Design and performance evaluation of bitwise retransmission schemes in wireless sensor networks

The previously proposed bitwise retransmission schemes which retransmit only selected bits to accumulate their reliability are designed and evaluated. Unlike conventional automatic repeat request (ARQ) schemes, the bitwise retransmission schemes do not require a checksum for error detection. The bitwise retransmission decisions and combining can be performed either after demodulation of the received symbols or after channel decoding. The design and analysis assume error-free feedback, however, the impact of feedback errors is also considered. The bit-error rate (BER) expressions are derived and verified by computer simulations in order to optimize the parameters of the retransmission schemes. The BER performance of coded and uncoded bitwise retransmissions is compared with a hybrid ARQ (HARQ) scheme over additive white Gaussian noise (AWGN), slow fading, and fast fading channels. It is shown that bitwise retransmissions outperform block repetition coding (BRC) over AWGN channels. In addition, the selection diversity created by the bitwise retransmissions can outperform the HARQ at large signal-to-noise ratio (SNR) over fast fading channels. Finally, the practical design of a bitwise retransmission protocol for data fusion in wireless sensor networks is presented assuming Zigbee, WiFi and Bluetooth system parameters

Relay Switching Aided Turbo Coded Hybrid-ARQ for Correlated Fading Channel

Hybrid-Automatic-Repeat-reQuest (HARQ) has become an indispensable technique in reliable communications systems. However, its performance is inevitably affected by the channel’s fading correlation. In this paper, we proposed a novel relay-switching aided HARQ scheme in order to mitigate the detrimental effects of correlated fading without unduly increasing the system’s complexity and delay. Our results show that the proposed relay-switching regime operates efficiently in correlated channels, hence significantly reduces the error floor of turbo-coded HARQ. Additionally, a HARQ scheme using Segment Selective Repeat (SSR) is incorporated in the relay-switching scheme for achieving further improvements. Quantitatively, the proposed relay-switching aided turbo-coded HARQ scheme using SSR may achieve an approximately 2 dB gain, compared to the conventional amplify-and-forward aided turbo coded HARQ arrangement using Chase Combining. Index Terms - Relay switching, correlated fading channel, Hybrid-ARQ, turbo codes, chase combining, incremental redundancy, selective segment repeat

Using Channel Output Feedback to Increase Throughput in Hybrid-ARQ

Hybrid-ARQ protocols have become common in many packet transmission systems due to their incorporation in various standards. Hybrid-ARQ combines the normal automatic repeat request (ARQ) method with error correction codes to increase reliability and throughput. In this paper, we look at improving upon this performance using feedback information from the receiver, in particular, using a powerful forward error correction (FEC) code in conjunction with a proposed linear feedback code for the Rayleigh block fading channels. The new hybrid-ARQ scheme is initially developed for full received packet feedback in a point-to-point link. It is then extended to various different multiple-antenna scenarios (MISO/MIMO) with varying amounts of packet feedback information. Simulations illustrate gains in throughput.Comment: 30 page

On the Performance of the Relay-ARQ Networks

This paper investigates the performance of relay networks in the presence of hybrid automatic repeat request (ARQ) feedback and adaptive power allocation. The throughput and the outage probability of different hybrid ARQ protocols are studied for independent and spatially-correlated fading channels. The results are obtained for the cases where there is a sum power constraint on the source and the relay or when each of the source and the relay are power-limited individually. With adaptive power allocation, the results demonstrate the efficiency of relay-ARQ techniques in different conditions.Comment: Accepted for publication in IEEE Trans. Veh. Technol. 201

Green Communication via Power-optimized HARQ Protocols

Recently, efficient use of energy has become an essential research topic for green communication. This paper studies the effect of optimal power controllers on the performance of delay-sensitive communication setups utilizing hybrid automatic repeat request (HARQ). The results are obtained for repetition time diversity (RTD) and incremental redundancy (INR) HARQ protocols. In all cases, the optimal power allocation, minimizing the outage-limited average transmission power, is obtained under both continuous and bursting communication models. Also, we investigate the system throughput in different conditions. The results indicate that the power efficiency is increased substantially, if adaptive power allocation is utilized. For instance, assume Rayleigh-fading channel, a maximum of two (re)transmission rounds with rates $\{1,\frac{1}{2}\}$ nats-per-channel-use and an outage probability constraint ${10}^{-3}$. Then, compared to uniform power allocation, optimal power allocation in RTD reduces the average power by 9 and 11 dB in the bursting and continuous communication models, respectively. In INR, these values are obtained to be 8 and 9 dB, respectively.Comment: Accepted for publication on IEEE Transactions on Vehicular Technolog

Frequency Domain Hybrid-ARQ Chase Combining for Broadband MIMO CDMA Systems

In this paper, we consider high-speed wireless packet access using code division multiple access (CDMA) and multiple-input multiple-output (MIMO). Current wireless standards, such as high speed packet access (HSPA), have adopted multi-code transmission and hybrid-automatic repeat request (ARQ) as major technologies for delivering high data rates. The key technique in hybrid-ARQ, is that erroneous data packets are kept in the receiver to detect/decode retransmitted ones. This strategy is refereed to as packet combining. In CDMA MIMO-based wireless packet access, multi-code transmission suffers from severe performance degradation due to the loss of code orthogonality caused by both interchip interference (ICI) and co-antenna interference (CAI). This limitation results in large transmission delays when an ARQ mechanism is used in the link layer. In this paper, we investigate efficient minimum mean square error (MMSE) frequency domain equalization (FDE)-based iterative (turbo) packet combining for cyclic prefix (CP)-CDMA MIMO with Chase-type ARQ. We introduce two turbo packet combining schemes: i) In the first scheme, namely "chip-level turbo packet combining", MMSE FDE and packet combining are jointly performed at the chip-level. ii) In the second scheme, namely "symbol-level turbo packet combining", chip-level MMSE FDE and despreading are separately carried out for each transmission, then packet combining is performed at the level of the soft demapper. The computational complexity and memory requirements of both techniques are quite insensitive to the ARQ delay, i.e., maximum number of ARQ rounds. The throughput is evaluated for some representative antenna configurations and load factors to show the gains offered by the proposed techniques.Comment: Submitted to IEEE Transactions on Vehicular Technology (Apr 2009

Turbo Packet Combining for Broadband Space-Time BICM Hybrid-ARQ Systems with Co-Channel Interference

In this paper, efficient turbo packet combining for single carrier (SC) broadband multiple-input--multiple-output (MIMO) hybrid--automatic repeat request (ARQ) transmission with unknown co-channel interference (CCI) is studied. We propose a new frequency domain soft minimum mean square error (MMSE)-based signal level combining technique where received signals and channel frequency responses (CFR)s corresponding to all retransmissions are used to decode the data packet. We provide a recursive implementation algorithm for the introduced scheme, and show that both its computational complexity and memory requirements are quite insensitive to the ARQ delay, i.e., maximum number of ARQ rounds. Furthermore, we analyze the asymptotic performance, and show that under a sum-rank condition on the CCI MIMO ARQ channel, the proposed packet combining scheme is not interference-limited. Simulation results are provided to demonstrate the gains offered by the proposed technique.Comment: 12 pages, 7 figures, and 2 table