless sensor networks (WSNs) have become one of the most important topics in wireless communication during the last decade. In a wireless sensor system, sensors are spread over a region to build a sensor network and the sensors in a region co-operate to each other to sense, process, filter and routing. Sensor Positioning is a fundamental and crucial issue for sensor network operation and management. WSNs have so many applications in different areas such as health-care, monitoring and control, rescuing and military; they all depend on nodes being able to accurately determine their locations. This master’s thesis is focused on distance-based sensor node localization techniques; Received signal strength indicator, ultrasound and ultra-wideband. Characteristics and factors which affect these distance estimation techniques are analyzed theoretically and through simulation the quality of these techniques are compared in different scenarios. MDS, a centralized algorithm is used for solving the coordinates. It is a set of data analysis techniques that display the structure of distance-like data as a geometrical picture. Centralized and distributed implementations of MDS are also discussed. All simulations and computations in this thesis are done in Matlab. Virtual WSN is simulated on Sensorviz. Sensorviz is a simulation and visualization tool written by Andreas Savvides.fi=Opinnäytetyö kokotekstinä PDF-muodossa.|en=Thesis fulltext in PDF format.|sv=Lärdomsprov tillgängligt som fulltext i PDF-format

Distance-based sensor node localization by using ultrasound, RSSI and ultra-wideband - A comparision between the techniques

Wireless sensor networks (WSNs) have become one of the most important topics in wireless communication during the last decade. In a wireless sensor system, sensors are spread over a region to build a sensor network and the sensors in a region co-operate to each other to sense, process, filter and routing. Sensor Positioning is a fundamental and crucial issue for sensor network operation and management. WSNs have so many applications in different areas such as health-care, monitoring and control, rescuing and military; they all depend on nodes being able to accurately determine their locations. This master’s thesis is focused on distance-based sensor node localization techniques; Received signal strength indicator, ultrasound and ultra-wideband. Characteristics and factors which affect these distance estimation techniques are analyzed theoretically and through simulation the quality of these techniques are compared in different scenarios. MDS, a centralized algorithm is used for solving the coordinates. It is a set of data analysis techniques that display the structure of distance-like data as a geometrical picture. Centralized and distributed implementations of MDS are also discussed. All simulations and computations in this thesis are done in Matlab. Virtual WSN is simulated on Sensorviz. Sensorviz is a simulation and visualization tool written by Andreas Savvides.fi=Opinnäytetyö kokotekstinä PDF-muodossa.|en=Thesis fulltext in PDF format.|sv=Lärdomsprov tillgängligt som fulltext i PDF-format