Transceiver design for non-regenerative MIMO relay systems with decision feedback detection

In this paper we consider the design of zero forcing (ZF) and minimum mean square error (MMSE) transceivers for non-regenerative multiple input multiple output (MIMO) relay networks. Our designs utilise linear processors at each stage of the network along with a decision feedback detection device at the receiver. Under the assumption of full channel state information (CSI) across the entire link the processors are jointly optimised to minimise the system arithmetic mean square error (MSE) whilst meeting average power constraints at both the source and the relay terminals. We compare the presented methods to linear designs available in the literature and show the advantages of the proposed transceivers through simulation results

Power Allocation in Two-Hop Amplify-and-Forward MIMO Relay Systems with QoS requirements

The problem of minimizing the total power consumption while satisfying different quality-of-service (QoS) requirements in a two-hop multiple-input multiple-output network with a single non-regenerative relay is considered. As shown by Y. Rong in [1], the optimal processing matrices for both linear and non-linear transceiver architectures lead to the diagonalization of the source-relay-destination channel so that the power minimization problem reduces to properly allocating the available power over the established links. Unfortunately, finding the solution of this problem is numerically difficult as it is not in a convex form. To overcome this difficulty, existing solutions rely on the computation of upper- and lower-bounds that are hard to obtain or require the relaxation of the QoS constraints. In this work, a novel approach is devised for both linear and non-linear transceiver architectures, which allows to closely approximate the solutions of the non-convex power allocation problems with those of convex ones easy to compute in closed-form by means of multi-step procedures of reduced complexity. Computer simulations are used to assess the performance of the proposed approach and to make comparisons with alternatives

Linear Precoders for Non-Regenerative Asymmetric Two-way Relaying in Cellular Systems

Two-way relaying (TWR) reduces the spectral-efficiency loss caused in conventional half-duplex relaying. TWR is possible when two nodes exchange data simultaneously through a relay. In cellular systems, data exchange between base station (BS) and users is usually not simultaneous e.g., a user (TUE) has uplink data to transmit during multiple access (MAC) phase, but does not have downlink data to receive during broadcast (BC) phase. This non-simultaneous data exchange will reduce TWR to spectrally-inefficient conventional half-duplex relaying. With infrastructure relays, where multiple users communicate through a relay, a new transmission protocol is proposed to recover the spectral loss. The BC phase following the MAC phase of TUE is now used by the relay to transmit downlink data to another user (RUE). RUE will not be able to cancel the back-propagating interference. A structured precoder is designed at the multi-antenna relay to cancel this interference. With multiple-input multiple-output (MIMO) nodes, the proposed precoder also triangulates the compound MAC and BC phase MIMO channels. The channel triangulation reduces the weighted sum-rate optimization to power allocation problem, which is then cast as a geometric program. Simulation results illustrate the effectiveness of the proposed protocol over conventional solutions.Comment: 30 pages, 7 figures, submitted to IEEE Transactions on Wireless Communication

Wireless Information and Energy Transfer for Two-Hop Non-Regenerative MIMO-OFDM Relay Networks

This paper investigates the simultaneous wireless information and energy transfer for the non-regenerative multipleinput multiple-output orthogonal frequency-division multiplexing (MIMO-OFDM) relaying system. By considering two practical receiver architectures, we present two protocols, time switchingbased relaying (TSR) and power splitting-based relaying (PSR). To explore the system performance limit, we formulate two optimization problems to maximize the end-to-end achievable information rate with the full channel state information (CSI) assumption. Since both problems are non-convex and have no known solution method, we firstly derive some explicit results by theoretical analysis and then design effective algorithms for them. Numerical results show that the performances of both protocols are greatly affected by the relay position. Specifically, PSR and TSR show very different behaviors to the variation of relay position. The achievable information rate of PSR monotonically decreases when the relay moves from the source towards the destination, but for TSR, the performance is relatively worse when the relay is placed in the middle of the source and the destination. This is the first time to observe such a phenomenon. In addition, it is also shown that PSR always outperforms TSR in such a MIMO-OFDM relaying system. Moreover, the effect of the number of antennas and the number of subcarriers are also discussed.Comment: 16 pages, 12 figures, to appear in IEEE Selected Areas in Communication

ZF DFE transceiver design for MIMO relay systems with direct source-destination link

In this paper we consider a non-linear transceiver design for non-regenerative multiple-input multiple-output (MIMO) relay networks where a direct link exists between the source and destination. Our system utilises linear processors at the source and relay as well as a zero-forcing (ZF) decision feedback equaliser (DFE) at the receiver. Under the assumption that full channel state information (CSI) is available the precoding and equaliser matrices are designed to minimise the arithmetic mean square error (MSE) whilst meeting transmit power constraints at the source and destination. The source, relay, and destination processors are provided in closed form solution. In the absence of the direct link our design particularises to a previous ZF DFE solution and as such can be viewed as a generalisation of an existing work. We demonstrate the effectiveness of the proposed solution through simulation and show that it outperforms existing techniques in terms of bit error ratio (BER)

Recovering Multiplexing Loss Through Successive Relaying Using Repetition Coding

In this paper, a transmission protocol is studied for a two relay wireless network in which simple repetition coding is applied at the relays. Information-theoretic achievable rates for this transmission scheme are given, and a space-time V-BLAST signalling and detection method that can approach them is developed. It is shown through the diversity multiplexing tradeoff analysis that this transmission scheme can recover the multiplexing loss of the half-duplex relay network, while retaining some diversity gain. This scheme is also compared with conventional transmission protocols that exploit only the diversity of the network at the cost of a multiplexing loss. It is shown that the new transmission protocol offers significant performance advantages over conventional protocols, especially when the interference between the two relays is sufficiently strong.Comment: To appear in the IEEE Transactions on Wireless Communication