Dynamic Security-aware Routing for Zone-based data Protection in Multi-Processor System-on-Chips

In this work, we propose a NoC which enforces the encapsulation of sensitive traffic inside the asymmetrical security zones while using minimal and non-minimal paths. The NoC routes guarantee that the sensitive traffic is communicated only through the trusted nodes which belong to the security zone. As the shape of the zones may change during operation, the sensitive traffic must be routed through low-risk paths. We test our proposal and we show that our solution can be an efficient and scalable alternative for enforce the data protection inside the MPSoC

Quarc: a high-efficiency network on-chip architecture

The novel Quarc NoC architecture, inspired by the Spidergon scheme is introduced as a NoC architecture that is highly efficient in performing collective communication operations including broadcast and multicast. The efficiency of the Quarc architecture is achieved through balancing the traffic which is the result of the modifications applied to the topology and the routing elements of the Spidergon NoC. This paper provides an ASIC implementation of both architectures using UMCpsilas 0.13 mum CMOS technology and demonstrates an analysis and comparison of the cost and performance between the Quarc and the Spidergon NoCs

Quarc: a novel network-on-chip architecture

This paper introduces the Quarc NoC, a novel NoC architecture inspired by the Spidergon NoC. The Quarc scheme significantly outperforms the Spidergon NoC through balancing the traffic which is the result of the modifications applied to the topology and the routing elements.The proposed architecture is highly efficient in performing collective communication operations including broadcast and multicast. We present the topology, routing discipline and switch architecture for the Quarc NoC and demonstrate the performance with the results obtained from discrete event simulations

NoCo: ILP-based worst-case contention estimation for mesh real-time manycores

Manycores are capable of providing the computational demands required by functionally-advanced critical applications in domains such as automotive and avionics. In manycores a network-on-chip (NoC) provides access to shared caches and memories and hence concentrates most of the contention that tasks suffer, with effects on the worst-case contention delay (WCD) of packets and tasks' WCET. While several proposals minimize the impact of individual NoC parameters on WCD, e.g. mapping and routing, there are strong dependences among these NoC parameters. Hence, finding the optimal NoC configurations requires optimizing all parameters simultaneously, which represents a multidimensional optimization problem. In this paper we propose NoCo, a novel approach that combines ILP and stochastic optimization to find NoC configurations in terms of packet routing, application mapping, and arbitration weight allocation. Our results show that NoCo improves other techniques that optimize a subset of NoC parameters.This work has been partially supported by the Spanish Ministry of Economy and Competitiveness under grant TIN2015- 65316-P and the HiPEAC Network of Excellence. It also received funding from the European Research Council (ERC) under the European Union’s Horizon 2020 research and innovation programme (agreement No. 772773). Carles Hernández is jointly supported by the MINECO and FEDER funds through grant TIN2014-60404-JIN. Jaume Abella has been partially supported by the Spanish Ministry of Economy and Competitiveness under Ramon y Cajal postdoctoral fellowship number RYC-2013-14717. Enrico Mezzetti has been partially supported by the Spanish Ministry of Economy and Competitiveness under Juan de la Cierva-Incorporaci´on postdoctoral fellowship number IJCI-2016-27396.Peer ReviewedPostprint (author's final draft

Reliability-aware and energy-efficient system level design for networks-on-chip

2015 Spring.Includes bibliographical references.With CMOS technology aggressively scaling into the ultra-deep sub-micron (UDSM) regime and application complexity growing rapidly in recent years, processors today are being driven to integrate multiple cores on a chip. Such chip multiprocessor (CMP) architectures offer unprecedented levels of computing performance for highly parallel emerging applications in the era of digital convergence. However, a major challenge facing the designers of these emerging multicore architectures is the increased likelihood of failure due to the rise in transient, permanent, and intermittent faults caused by a variety of factors that are becoming more and more prevalent with technology scaling. On-chip interconnect architectures are particularly susceptible to faults that can corrupt transmitted data or prevent it from reaching its destination. Reliability concerns in UDSM nodes have in part contributed to the shift from traditional bus-based communication fabrics to network-on-chip (NoC) architectures that provide better scalability, performance, and utilization than buses. In this thesis, to overcome potential faults in NoCs, my research began by exploring fault-tolerant routing algorithms. Under the constraint of deadlock freedom, we make use of the inherent redundancy in NoCs due to multiple paths between packet sources and sinks and propose different fault-tolerant routing schemes to achieve much better fault tolerance capabilities than possible with traditional routing schemes. The proposed schemes also use replication opportunistically to optimize the balance between energy overhead and arrival rate. As 3D integrated circuit (3D-IC) technology with wafer-to-wafer bonding has been recently proposed as a promising candidate for future CMPs, we also propose a fault-tolerant routing scheme for 3D NoCs which outperforms the existing popular routing schemes in terms of energy consumption, performance and reliability. To quantify reliability and provide different levels of intelligent protection, for the first time, we propose the network vulnerability factor (NVF) metric to characterize the vulnerability of NoC components to faults. NVF determines the probabilities that faults in NoC components manifest as errors in the final program output of the CMP system. With NVF aware partial protection for NoC components, almost 50% energy cost can be saved compared to the traditional approach of comprehensively protecting all NoC components. Lastly, we focus on the problem of fault-tolerant NoC design, that involves many NP-hard sub-problems such as core mapping, fault-tolerant routing, and fault-tolerant router configuration. We propose a novel design-time (RESYN) and a hybrid design and runtime (HEFT) synthesis framework to trade-off energy consumption and reliability in the NoC fabric at the system level for CMPs. Together, our research in fault-tolerant NoC routing, reliability modeling, and reliability aware NoC synthesis substantially enhances NoC reliability and energy-efficiency beyond what is possible with traditional approaches and state-of-the-art strategies from prior work

Adaptive Network on Chip Routing using the Turn Model

To create a viable network on chip, many technical challenges need to be solved. One of the aspects of solutions is the routing algorithm: how to route packets from one component (e.g., core CPU) to another without deadlock or livelock while avoiding congestion or faulty routers. Routing algorithms must deal with these problems while remaining simple enough to keep the hardware cost low. We have created a simple to implement, deadlock free, and livelock free routing algorithm that addresses these challenges. This routing algorithm, Weighted Non-Minimal OddEven (WeNMOE), gathers information on the state of the network (congestion/faults) from surrounding routers. The algorithm then uses this information to estimate a routing cost and routes down the path with the lowest estimated cost. A simulator was developed and used to study the performance and to compare the new routing algorithm against other state of the art routing algorithms. This simulator emulates bit reverse, complement, transpose, hotspots, and uniform random traffic patterns and measures the average latency of delivered packets. The results of the simulations showed that WeNMOE outperformed most routing algorithms. The only exception was the XY routing algorithm on uniform random and complement traffic. In these traffic patterns, the traffic load is uniformly distributed, limiting the opportunity for an improved route selection by WeNMOE