Design and performance evaluation of turbo FDE receivers

Dissertação apresentada na Faculdade de Ciências e Tecnologia da Universidade Nova de Lisboa para obtenção do Grau de Mestre em Engenharia Electrotécnica e de ComputadoresIn recent years, block transmission techniques were proposed and developed for broadband wireless communication systems, which have to deal with strongly frequency-selective fading channels. Techniques like Orthogonal Frequency-Division Multiplexing (OFDM)and Single Carrier with Frequency Domain Equalization (SC-FDE) are able to provide high bit rates despite the channel adversities. In this thesis we concentrate on the study of single carrier block transmission techniques considering receiver structures suitable to scenarios with strongly time-dispersive channels. CP-assisted (Cycle Pre x) block transmission techniques are employed to cope with frequency selective channels, allowing cost-e ective implementations through FFT-based (Fast Fourier Transform) signal processing. It is investigated the impact of the number of multipath components as well as the diversity order on the asymptotic performance of SC-FDE schemes. We also propose a receiver structure able to perform a joint detection and channel estimation method, in which it is possible to combine the channel estimates, based on training sequences, with decision-directed channel estimates. A study about the impact of the correlation factor estimation in the performance of Iterative Block-Decision Feedback Equalizer (IB-DFE) receivers is also presented

Energy-efficient diversity combining for different access schemes in a multi-path dispersive channel

Dissertação para obtenção do Grau de Doutor em Engenharia Electrotécnica e ComputadoresThe forthcoming generation of mobile communications, 5G, will settle a new standard for a larger bandwidth and better Quality of Service (QoS). With the exploding growth rate of user generated data, wireless standards must cope with this growth and at the same time be energy efficient to avoid depleting the batteries of wireless devices. Besides these issues, in a broadband wireless setting QoS can be severely affected from a multipath dispersive channel and therefore be energy demanding. Cross-layered architectures are a good choice to enhance the overall performance of a wireless system. Examples of cross-layered Physical (PHY) - Medium Access Control (MAC) architectures are type-II Diversity Combining (DC) Hybrid-ARQ (H-ARQ) and Multi-user Detection (MUD) schemes. Cross-layered type-II DC H-ARQ schemes reuse failed packet transmissions to enhance data reception on posterior retransmissions; MUD schemes reuse data information from previously collided packets on posterior retransmissions to enhance data reception. For a multipath dispersive channel, a PHY layer analytical model is proposed for Single-Carrier with Frequency Domain Equalization (SC-FDE) that supports DC H-ARQ and MUD. Based on this analytical model, three PHY-MAC protocols are proposed. A crosslayered Time Division Multiple Access (TDMA) scheme that uses DC H-ARQ is modeled and its performance is studied in this document; the performance analysis shows that the scheme performs better with DC and achieves a better energy efficiency at the cost of a higher delay. A novel cross-layered prefix-assisted Direct-Sequence Code Division Multiple Access (DS-CDMA) scheme is proposed and modeled in this document, it uses principles of DC and MUD. This protocol performs better by means of additional retransmissions, achieving better energy efficiency, at the cost of higher redundancy from a code spreading gain. Finally, a novel cross-layered protocol H-ARQ Network Division Multiple Access (H-NDMA) is proposed and modeled, where the combination of DC H-ARQ and MUD is used with the intent of maximizing the system capacity with a lower delay; system results show that the proposed scheme achieves better energy efficiency and a better performance at the cost of a higher number of retransmissions. A comparison of the three cross-layered protocols is made, using the PHY analytical model, under normalized conditions using the same amount of maximum redundancy. Results show that the H-NDMA protocol, in general, obtains the best results, achieving a good performance and a good energy efficiency for a high channel load and low Signal-to-Noise Ratio (SNR). TDMA with DC H-ARQ achieves the best energy efficiency, although presenting the worst delay. Prefix-assisted DS-CDMA in the other hand shows good delay results but presents the worst throughput and energy efficiency

High performance faster-than-nyquist signaling

AbstractIn a wireless broadband context, multi-path dispersive channels can severely affectdata communication of Mobile Terminals (MTs) uplink.Single Carrier withFrequency-Domain Equalization (SC-FDE) has been proposed to deal with highlydispersive channels for the uplink of broadband wireless systems. However, currentsystems rely on older assumptions of the Nyquist theorem and assume that a systemneeds a minimum bandwidth 2Wper MT. Faster-Than-Nyquist (FTN) assumesthat it is possible to employ a bandwidth as low as 0.802 of the original Nyquistbandwidth with minimum loss - despite this, the current literature has only proposedcomplex receivers for a simple characterization of the wireless channel. Furthermore,the uplink of SC-FDE can be severely affected by a deep-fade and or poor channelconditions; to cope with such difficulties Diversity Combining (DC) Hybrid ARQ(H-ARQ) is a viable technique, since it combines the several packet copies sent bya MT to create reliable packet symbols at the receiver.In this thesis we consider the use of FTN signaling for the uplink of broadbandwireless systems employing SC-FDE based on the Iterative Block with DecisionFeedback Equalization (IB-DFE) receiver with a simple scheduled access HybridAutomatic Repeat reQuest (H-ARQ) specially designed taking into account thecharacteristics of FTN signals. This approach achieves a better performance thanNyquist signaling by taking advantage of the additional bandwidth employed of aroot-raised cosine pulse for additional diversity.Alongside a Packet Error Rate (PER) analytical model, simulation results show that this receiver presents a better performance when compared with a regular system,with higher system throughputs and a lower Energy per Useful Packet (EPUP)

Single-RF spatial modulation requires single-carrier transmission: frequency-domain turbo equalization for dispersive channels

In this paper, we propose a broadband single-carrier (SC) spatial-modulation (SM) based multiple-input multipleoutput (MIMO) architecture relying on a soft-decision (SoD) frequency-domain equalization (FDE) receiver. We demonstrate that conventional orthogonal frequency-division multiplexing (OFDM)-based broadband transmissions are not readily suitable for the single–radio frequency (RF) assisted SM-MIMO schemes, since this scheme does not exhibit any substantial performance advantage over single-antenna transmissions. To circumvent this limitation, a low-complexity soft-decision (SoD) FDE algorithm based on the minimum mean-square error (MMSE) criterion is invoked for our broadband SC-based SM-MIMO scheme, which is capable of operating in a strongly dispersive channel having a long channel impulse response (CIR) at a moderate decoding complexity. Furthermore, our SoD FDE attains a near-capacity performance with the aid of a three-stage concatenated SC-based SM architecture

Single-Frequency Network Terrestrial Broadcasting with 5GNR Numerology

L'abstract è presente nell'allegato / the abstract is in the attachmen