907 research outputs found

    Scattered Pilots and Virtual Carriers Based Frequency Offset Tracking for OFDM Systems: Algorithms, Identifiability, and Performance Analysis

    Get PDF
    In this paper, we propose a novel carrier frequency offset (CFO) tracking algorithm for orthogonal frequency division multiplexing (OFDM) systems by exploiting scattered pilot carriers and virtual carriers embedded in the existing OFDM standards. Assuming that the channel remains constant during two consecutive OFDM blocks and perfect timing, a CFO tracking algorithm is proposed using the limited number of pilot carriers in each OFDM block. Identifiability of this pilot based algorithm is fully discussed under the noise free environment, and a constellation rotation strategy is proposed to eliminate the c-ambiguity for arbitrary constellations. A weighted algorithm is then proposed by considering both scattered pilots and virtual carriers. We find that, the pilots increase the performance accuracy of the algorithm, while the virtual carriers reduce the chance of CFO outlier. Therefore, the proposed tracking algorithm is able to achieve full range CFO estimation, can be used before channel estimation, and could provide improved performance compared to existing algorithms. The asymptotic mean square error (MSE) of the proposed algorithm is derived and simulation results agree with the theoretical analysis

    FPGA implementation of an OFDM-based WLAN receiver

    Full text link
    This paper deals with the design and implementation on FPGA of a receiver for OFDM-based WLAN. The circuit is particularized for IEEE 802.11a/g standards. The system includes frame detection, time and frequency synchronization, demodulation, equalization and phase tracking. The algorithms to be implemented for each task are selected taking into account performance, hardware cost and latency. Also, a fixed point analysis is made for each algorithm. Our objective is to maintain the PER loss below 0.5 dB for a PER = 10 -2, 64-QAM and error correction. The whole system is composed of two main blocks (correlator and CORDIC) that are reused in different time intervals to perform all the necessary operations, so the required hardware resources are minimized. To verify it, the receiver is physically implemented and tested. © 2011 Elsevier B.V. All rights reserved.This work was supported by the Spanish Ministerio de Educacion y Ciencia under grant TEC2008-06787.Canet Subiela, MJ.; Valls Coquillat, J.; Almenar Terré, V.; Marín-Roig Ramón, J. (2012). FPGA implementation of an OFDM-based WLAN receiver. Microprocessors and Microsystems. 36(3):232-244. https://doi.org/10.1016/j.micpro.2011.11.004S23224436

    Channel estimation and tracking algorithms for vehicle to vehicle communications

    Get PDF
    The vehicle-to-vehicle (V2V) communications channels are highly time-varying, making reliable communication difficult. This problem is particularly challenging because the standard of the V2V communications (IEEE 802.11p standard) is based on the WLAN IEEE 802.11a standard, which was designed for indoor, relatively stationary channels; so the IEEE 802.11p standard is not customized for outdo or, highly mobile non-stationary channels. In this thesis,We propose Channel estimation and tracking algorithms that are suitable for highly-time varying channels. The proposed algorithms utilize the finite alphabet property of the transmitted symbol, time domain truncation, decision-directed as well as pilot information. The proposed algorithm s improve the overall system performance in terms of bit error rates, enabling the system to achieve higher data rates and larger packet lengths at high relative velocities. Simulation results show that the proposed algorithms achieve improved performance for all the V2V channel models with different velocities, and for different modulation schemes and packet sizes as compared to the conventional least squares and other previously proposed channel estimation techniques for V2V channels

    The impact of Rayleigh fading channel effects on the RF-DNA fingerprinting process

    Get PDF
    The Internet of Things (IoT) consists of many electronic and electromechanical devices connected to the Internet. It is estimated that the number of connected IoT devices will be between 20 and 50 billion by the year 2020. The need for mechanisms to secure IoT networks will increase dramatically as 70% of the edge devices have no encryption. Previous research has proposed RF-DNA fingerprinting to provide wireless network access security through the exploitation of PHY layer features. RF-DNA fingerprinting takes advantage of unique and distinct characteristics that unintentionally occur within a given radio’s transmit chain during waveform generation. In this work, the application of RF-DNA fingerprinting is extended by developing a Nelder-Mead-based algorithm that estimates the coefficients of an indoor Rayleigh fading channel. The performance of the Nelder-Mead estimator is compared to the Least Square estimator and is assessed with degrading signal-to-noise ratio. The Rayleigh channel coefficients set estimated by the Nelder-Mead estimator is used to remove the multipath channel effects from the radio signal. The resulting channel-compensated signal is the region where the RF-DNA fingerprints are generated and classified. For a signal-to-noise ratio greater than 21 decibels, an average percent correct classification of more than 95% was achieved in a two-reflector channel

    Development and Experimental Analysis of Wireless High Accuracy Ultra-Wideband Localization Systems for Indoor Medical Applications

    Get PDF
    This dissertation addresses several interesting and relevant problems in the field of wireless technologies applied to medical applications and specifically problems related to ultra-wideband high accuracy localization for use in the operating room. This research is cross disciplinary in nature and fundamentally builds upon microwave engineering, software engineering, systems engineering, and biomedical engineering. A good portion of this work has been published in peer reviewed microwave engineering and biomedical engineering conferences and journals. Wireless technologies in medicine are discussed with focus on ultra-wideband positioning in orthopedic surgical navigation. Characterization of the operating room as a medium for ultra-wideband signal transmission helps define system design requirements. A discussion of the first generation positioning system provides a context for understanding the overall system architecture of the second generation ultra-wideband positioning system outlined in this dissertation. A system-level simulation framework provides a method for rapid prototyping of ultra-wideband positioning systems which takes into account all facets of the system (analog, digital, channel, experimental setup). This provides a robust framework for optimizing overall system design in realistic propagation environments. A practical approach is taken to outline the development of the second generation ultra-wideband positioning system which includes an integrated tag design and real-time dynamic tracking of multiple tags. The tag and receiver designs are outlined as well as receiver-side digital signal processing, system-level design support for multi-tag tracking, and potential error sources observed in dynamic experiments including phase center error, clock jitter and drift, and geometric position dilution of precision. An experimental analysis of the multi-tag positioning system provides insight into overall system performance including the main sources of error. A five base station experiment shows the potential of redundant base stations in improving overall dynamic accuracy. Finally, the system performance in low signal-to-noise ratio and non-line-of-sight environments is analyzed by focusing on receiver-side digitally-implemented ranging algorithms including leading-edge detection and peak detection. These technologies are aimed at use in next-generation medical systems with many applications including surgical navigation, wireless telemetry, medical asset tracking, and in vivo wireless sensors

    On detection of OFDM signals for cognitive radio applications

    Get PDF
    As the requirement for wireless telecommunications services continues to grow, it has become increasingly important to ensure that the Radio Frequency (RF) spectrum is managed efficiently. As a result of the current spectrum allocation policy, it has been found that portions of RF spectrum belonging to licensed users are often severely underutilised, at particular times and geographical locations. Awareness of this problem has led to the development of Dynamic Spectrum Access (DSA) and Cognitive Radio (CR) as possible solutions. In one variation of the shared-use model for DSA, it is proposed that the inefficient use of licensed spectrum could be overcome by enabling unlicensed users to opportunistically access the spectrum when the licensed user is not transmitting. In order for an unlicensed device to make decisions, it must be aware of its own RF environment and, therefore, it has been proposed that DSA could been abled using CR. One approach that has be identified to allow the CR to gain information about its operating environment is spectrum sensing. An interesting solution that has been identified for spectrum sensing is cyclostationary detection. This property refers to the inherent periodic nature of the second order statistics of many communications signals. One of the most common modulation formats in use today is Orthogonal Frequency Division Multiplexing (OFDM), which exhibits cyclostationarity due to the addition of a Cyclic Prefix (CP). This thesis examines several statistical tests for cyclostationarity in OFDM signals that may be used for spectrum sensing in DSA and CR. In particular, focus is placed on statistical tests that rely on estimation of the Cyclic Autocorrelation Function (CAF). Based on splitting the CAF into two complex component functions, several new statistical tests are introduced and are shown to lead to an improvement in detection performance when compared to the existing algorithms. The performance of each new algorithm is assessed in Additive White Gaussian Noise (AWGN), impulsive noise and when subjected to impairments such as multipath fading and Carrier Frequency Offset (CFO). Finally, each algorithm is targeted for Field Programmable Gate Array (FPGA) implementation using a Xilinx 7 series device. In order to keep resource costs to a minimum, it is suggested that the new algorithms are implemented on the FPGA using hardware sharing, and a simple mathematical re-arrangement of certain tests statistics is proposed to circumvent a costly division operation.As the requirement for wireless telecommunications services continues to grow, it has become increasingly important to ensure that the Radio Frequency (RF) spectrum is managed efficiently. As a result of the current spectrum allocation policy, it has been found that portions of RF spectrum belonging to licensed users are often severely underutilised, at particular times and geographical locations. Awareness of this problem has led to the development of Dynamic Spectrum Access (DSA) and Cognitive Radio (CR) as possible solutions. In one variation of the shared-use model for DSA, it is proposed that the inefficient use of licensed spectrum could be overcome by enabling unlicensed users to opportunistically access the spectrum when the licensed user is not transmitting. In order for an unlicensed device to make decisions, it must be aware of its own RF environment and, therefore, it has been proposed that DSA could been abled using CR. One approach that has be identified to allow the CR to gain information about its operating environment is spectrum sensing. An interesting solution that has been identified for spectrum sensing is cyclostationary detection. This property refers to the inherent periodic nature of the second order statistics of many communications signals. One of the most common modulation formats in use today is Orthogonal Frequency Division Multiplexing (OFDM), which exhibits cyclostationarity due to the addition of a Cyclic Prefix (CP). This thesis examines several statistical tests for cyclostationarity in OFDM signals that may be used for spectrum sensing in DSA and CR. In particular, focus is placed on statistical tests that rely on estimation of the Cyclic Autocorrelation Function (CAF). Based on splitting the CAF into two complex component functions, several new statistical tests are introduced and are shown to lead to an improvement in detection performance when compared to the existing algorithms. The performance of each new algorithm is assessed in Additive White Gaussian Noise (AWGN), impulsive noise and when subjected to impairments such as multipath fading and Carrier Frequency Offset (CFO). Finally, each algorithm is targeted for Field Programmable Gate Array (FPGA) implementation using a Xilinx 7 series device. In order to keep resource costs to a minimum, it is suggested that the new algorithms are implemented on the FPGA using hardware sharing, and a simple mathematical re-arrangement of certain tests statistics is proposed to circumvent a costly division operation
    corecore