Phoenix-XNS - A Miniature Real-Time Navigation System for LEO Satellites

The paper describes the development of a miniature GPS receiver with integrated real-time navigation system for orbit determination of satellites in low Earth orbit (LEO). The Phoenix-XNS receiver is based on a commercial-off-the-shelf (COTS) single-frequency GPS receiver board that has been qualified for use in a moderate space environment. Its firmware is specifically designed for space applications and accounts for the high signal dynamics in the acquisition and tracking process. The supplementary eXtended Navigation System (XNS) employs an elaborate force model and a 24-state Kalman filter to provide a smooth and continuous reduced-dynamics navigation solution even in case of restricted GPS availability. Through the use of the GRAPHIC code-carrier combination, ionospheric path delays can be fully eliminated in the filter, which overcomes the main limitation of conventional single-frequency receivers. Tests conducted in a signal simulator test bed have demonstrated a filtered navigation solution accuracy of better than 1 m (3D rms)

Robust Positioning in the Presence of Multipath and NLOS GNSS Signals

GNSS signals can be blocked and reflected by nearby objects, such as buildings, walls, and vehicles. They can also be reflected by the ground and by water. These effects are the dominant source of GNSS positioning errors in dense urban environments, though they can have an impact almost anywhere. Non- line-of-sight (NLOS) reception occurs when the direct path from the transmitter to the receiver is blocked and signals are received only via a reflected path. Multipath interference occurs, as the name suggests, when a signal is received via multiple paths. This can be via the direct path and one or more reflected paths, or it can be via multiple reflected paths. As their error characteristics are different, NLOS and multipath interference typically require different mitigation techniques, though some techniques are applicable to both. Antenna design and advanced receiver signal processing techniques can substantially reduce multipath errors. Unless an antenna array is used, NLOS reception has to be detected using the receiver's ranging and carrier-power-to-noise-density ratio (C/N0) measurements and mitigated within the positioning algorithm. Some NLOS mitigation techniques can also be used to combat severe multipath interference. Multipath interference, but not NLOS reception, can also be mitigated by comparing or combining code and carrier measurements, comparing ranging and C/N0 measurements from signals on different frequencies, and analyzing the time evolution of the ranging and C/N0 measurements

Helmert Variance Component Estimation for Multi-GNSS Relative Positioning

The Multi-constellation Global Navigation Satellite System (Multi-GNSS) has become the standard implementation of high accuracy positioning and navigation applications. It is well known that the noise of code and phase measurements depend on GNSS constellation. Then, Helmert variance component estimation (HVCE) is usually used to adjust the contributions of di¿erent GNSS constellations by determining their individual variances of unit weight. However, HVCE requires a heavy computation load. In this study, the HVCE posterior weighting was employed to carry out a kinematic relative Multi-GNSS positioning experiment with six short-baselines from day of year (DoY) 171 to 200 in 2019. As a result, the HVCE posterior weighting strategy improved Multi-GNSS positioning accuracy by 20.5%, 15.7% and 13.2% ineast-north-up(ENU) components, compared to an elevation-dependent (ED) priori weighting strategy. We observed that the weight proportion of both code and phase observations for each GNSS constellation were consistent during the entire 30 days, which indicates that the weight proportions of both code and phase observations are stable over a long period of time. It was also found that the quality of a phase observation is almost equivalent in each baseline and GNSS constellation, whereas that of a code observation is different. In order to reduce the time consumption off the HVCE method without sacrificing positioning accuracy, the stable variances of unit weights of both phase and code observations obtained over 30 days were averaged and then frozen as a priori information in the positioning experiment. The result demonstrated similar ENU improvements of 20.0%, 14.1% and 11.1% with respect to the ED method but saving 88% of the computation time of the HCVE strategy. Our study concludes with the observations that the frozen variances of unit weight (FVUW) could be applied to the positioning experiment for the next 30 days, that is, from DoY 201 to 230 in 2019, improving the positioning ENU accuracy of the ED method by 18.1%, 13.2% and 10.6%, indicating the effectiveness of the FVUW.Peer ReviewedPostprint (published version

Spacecraft applications of advanced global positioning system technology

The purpose of this study was to evaluate potential uses of Global Positioning System (GPS) in spacecraft applications in the following areas: attitude control and tracking; structural control; traffic control; and time base definition (synchronization). Each of these functions are addressed. Also addressed are the hardware related issues concerning the application of GPS technology and comparisons are provided with alternative instrumentation methods for specific functions required for an advanced low earth orbit spacecraft

A new multipath mitigation method for GNSS receivers based on antenna array

the potential of small antenna array for multipath mitigation in GNSS systems is considered in this paper. To discriminate the different incoming signals (Line of sight and multipaths), a new implementation of the well known SAGE algorithm is proposed. This allows a significant complexity reduction and it is fully compatible with conventional GNSS receivers. Theoretical study thanks to the Cramer Rao Bound derivation and tracking simulation results (in static and dynamic scenarios) show that the proposed method is a very promising approach for the multipath mitigation problem in GNSS receivers

System architecture study of an orbital GPS user terminal

The generic RF and applications processing requirements for a GPS orbital navigator are considered. A line of demarcation between dedicated analog hardware, and software/processor implementation, maximizing the latter is discussed. A modular approach to R/PA design which permits several varieties of receiver to be constructed from basic components is described. It is a basic conclusion that software signal processing of the output of the baseband correlator is the best choice of transition from analog to digital signal processing. High performance sets requiring multiple channels are developed from a generic design by replicating the RF processing segment, and modifying the applications software to provide enhanced state propagation and estimation