Using Short Synchronous WOM Codes to Make WOM Codes Decodable

In the framework of write-once memory (WOM) codes, it is important to distinguish between codes that can be decoded directly and those that require that the decoder knows the current generation to successfully decode the state of the memory. A widely used approach to construct WOM codes is to design first nondecodable codes that approach the boundaries of the capacity region, and then make them decodable by appending additional cells that store the current generation, at an expense of a rate loss. In this paper, we propose an alternative method to make nondecodable WOM codes decodable by appending cells that also store some additional data. The key idea is to append to the original (nondecodable) code a short synchronous WOM code and write generations of the original code and of the synchronous code simultaneously. We consider both the binary and the nonbinary case. Furthermore, we propose a construction of synchronous WOM codes, which are then used to make nondecodable codes decodable. For short-to-moderate block lengths, the proposed method significantly reduces the rate loss as compared to the standard method.Comment: To appear in IEEE Transactions on Communications. The material in this paper was presented in part at the 2012 IEEE International Symposium on Information Theory, Cambridge, MA, July 201

Coding scheme for 3D vertical flash memory

Recently introduced 3D vertical flash memory is expected to be a disruptive technology since it overcomes scaling challenges of conventional 2D planar flash memory by stacking up cells in the vertical direction. However, 3D vertical flash memory suffers from a new problem known as fast detrapping, which is a rapid charge loss problem. In this paper, we propose a scheme to compensate the effect of fast detrapping by intentional inter-cell interference (ICI). In order to properly control the intentional ICI, our scheme relies on a coding technique that incorporates the side information of fast detrapping during the encoding stage. This technique is closely connected to the well-known problem of coding in a memory with defective cells. Numerical results show that the proposed scheme can effectively address the problem of fast detrapping.Comment: 7 pages, 9 figures. accepted to ICC 2015. arXiv admin note: text overlap with arXiv:1410.177

Time-Space Constrained Codes for Phase-Change Memories

Phase-change memory (PCM) is a promising non-volatile solid-state memory technology. A PCM cell stores data by using its amorphous and crystalline states. The cell changes between these two states using high temperature. However, since the cells are sensitive to high temperature, it is important, when programming cells, to balance the heat both in time and space. In this paper, we study the time-space constraint for PCM, which was originally proposed by Jiang et al. A code is called an \emph{$(\alpha,\beta,p)$-constrained code} if for any $\alpha$ consecutive rewrites and for any segment of $\beta$ contiguous cells, the total rewrite cost of the $\beta$ cells over those $\alpha$ rewrites is at most $p$. Here, the cells are binary and the rewrite cost is defined to be the Hamming distance between the current and next memory states. First, we show a general upper bound on the achievable rate of these codes which extends the results of Jiang et al. Then, we generalize their construction for $(\alpha\geq 1, \beta=1,p=1)$-constrained codes and show another construction for $(\alpha = 1, \beta\geq 1,p\geq1)$-constrained codes. Finally, we show that these two constructions can be used to construct codes for all values of $\alpha$, $\beta$, and $p$

플래시 메모리를 위한 양방향 비대칭 오류 정정 부호 및 간섭 완화 기법

학위논문 (박사)-- 서울대학교 대학원 : 전기·컴퓨터공학부, 2014. 2. 이정우.Recently, NAND multi-level cell (MLC) flash memories are now widely used due to low cost and high capacity. However, when the number of cell levels increases, cell-to-cell interference (C2CI) which shifts threshold voltage may degrades the error rate in reading process. There are several approaches to alleviate the errors caused by the threshold voltage shift and we discuss error correcting codes and message encoding schemes. First, we propose error correcting codes that are effective for multi-level cell flash memory and non-binary WOM (write once memory) codes. In particular, we focus on bidirectional error correction codes. The errors in MLC flash memories tend to be directional and limited-magnitude. Many related works focus on asymmetric errors, but bidirectional errors also occur because of the bidirectional interference and the adjustment of the hard-decision reference voltages. The code treats both upward and downward errors when the error magnitude in each direction differs. The maximum magnitudes of the upward error and downward error are lu and ld, respectively. One of proposed codes extends the technique of the distinct sum sets to the bidirectional error correction codes. The other code is bidirectional limited magnitude error correction codes based on modulo operation and uses non-binary conventional error correction codes. These proposed codes can reduce the parity size, and have better error correction performance than the conventional error correction codes when the code rate is equal. Furthermore, error correcting schemes for non-binary WOM codes are discussed. WOM codes is a coding scheme that allows information to be written in a memory cell multiple times without erasure, and conventional error correction codes cannot be directly applied to WOM codes. The advantages of the proposed methods are that these are practical and systematic codes, and the complexity of encoding and decoding processes are low. We also introduce effective error locating limited-magnitude parity check error correction codes for the MLC flash memory error with lower complexity. Second, we introduce coding schemes to lower the generated interferences by cell to cell interference. It is known that C2CI is caused by the threshold voltage change of neighbor cells in writing operation. The amount of threshold voltage change is proportional to the magnitude. To minimize the generated interference, the average magnitude needs to be decreased. We propose two new C2CI reduction coding schemes that adjust the average magnitude to reduce C2CI. The proposed coding scheme deals with q-ary message codes, and generates fixed length codes. Message codewords are divided into several blocks, and are modified by modulo addition with proper values to minimize the average magnitude. We also propose low energy Huffman codes based on entropy coding when the frequency of symbols is not distributed uniformly. This scheme produces variable-length codes without redundancy. We modified Huffman codes to minimize average number of high bits ('1' bits). We show that proposed codes generate optimal codewords which have minimum high bits with minimum average codeword length.Chapter 1 Introduction 1 1.1 Backgrounds 1 1.2 Scope and Organization 5 Chapter 2 MLC Flash Memory Interference and Mitigation Techniques for Reliability 9 2.1 MLC flash memory and interference 9 2.2 Signal processing based interference mitigation in MLC flash memories 15 2.3 WOM codes 22 2.4 Asymmetric limited-magitude error correction codes based on distinct sum set 27 Chapter 3 Error Correction Codes for Flash Memories 29 3.1 Introduction 29 3.2 Bidirectional error correction codes for non-binary WOM codes based on distinct sum sets 30 3.2.1 Bidirectional error correction codes based on distinct sum sets 30 3.2.2 Error correction coding schemes for WOM codes based on distinct sum sets 41 3.3 Bidirectional error correction codes for WOM codes based on modulo operation 44 3.3.1 Bidirectional error correction codes based on modulo operation 44 3.3.2 Performance simulation of bidirectional error correction codes based on modulo operation 54 3.3.3 Error correction coding schemes for WOM codes based on modulo operation 58 3.4 Performance of error correction coding schemes for WOM code 61 3.5 Error locating parity check codes for errors with limited magnitude 68 3.6 Summary 77 Chapter 4 On Interference Mitigating Codes for Multi-level Flash Memories 79 4.1 Introduction 79 4.2 The modeling of generated interference in flash memory 80 4.3 Coding schemes for interference mitigation 83 4.3.1 Minimum energy coding 83 4.3.2 Module shift coding 85 4.3.3 Low energy Huffman code 89 4.4 Performance analysis of proposed coding schemes 91 4.4.1 Performance analysis of ME codes 91 4.4.2 Performance analysis of MS codes 93 4.4.3 Performance of low-energy Huffman codes 97 4.4.4 C2CI reduction performance 99 4.5 Summary 102 Chapter 5 Conclusions 105 Appendix A 109 A.1 Performance analysis of MS coding with eta=2 case in chap. 4.4.2. 109 Bibliography 113 Abstract in Korean 120Docto